I need the location of the slave cylinder for a 1995 nissan maxima?

Hi Sarah:
Chances are that you still have the clutch problem that you started with.
Filling the master cylinder was good, now you have to find out why it was empty and where it went.
You'll need to make sure there is no air trapped in the lines so you'll have to bleed the slave cylinder.
If the slave cylinder seal has failed, it will have a lot of fluid visible so its fairly obvious.
Remove and replace, bleed lines, check fluid level, should be OK.

Spark plugs are located under the ignition coil for each cylinder. Each coil has to be removed to gain access to the spark plug for that cylinder.

For 1995 Nissan/Datsun Maxima 3.0L SFI DOHC 6cyl the Fuel Filter is located under hood, driver side, rear engine area, passenger side of master cylinder, mounted in fuel line.

Hope helps.

There are 2.
One is on the side of the master, and one is located on top of the slave. Some aftermarket slaves have them on the bottom.

i will assume that you are referring to the clutch master cylinder , you bleed the system at the clutch slave cylinder located on the transmission bellhousing

ON A 2000 MAX 6 CYLINDER HAS CLUTCH MASTER CYLINDER AND SLAVE CYLINDER, CHECK FLUID LEVEL AND BLEED CLUTCH SYSTEM AT SLAVE CYLINDER BLEEDER. HAVE NOT HEAR OF CABLE CLUTCH SYSTEM. ONLY HYDO.& LINKAGE. GOOD LUCK

No the master cylinder is for your brakes.And the slave cylinder only does clutch.

Drain or bleed? The bleeder nipple is on the slave cylinder. Fill master cylinder,leave the cap loose, open the bleed nipple at the slave cylinder,and let gravity do the rest. whe vo more aie bibbles come out and it drips steady. Close the bleeder, top of the master cylinder and you are done.

find the wires coming out of the blower motor and they should go right to it.i hope this helps

the clutch slave cylinder has failed or the master, it is always best to replace them as a unit. the slave is located nex to the bell housing under the car.