Question about 1993 Toyota Corolla

Open Question

Engine idle at a stop has a hiccup to it or stalls. What is the cause? Did a tune up and fuel injection service 2000 miles ago when had same problem. Now it is back again. 1993 Toyota Corolla 142,000 miles

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1861 Answers

SOURCE: wiring diagram for 1993 toyota camery v6

Does the engine run properly when you drive it? Does it accelerate normally, or does it hesitate & ****? If it runs poor, it may be the wires crossed. If it just stalls at idle, you may have a bad Idle Air Control (IAC) valve, or a partially stuck open EGR valve.

Posted on Oct 01, 2008

  • 1861 Answers

SOURCE: replace rear seat belt in 1993 Toyota Corolla

OK. On the front edge of the seat bottom cushion, pull up hard, both sides. This will dislodge the 2 clamps that holds the seat cushion to the floor. Pull the seat cushion out & set it aside. You will now see the female latches bolted to the area where the rear of the seat cushion meets the rear seat back bottom. Remove the bolts (14 mm I think).

Posted on Oct 07, 2008

  • 1861 Answers

SOURCE: 03 toyota corolla engine light on again!

Without seeing your vehicle on my scan tool, it is hard to see what is exactly going on.
But, please allow me to share the following info with you:
The P-0171 code relates to the Mass Airflow Sensor. This is a VERY common code with the Corolla product.Your dealer *** should *** have inspected it for dirt contamination, and cleaned it, if it was indeed dirty.
Secondly, The P-0125 relates to Oxygen Sensor number ONE. If your dealer replaced the wrong sensor; (#2), you can expect to have problems.
My advice: unplug, remove, inspect & clean the MAF sensor. Ensure that the air filter is clean.
This should help you quite a bit.

Posted on Oct 13, 2008

USfalcon
  • 175 Answers

SOURCE: Corolla repair manual

can y tell me what enigne size ?

Posted on Mar 23, 2009

  • 9 Answers

SOURCE: wondering if a 1998 toyota corolla will fit in a 2000 corolla

In 1998 the 1zz-fe engine was intoduced. Toyota only added variable valve timing in the 2000-2002 1zz Corolla engines. Same engine same parts and components

Computers should not need swapped but you could go to the dealer and ask for the part number for 1998-2002 ECU's for Corolla. This is the electronic control modul on the car that runs the engines.It is usually located under the dash by the passengers side glove box.

Posted on May 27, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Engine dies immediately after starting


Very limited information for me to work with here, but if it is a newer fuel injected engine built prior to 2000 the try the procedure below.
Throttle Body Cleaning on vehicles without electronic throttle control (most 2000 and down)
You can in most cases repair this slow speed stall or unstable idle by cleaning the engine throttle valve and the idle speed control valve using a product called CRC Spray Throttle valve cleaner. Spray the cleaner into the air intake of the engine with the hose removed from the throttle body, the engine will try to stall so hold up the idle speed manually. Once you have used up about 1/2 can of the cleaner stall the engine out while spraying and turn the key off, disconnect the negative battery cable for 5 minutes and then reconnect and drive the car for a about 25 miles of varied driving modes. If this doesn't cure the problem you may need the fuel injectors professionally cleaned by the dealer service dept.

Jun 15, 2017 | Cars & Trucks

Tip

Car and Light Truck Engine Stalls-all fuel injected gas engines


Here are the common cause of surges, cold stalls, stalls at stops, slow idle speed, erratic idle speed, rough idle and engine hesitation (and other problems), it is in most cases the idle speed control air-bypass valve and or throttle valve and upper intake, these area's get full of gunk and combustion residue over the miles and cause idle issues (stalls, low idle) like yours, Get a can of intake cleaner from any local parts store, not carb spray, intake cleaner, it is made by a company called CRC, remove the air intake hose to the engine, hold the idle high so the engine won't stall, then spray the can of cleaner into the intake while keeping the engine running, use at least 1/2 the can, shut down the engine and disconnect the battery for 5 minutes, then restart and complete a number of mixed driving cycles, town, freeway, stop and go etc., after a few days the problem will go away as the system will relearn to the clean intake.

on Dec 01, 2009 | Chevrolet Camaro Cars & Trucks

2 Answers

What makes my 2007 Isuzu turn off when I come to a stop


if it is petrol and you have your foot on the brake do a simple test first of stopping with the hand brake and if it keeps idling the replace the brake booster
next is to run the fault codes

Jul 09, 2015 | Isuzu Cars & Trucks

1 Answer

1991 ford ranger 2.3L manual, no air, lopes underway, wants to stall at take off. What is cause?


