Question about 1994 Honda Civic Del Sol

1 Answer

1993 honda del sol

Key does not release from the ignition cylinder even after replacing the cylinder.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 350 Answers

Hi did you replace the whole housing and barrel and the key or just the barrel and use the oridginal key and was this the reason in the first place for replacing the barrel [cylinder] yates210456

Posted on Oct 01, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1993 honda del sol trunk wont open with key


You might be able to release the back seats and lay them down to climb into the trunk, or the seats may need to be unbolted for access to the trunk.

Jan 22, 2014 | Cars & Trucks

1 Answer

1993 Honda Del Sol makes noise when turning and


Sounds like your CV joints (axles) may be going bad.

Nov 01, 2013 | Honda Cars & Trucks

1 Answer

1993 honda del sol horn does not work. Horn


Im in the same boat with my 99 civic si. it is wiring in the steering wheel that is causing your horn to not work. it is a lot of work to replace the wire in the steering wheel, so if you want a horn, my suggestion is to wire the horn to a aftermarket switch. it is a cheap and easy solution and will get the job done.

Sep 08, 2009 | 1994 Honda Civic Del Sol

1 Answer

Honda civic 1994


Try holding the key between II and III in the ignition immediately after you start it. My 95 Del Sol VTEC is at the dealership now for the same issue, it is an ignition switch problem.

Jan 27, 2009 | 1997 Honda Civic del Sol

2 Answers

I can't turn the key in the ignition in my 98 honda civic. i know the car starts b/c i have remote start and used it. i checked that the wheel isn't locked and the car is in park.


You may need a new ignition key cylinder or your key grooves may have worn down and no longer mesh with your ignition cylinder. Good luck. Mark

Jan 06, 2009 | 1994 Honda Civic Del Sol

2 Answers

1993 honda del sol si


The click you are hearing is the starter solenoid. This solenoid is a relay that applies 12 volts (at high current) to the starter motor. When you turn the ignition key you apply 12 volts ( at low current) to the solenoid. If jiggling the key solves the problem all of the time I would suspect the ignition key assembly.
If jiggling the key only works some of the time I would suspect the solenoid/starter assembly. For your info the solenoid/starter comes as a complete assembly, when you buy it.

Hope this helps

Loringh

Nov 05, 2008 | 1994 Honda Civic Del Sol

2 Answers

Which engine fits a del sol honda 1993


Anything that is OBD 1 or newer if you want it to be legal, here are the most common options and the basic requirements. 1. B16A2/3: Completely bolt-in Swap, VTEC needs to be wired, SIR II, Hasport shift linkage. Del Sol VTEC for the del sol 2. B18B: Completely bolt-in swap, SIR II, Hasport shift linkage. Del Sol VTEC for the del sol 3. B17A: Completely bolt-in swap, cable-hydro transmission kit(not recommended) or hydraulic b-series transmission, VTEC needs to be wired. 4. B18C1: Completely bolt-in swap, VTEC needs to be wired. 5. B18C5: Completely bolt-in swap, OBD conversion, VTEC needs to be wired. 6. B16B: Completely bolt-in swap, OBD conversion, VTEC needs to be wired. 7. H22A: Mount kit required, Hasport shift linkage, VTEC needs to be wired. 8. B16A: Not recommended! Too much work, more costly compared to B16A2/3's. 9. D16Z6: Completely bolt in, VTEC needs to be wired. 10. D16Y8: Completely bolt in, VTEC needs to be wired. If you want to know more check this out - http://hondaswap.com/swap-articles/en gine-swaps-101-a-29052/

May 18, 2008 | 1995 Honda Civic del sol

Not finding what you are looking for?
1994 Honda Civic Del Sol Logo

Related Topics:

178 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

64034 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...