Question about 2000 Chevrolet Blazer

1 Answer

Blazer not firing

Replaced fuel pump, then filter, distributer, now it's not firing. Any advice?

Posted by on

  • Anonymous Jun 22, 2008

    Not getting fuel. replaced pump and filter



1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Master
  • 1,010 Answers

Maybe try also to replace the blazer...

Posted on Jun 19, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

1998 s-10 blazer 4x4 4.3 engine starts and dies quickly

How about finding a repair shop, that
can actually find a problem,instead of
installing parts,as it appears was done ?

Oct 04, 2014 | 1998 Chevrolet Blazer

1 Answer

Truck will not start, tries to fire, better luck when i alow fuel pump to kick on a couple times. but i just replaced the pump and fillter.

If you know plugs /wires are good and you know for sure cap/rotor/and or coil pack is all good and getting should be crank sensor is bad....if not fuel pump could be installed improperly or in some cases fuel filter is in backwards...make sure arrow on fuel filter is in flow direction....

Feb 25, 2011 | 1993 Chevrolet S-10 Blazer

1 Answer

Have replaced fuel pump, relay & fuel filter.

have you checked to see if you have a bad came or lifter. that would make it backfire. if it kind of spits fuel it maybe cam. if it throws fire than it could be timing like a bad chain.

Feb 12, 2010 | 1986 Chevrolet S-10 Blazer

1 Answer

I have 98 s 10 blazer have re place fuel filter,had fouel injection cleaned via fuel rail ,replaced plugs wires rotor and cap .first start is always hard and advice

Sounds like the fuel pressure doesn't build up right away, before you crank the engine, just cycle the key from off to run position a couple times to allow the fuel pump to build pressure and then crank...if this still doesn't work, hook a set of jumper cables up to it and then crank...the extra voltage will allow the pump run faster and may fire right off....if this helps in starting, i would suspect a weak fuel pump.

Jan 21, 2010 | 1998 Chevrolet S-10 Pickup

1 Answer

87 Chevy K5 Blazer engine won't fire, but revs when trying

If you had water on your distributer I would personally pop that off and check inside to see if there is a little moisture in there. It almost sounds like there is

Jan 03, 2010 | 1987 Chevrolet Blazer

1 Answer

2001 Blazer Ignition or fuel Problem?

try checking your fuel tank for sediment it may be clogging the fuel pump and when it dies it falls away then when you start up again it gets sucked up

Jun 11, 2009 | 2001 Chevrolet Blazer

2 Answers

Where is fuel pump relay located on 1994 chevy blazer

It should be in the power distribution box under the hood on the drivers side.

Jan 12, 2009 | 2003 Chevrolet Tahoe

2 Answers

86 Chevy wont start

check for spark by removing a sparkplug

Dec 31, 2008 | 1986 Chevrolet S-10 Blazer

Not finding what you are looking for?
2000 Chevrolet Blazer Logo

Related Topics:

59 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

77202 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides