Question about 2006 Honda Accord

1 Answer

Wont start - the engine turns but won't fire - 2006 Honda Accord

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Honda Master
  • 5,370 Answers

In addition to the battery voltage to "turn the engine over"...ignition requires spark and gas. so first check the battery voltage with meter.it should show 12 volts.If the battery is proper and fully charged you get 12 volts.

A car that cranks over but doesn't start or does not fire, in many cases will be due to a bad fuel pump, a broken timing belt, an inoperative cam sensor or crank sensor. Also this problems are related to faulty spark plug. Check the spark at spark plugs when you start the car. Do you notice any spark. Actually you should see. If in case there is no spark then it's a spark plug problem. Also the coil pack gives power to spark plug. So check the voltage at coil pack. It will show 12 volt.If there is no voltage noticed at coil pack then its faulty coil pack that has to be replaced.If all the possible options checked out ok then check the car starter. The starter gets power from battery to start the care. If the starter is faulty then it will not let the car to start. Also check and confirm that there is fuel in the car. If its very low fuel then in some cases this causes the problem. Also check and confirm that fuel pump is functioning properly and the fuel filter is not clogged. One of the easiest ways to check for a fuel pump related problem is to spray a little starting fluid into the air intake while trying to start the car. If the car starts momentarily, then there's a good chance the fuel pump is not working or the car is out of gas. You can also listen for the fuel pump's humming sound when the key is first turned on. Also if a inoperative fuel pump is suspected, a good technician will always check to verify there is power and ground being supplied to the pump, to eliminate the possibility of a bad relay or electrical issue. Fuel pressure can be checked with a pressure gauge and if there is pressure, pulse can be checked at the fuel injectors in several ways including the most common, with the use of noid lights. If the injectors don't have pulse the engine won't start. ---------- This troubleshooting tips will help you to solve the problem.Thanks.Helpmech.

Posted on Nov 15, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Engine won't start. a grinding sound but wont fire.


Are you saying the starter is grinding but the engine is not cranking, or the engine is cranking and making noise and not starting ?

Feb 21, 2013 | 1991 Honda Accord

1 Answer

Volvo 2005 EC210 BLC Engine Crank but no start .display shows code 140SID and 250 9


It can be faulty fuel pump or clogged fuel filter or its issue with starter or battery or may be problem with sensors.There are few possibilities that can cause these problem,there are few help links provided related to these issue. Click the link below and refer the troubleshooting procedure to solve the problem:-----
Engine cranks but will not start? http://technoanswers.blogspot.in/2012/02/engine-cranks-but-will-not-start.html
-------- Landcruiser prado won't start http://technoanswers.blogspot.com/2012/10/landcruiser-prado-wont-start.html ------- 2007 ford expedition engine cranks but wont start http://technoanswers.blogspot.com/2012/10/2007-ford-expedition-engine-cranks-but.html

--------
: Engine Cranking Fast but not Firing up? http://whatisbyme.blogspot.in/2012/05/1999-lexus-gs300-engine-cranking-fast.html

----------
1997 Oldsmobile Cutlass Ciera: The Engine cranks but not start? http://schematicsdiagram.blogspot.in/2012/04/1997-oldsmobile-cutlass-ciera-engine.html

-----
Mazda MPV cranks but will not start? http://technoanswers.blogspot.com/2012/01/mazda-mpv-cranks-but-will-not-start.html
-------- MAZDA MPV WILL CRANK BUT NOT TURN OVER TO START? http://technoanswers.blogspot.com/2012/01/mazda-mpv-will-crank-but-not-turn-over.html
--------- Vehicle Cranks Fast but Won't Start http://whoisbyme.blogspot.in/2012/07/vehicle-cranks-fast-but-wont-start.html

------
How to test Crankshaft Position Sensor? http://fordrepairhelp.blogspot.in/2012/03/how-to-test-ford-focus-crankshaft.html

---------
These details will help,keep updated for more help.

