Question about 2000 Jeep Wrangler

1 Answer

Jeep Troubles I have a 2000 jeep wrangler sport, today I got into it after work and I couldn't put it in gear (manual trans.), when I press in the clutch it feels like it has pressure but I can not put it in any gear, it's like it won't go in gear. Any ideas what the problem might be?? Shawn

Posted by on

  • 1 more comment 
  • mspage71 Jun 19, 2008

    I went out and started it this morning and it went in gear like nothing was ever wrong, so I drove around the block a few times (seemed to grind just a little going into 3 & 4 gear), I got home waited about 20 mins. started it back up and it won't go in any gear again. So this problem is happening off & on, think the trans. is going out???
    Shawn


  • mspage71 Jun 20, 2008

    Thanks again!

  • SLAYER SLY May 11, 2010

    is it grinding try putting it in gear before cranking and let me know what it does

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 113 Answers

Sounds like the clutch is failing before changing the clutch check the trans fluid for metal hunks or sliver fluid if that is present u might have an internal trans failure

Posted on Jun 20, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2010 Jeep Wrangler unlimited sport extreme shudder at 40 mph- if I press the gas-pedal and get the RPMs to rev, the shudder ceases, only to return once I am back down around 38 mph-41mph.


which engine the 3.6? v6?
that shudder is called MISFIRE.
get a tune up yet, even $1.49 spark plugs?
no its not the trans,
if it dont slip, its not trans, (see RPM races? that is slip or too low gear)
if it shifting to the right gears, its not the trans can you count them?
is the CEL lamp glowing or flashing driving, is yes, that means
scan me now. in fact scanning while it shudders, is like (magic)
why start guessing, do a tuneup,
then scan it.
if its is misfire the PCM will tell you what cylinder misfires.

are your spark plugs 6 years old, if yes, why?
going for 200k miles on them.?

Oct 30, 2016 | 2010 Jeep Wrangler Unlimited

1 Answer

What type of fluids are used in a 2000 Jeep Wrangler sport 4.0 in-line 6 automatic


go on line to jeep wrangler fluid capacities and specs and down load the information.

Dec 20, 2014 | Jeep Cars & Trucks

1 Answer

Can a jeep cherokee ****** be put into a jeep wrangler


only if it is a jeep cherokee sport and you will need to swap out the sensors

Dec 15, 2012 | 1998 Jeep Wrangler

1 Answer

My 2000 Jeep Wrangler manual trans. won't shift it into 2nd, 4th, Reverse...


I had the same problem, funny as it sounds but go to jiffy lube, oil rig, or one of those places and have them flush ur trans and have good fluid put in...

Oct 25, 2012 | 2000 Jeep Wrangler

1 Answer

How hard is it to install a gear box for a 2002 Jeep Wrangler Sport


Not too bad with a lift and a trans jack to support it.just remove the two drive shafts,the bolts attaching it to the rear of the transmission and any wiring.Thats the jist of it.Hope tis helps,
Ken

Oct 08, 2010 | 2002 Jeep Wrangler

1 Answer

Jeep 1997 Wrangler. Gear shifting very hard


synchronizers are going bad a used trans would be cheaper than a rebuild due to the labor involved

Aug 19, 2009 | 1997 Jeep Wrangler

1 Answer

Jeep auto trans skips second gear


That transmission drum is gone, no other alternative to dismantle and repair.

Jul 16, 2009 | 1993 Jeep Wrangler

1 Answer

89 Jeep Wrangler. Engine stalls only when I put into gear.


it might be getting to much fuel check the fuel screw

Jun 10, 2009 | 1989 Jeep Wrangler

1 Answer

2000 jeep wrangler are sythetic lubes used in axils and trans


Hello grega1967, your Jeep Wrangler came from the factory with gear oil in the axles and manual transmission, but the transfer case uses transmission fluid. It is a NP231 and your axles are Dana 30 in the front and Dana 35 in the rear. They should have a 4.10 gear ratio due to you having a 2.5 liter 4 cylinder.

I hope this helps,

map6260

Mar 12, 2009 | 2000 Jeep Wrangler

1 Answer

Manual Trans Problem


you should of stopped and picked it up. just kidding! do you mean it wont go into gear or when it is in gear nothing happens

Aug 14, 2008 | 1995 Jeep Wrangler

Not finding what you are looking for?
2000 Jeep Wrangler Logo

Related Topics:

255 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

64286 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...