The problem could be plugged up catalytic convert it is related to tune up.One more thing fuel filter too. Check auto zone if they have anything to burn out catalytic.When you change with standard catalytic you will have code PO420 will be a headache!!!!!!!! 80% cars have this problem Think twice before doing anything.

Apr 14, 2017 | Ford Ranger Cars & Trucks

1 Answer

No power won't hold idle


stalls. (hot engine, cold engine, both?)_what engine of the many.?
lost engine power. sure that will stall any motor.
ever tune it up r, or do the 60k mile service points, EVER?
if car was serviced, we can then say
Stalls.
1: lost 12vdc to EFI and spark , did dash lamps all go dead at stall.
can you save the stall with a fast right foot. (big clue there !!!)
2: lost compression hot. (guage it)
3: lost spark. (tests)
4: lost fueling, or floods more simple tests, ask if not known.
5: EGR main valve stuck wide open.
6: ISC stuck closed but will not stop power, or fast right foot.

lost fueling can be just the skippped, 60k fuel fuilter swap.

Dec 05, 2013 | 1991 Honda Civic

1 Answer

1998 Lincoln Mark VIII sometimes stalls when idling in gear


Do you have a "Check Engine" light?

Check the coils in each cylinder. At 140k the valve cover gaskets tend to break and oil will fill the coils causing misfires and stalling.

Feb 14, 2012 | 1998 Lincoln Mark VIII

1 Answer

My 1994 mazda 626 starts and ldles but stalls when driving


ENGINE STALL WHILE DRIVING COULD BE STOPPED UP FUEL FILTER OR FAULTY FUEL PUMP.IDLE SPEED TOO LOW.OR IGNITION COIL HAS A LOOSE ELECTRICAL CONNECTION.FAULTY IGNITION MODULE.BAD PLUGS AND WIRES. I WOULD DO A LITTLE TUNE UP.CHANGE FUEL FILTER AND AIR FILTER.IF SPARK PLUGS AND WIRES HAS OVER 30000 MILES ON THEM I WOULD CHANGE THEM.ALSO FUEL FILTER IF OVER 30000 MILES.CHANGE IT CLEAN FUEL INJECTORS. TO TROUBLE SHOOT CAR I WILL DO A LITTLE TUNE UP FIRST TO MAKE EVERYTHING TOP NOTCH ON THE ENGINE BEFORE I GO TO NEXT LEVEL.BUYING NEW PARTS DONT NEED.GET VECHICLE SCANNED WITH A SCANNER. THAT WILL ALSO PIN POINT PROBLEM QUICKLY.BUT DO THE LITTLE TUNE UP FIRST IF EVERYTHING PAST 30000 MILES MARK.SCAN VECHICLE FOR FAULTY IDLE SPEED CODES OR FAULTY IGNITION MODULE CODE THEY WILL COST MORE MONEY TO FIX.PARTS HIGH.

Dec 24, 2010 | 1994 Mazda 626

2 Answers

2005 Tahoe stalls when turning (not always - maybe 5% of the time). Vehicle has 40,000 miles.


The most likley cause is a dirty throttle body this will cause a low idle and stall at slow speeds.

Aug 06, 2009 | Chevrolet Tahoe Cars & Trucks

1 Answer

2000 kia sephia constant engine stalling!!!


try this procedure and let me know if it cures the problem.

Here is the common cause of surges, stalls at stops, slow idle speed, erratic idle speed, rough idle and engine hesitation (and other problems), it is in most cases the idle speed control air-bypass valve and or throttle valve and upper intake, these area's get full of gunk and combustion residue over the miles and cause idle issues (stalls, low idle) like yours, Get a can of intake cleaner from any local parts store, not carb spray, intake cleaner, it is made by a company called CRC, remove the air intake hose to the engine, hold the idle high so the engine won't stall, then spray the can of cleaner into the intake while keeping the engine running, use at least 1/2 the can, shut down the engine and disconnect the battery for 5 minutes, then restart and complete a number of mixed driving cycles, town, freeway, stop and go etc., after a few days the problem will go away as the system will relearn to the clean intake.

May 20, 2009 | 2000 Kia Sephia

Not finding what you are looking for?
1993 Toyota Corolla Logo

Related Topics:

147 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7782 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...