Question about 2003 Jeep Grand Cherokee

1 Answer

My jeep grand cherokee rear end seems to twist when I accelerate 2003

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Jeep Master
  • 2,527 Answers

Check your shocks push up and down on rear bumper it should stop moveing up and down in like 2 seconds if it keeps bounceing your shocks are blowen also look at the springs they should have apisitive arch to them

Posted on Nov 14, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

My jeep makes a repetitive noise at high speeds. At first I thought it was due to the fact that I was running late and didnt have time to let it warm up. I live in New England so it get's very cold over...

Check for the Universal Joint wear in the driveline. If it gets louder and louder and the clicking doesn't seem to go away on acceleration on the highway, then it's time to replace it.

Dec 18, 2010 | 1999 Jeep Grand Cherokee

1 Answer

I am getting a metallic "clicking" noise from the front end of a 2003 jeep grand cherokee. The noise is most audible at low speeds (10-15 mph) The tempo of the noise does not seem to increase/decrease with...

I can't say for sure without actually checking myselft but it sounds like one of four possiblilities, ball joints, tie rod ends or sabilizer bar ends or shocks.
To check the tie rod ends put the jeep on jack stands or a hoist, with the steering wheel locked try to turn the wheels back and forth and look for movement in the joints of the linkages.
To check the ball joints, while the jeep is up in the air grasp the top and bottom of the wheel and try tipping the wheel in and out, checking for movement in the ball joints.
Lower the Jeep back to the ground. Continue the tests by having a big friend or family member bounce the Jeep while you listen for and look for movement in the ball joints, stabilizer bar ends and along the linkage and abnormal movement in the shocks.

Jun 25, 2010 | 2003 Jeep Grand Cherokee

1 Answer

I have a 2003 Jeep Grand Cherokee, there is a small wire on the positive battery terminal, it is disconnected at the opposite end, where does this connect to? The engine is a 4 liter 6cyl.

it sounds like the wire has been fitted for an aftermarket accessory. eg handsfree kit or somthing, doesnt seem to be original.
hope this helps

Dec 13, 2009 | 2003 Jeep Grand Cherokee

1 Answer

Vibration while accelerating from 30 to 45 mph Jeep GrandCherokee

Not a tune up problem,
You need to have all U-joints checked out,They will give you the vibrations only while acceleration

Dec 04, 2009 | 2003 Jeep Grand Cherokee

1 Answer

2003 grand cherokee steering column noise

check the universal joint on the bottom of the steering collum, put one hand ether side of it an twist see if there is any play in it you can also see if it is stiff/seized these will both cause a noise

Oct 01, 2009 | Jeep Grand Cherokee Cars & Trucks

1 Answer

2003 Jeep Grand Cherokee, how to replace rear tail light

I thinking tha you are fix the CHMSL (Central High Mounted Stop Light); review the Service Manual, the section ZJ-Secc-8L-Lamps (page 7, fig. 11).

I hope help you with this, good luck (remember rated this help).

Sep 16, 2009 | 2003 Jeep Grand Cherokee

1 Answer

How do you change a headlight on a 2003 jeep grand cherokee

Pop your hood. Look for a connection that goes to your headlight and you just twist the connector and the burned out light is on the other side. If that doesn't help go to your local auto parts store and I'm sure they would help you out.


Mar 25, 2009 | 2003 Jeep Grand Cherokee

4 Answers

Rear end (axle)

call jeep and give them last 9 digits of your vin and ask for three things -Differential Type,Gear ratio, and Track lock- They will give you
1) Dana 35 or 44
2) Gear Ratio 3.31 or 3.73
3) Track Lock - yes/no

Jan 11, 2009 | 1998 Jeep Grand Cherokee

1 Answer

Not accelerating when stepping on the gas

throttle position sensor would cause this. Is there a check engine light

Dec 13, 2008 | 2003 Jeep Grand Cherokee

Not finding what you are looking for?
2003 Jeep Grand Cherokee Logo

Related Topics:

177 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts


Level 3 Expert

79123 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides