Question about 1987 Plymouth Gran Fury

2 Answers

Where is the ignition module at on my 1987 plymouth gran fury which is a 318 automatic?

Posted by on


2 Answers

  • Level 1:

    An expert who has achieved level 1.


    An expert that has over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 15 Answers

Squad cars with the 4bbl carb had them under the dash on probably 90% of the Furys and Diplomats.

Whats the car doing?

Posted on Jul 10, 2011

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 381 Answers

On The late 80's gran fury The ignition module was part of the computer that is attchced to the air cleaner. I have seen them on some of the very early 80 cars and they were on the passenger inner fender under the hood. But if you have a big black box on your air cleaner with a bunch of wires going to it it was part of that. Hope this helps.

Posted on Nov 15, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

What does the ignition actuator do?

the actuator is the rod that runs from the key switch to the ignition switch at the bottom of the steering colume that moves the slide in the switch to start the car.

Jul 11, 2014 | 1987 Plymouth Gran Fury

1 Answer

Ignition coil wiring diagram 1987 plymouth gran fury

I just looked on my 86 gran fury--I have a blue and a black wire. They both run up into a combination of other wires(including the voltage regulator mounted on the firewall, the wires from the windshield washer fluid tanks, etc). This larger set of wires run along the firewall across to the driver's side. Maybe start unwrapping the wire bundles closest to the wire in question,, and you will find the broken wire end inside. If you meant the coil wire(in the center of the top of the ignition coil;it has a rubber boot on it), it goes to the center of the distributor, which is behind the air cleaner along the firewall. both wires need to be intact for the car to start.

Jul 06, 2012 | Plymouth Gran Fury Cars & Trucks

1 Answer

Installing waterpump reinstaling alternator

Biggest thing here is you have to have the right bolts in the right place. Easiest thing to do is put the bolts in the new pump as you take out the old one. If you have them all mixed up, go to the junkyard and take a look at any older (pre-Magnum) chrysler 318 or 360. Draw a diagram, and you're all set.

Feb 14, 2011 | 1987 Plymouth Gran Fury

2 Answers

What would make my 87 gran fury sputter when floored ???-

bad wires or distributor cap, fuel injectors, coils

Oct 06, 2010 | 1987 Plymouth Gran Fury

1 Answer

Where is the fuel pump located on a 73 Duster 318

Should be located on the block, passenger side, down low, and more at the front of the vehichle. It is a mechanical pump and bolted to the block with either 2 or 3 bolts, should have 2 or 3 steel lines cominng out of it.

Sep 17, 2009 | 1983 Plymouth Gran Fury

1 Answer

Problem starting my 88 gran fury.

try giving it a full tune up and carb /fuel injection cleaner

Aug 22, 2009 | Plymouth Gran Fury Cars & Trucks

1 Answer

How to remove 1988 gran fury rear seat

Push down on bottom part with knee, while pushing back. Do the same on the other side. Once that's out, two bottom bolts for the upright part, then lift up. You're done.

Aug 13, 2009 | 1987 Plymouth Gran Fury

1 Answer

Where is the fuel filter located for a 1987 Plymouth Gran Fury?

Fuel filter should be pass side front of engine,down low by the pump

Mar 14, 2009 | 1987 Plymouth Gran Fury

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

200 people viewed this question

Ask a Question

Usually answered in minutes!

Top Plymouth Experts


Level 3 Expert

79024 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8836 Answers

Are you a Plymouth Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides