Question about 2003 Ford Focus

1 Answer

Ford Focus Towbar Wiring

Step by step guide to wiring Ford Focus Towbar single socket for trailer only.

Posted by on

  • Anonymous May 02, 2009

    can i have the circuit for c max 08 to conect the electrical 7 pin socket

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 39 Answers

Seek the help of an auto electrician, one wrong wire and you can toast the ecu.

Posted on Jun 30, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2012 Hyundai ix35& have fitted a towbar wiring loom.


take it to an accredited auto electrician to have the reverse sensor disconnected when the trailer is connected as the sensors are seeing the trailer when reversing and that is why they are beeping

Feb 17, 2016 | Hyundai Cars & Trucks

1 Answer

Directions to install witter towbar on ford focus


Towbars are fairly simple, if the towbar fits the frame, you are all set, if it doesn't, you have the wrong one. If there are holes that line up, use them, if not, you can drill through the frame very easily, it is soft steel, Put some bolts in there that go through about 1/2 longer than the frame parts. Support the towbar with a jack, make sure it stays put. Drill a small pilot hole first with about 1/4 inch bit, then go to the hole size of the towbar, 1/2 inch. Those step bits work great, put in the bolts, tighten them up, all set. As far as positioning this thing, I would make the ball stick out just past the bumper, if no hole line up. You don't want to be smashing the trailer into the bumper all the time, so make sure it is enough, but not so much that you trip over it. Hope this helps.

Jul 29, 2010 | 2000 Ford Focus

1 Answer

How do i install a wiring harness for a trailer on a 2002 ford focus wagon?


  • Loosen and pull back the carpeting in the back of the trunk behind the taillights.
  • Step 2 Remove the plastic wingnuts that secure the taillight to the vehicle's body.
  • Step 3 Separate the taillights from the vehicle's body, but do not disconnect the wiring.
    Installing the Connector
  • Step 1 Examine the wiring harness on each taillight. There will be a plastic connector on each side that must be separated to insert the wiring harness connector.
  • Step 2 Thread the trailer wiring connectors through holes in the body behind each taillight. Follow the instructions provided with the connector to determine which connector belongs in which side of the vehicle.
  • Step 3 Insert the wiring connectors into the vehicle's wiring harness.
    Reinstalling the Taillights
  • Step 1 Push the taillights into position against the body and reinstall the plastic wingnuts that secure them. Be careful not to crush the wiring.
  • Step 2 Route the trailer wiring underneath the carpeting in the trunk, so that the trailer connector can extend out between the trunk lid and bumper when in use, and be tucked into the trunk when not in use.
  • Step 3 Reposition the trunk carpet over the taillight housing.
  • Jul 02, 2010 | 2002 Ford SVT Focus

    1 Answer

    Towbar Wiring Instructions Ford Focus


    On the left inside the boot behind the carpet is a blue connector, this has all of the wires for the rear lights. if you use a test lamp you can identify which wires do what and connect as you go. Use a self tapping screw for earth.

    Aug 27, 2009 | 2002 Ford SVT Focus

    2 Answers

    Tow bar trailer socket wiring connection point to car wiring?


    The connectors for towing wire harnesses on foresters are generally on the passenger side, below the rear taillight inside the cargo space. some require pulling up the foam block that is between the spare tire compartment and the taillight. Check where you replace the tailights from inside the car, if there isn't a matching connector hanging out there, check around the spare tire compartment, see if you can remove the carpeted foam block next to the compartment and find the plug under there.

    Jun 03, 2009 | 2006 Subaru Forester

    2 Answers

    Towbar wiring


    i wiried up my focus estate with the following no relays needed as the wiring is protected by the car fuses
    pin 1.yellow/left hand indicator
    pin 2.blue fog light
    pin 3.white/earth
    pin 4.right hand indicator
    pin 5.brown/right hand tail light
    pin 6.red/ brake lights
    pin 7. black left hand tail light
    connect these to the car wiring with scotch locks as follows/red/blue.right hand indicator/blue.left hand indicator,green/black,left hand indicator,red/green,right hand indicator,orange right hand light,orange and white,left hand lights, finally green/yellow fog light
    hope this is of use to you all my lights are working and correct

    May 09, 2009 | 2000 Ford Focus

    2 Answers

    Volvo V70 2001.. Plugs For Towbar Electric's??


    You can get an adapter that fits in to the 13 pin socket that give you a 12N socket, easily available on E-bay

    http://cgi.ebay.co.uk/13-to-7-Pin-Adaptor-for-Euro-Style-Towbar-Electrics_W0QQitemZ110303426204QQihZ001QQcategoryZ36631QQssPageNameZWDVWQQrdZ1QQcmdZViewItem

    I have one for my car and it does the trick

    Sep 30, 2008 | 2001 Volvo V70

    2 Answers

    Ford focus c max 2005 towbar wiring instructions needed


    probably you have to open the tail light bulb and connect the wire there

    Jun 27, 2008 | 2005 Ford Focus

    Not finding what you are looking for?
    2003 Ford Focus Logo

    Related Topics:

    1,762 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Ford Experts

    yadayada
    yadayada

    Level 3 Expert

    60960 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    21949 Answers

    Fordexpert

    Level 3 Expert

    5331 Answers

    Are you a Ford Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...