Oct 16, 2012 | Cars & Trucks

1 Answer

94 gmc sierra 4.3 v6 manual, won't turn over, can hear fuel pump start when accessories turned on..won't fire, girl who needs help


The first thing I would check is fuel pressure. This type of fuel injection requires a minimum fuel pressure in order to operate. If fuel pressure is as little as one psi below minimum the vehicle will not start. You can try squirting a couple of shots of carb spray into the air snorkel while somebody cranks the engine over. If the engine starts and then dies you now you fpdeffinetely have a fuel issue. If the engine still won't start check for spark. Let me know what you find. Let me know if you have any questions and I'll do my best to answer them. Thank you for using FixYa.com!

Feb 07, 2012 | GMC Sierra Cars & Trucks

1 Answer

My 1996 850 volvo wont start the engine turns over but wont crank


ok, turning over and cranking are the same thing, what your saying is it won't fire, so , 2 things make a motor fire, electric and fuel, so starting with the easiest remedy , remove the distributor cap, and inspect the rotor and connection points that are inside the cap, check for any debris built up , sometimes you can clean them good enough to get the car to fire up, if it does , normally you would replace them , ( not that expensive) remove the number one cylinder spark plug, and once out put the spark plug wire back on it, ( your going to need help with this step) with insulated pliers , hold the plug and place the bottom of the plug against a grounding point (any bolt on the motor will do,, but try and keep it away from the carb as its Hopefully going to spark) have someone try and turn the car over as if to start it, look for spark at the end of the plug, if you have spark,, replace the plug and try and start the car , if it won't,, move onto the fuel problem, you need to make sure that the car is getting fuel, remove the fuel line to the carb turn the key for a second, you should see fuel splashing out, if yes ,, you should be able to start the car , if no,, check the fuel filter first , then the fuel pump,

Jul 22, 2011 | Volvo 850 Cars & Trucks

2 Answers

My 1996 ford taurus sho wont start, it will turn over but not start what could be wrong?


Hello and welcome to FixYa!

Looks like that there's no current flowing that's why it won't fire up. I strongly suggest that you check and replace the coil pack if necessary. If the coil pack is faulty there will be no current to the plugs. One good reason why it won't fire up.

Hope this helps and thank you for using FixYa! Have a good one!

Apr 25, 2011 | 1996 Ford Taurus

1 Answer

My car wont star the dash lights and every thing comes on but wont start


Hello and welcome to FixYa!

If the car won't fire then it can be a faulty coil pack. If the coil pack is faulty there will be no current to the plugs, one good reason why it won't fire up the engine.

Hope this helps and thank you for using FixYa! Have a good one!

Apr 25, 2011 | 1995 Mercedes-Benz S-Class

5 Answers

Truck wont crank. we have put new distributor cap, rotor button, coil pack, plugs, wires, and fuel pump. we also checked our firing order.


you said you repl dist cap that means you don't have a crank sensor you have electronic ing module. remove your elec ing module have it tested most auto parts stores could test your module, or check your coil at the neg terminal. should have power. if not you lost your primary volt from your batt.your secondary power is coming from your electronic ing module from the module to the pos terminal on the coil, when the eng cranks,from the coil to the dist cap , from the dist cap center to the rotor then out to the plugs,this all happen pervided the timing belt or timing chain is ok. the cumbustion chainber needs 3 things , thats fuel, air, and spark.

Apr 17, 2011 | 1996 Chevrolet K1500

1 Answer

Car won,t fire up but trying to turn over its as


Lots of reasoons for a no start this answer is as if it was running OK just the other day and was starting OK. The gas tank has gas? Spinning real freely indicates to me that the timing belt broke. The oil cap off the valve cover look in there to see the cam and crank engine you should see it turn. The fuel pump may not be coming on. The fuel filter could be frozen not letting the gas go though. The spark may not be happening as A senser or also a plug wire or other wire off inspection of these things something off can be the only problem

Feb 08, 2010 | 2002 Volkswagen Golf

Not finding what you are looking for?
2006 Honda Accord Logo

300 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7688 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...