Question about Hummer H2

2 Answers

How do you remove the rear rotos normaly on most cars they just pull off but not on the Hummer what do I need to do

Posted by on

  • johnphilipso Nov 15, 2010

    The hummer H2 is 2003 and yes I did meen rotors

  • johnphilipso Nov 17, 2010

    Yes I received your your reply but there was no clips holding the rotors on and I still could not remove them

×

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 4,059 Answers

Front rotors...
Remove caliper and remove the two little retaining clips on two of the studs. NO need to replace these clips, they are on for factory assembly to prevent the rotors from falling off on the line.
Pull on rotor and remove.

Rear...same thing as the front. However, since the park brake shoes are on the inside of the rear disc drum, they tend to hangup the rotor. So, pull it back and forth and sometime the infamous special tool known as a rubber mallet, can be your friend.

However, most of the time that there is a problem removing a rotor is due to the two retainers holding the rotors in place.

Posted on Nov 15, 2010

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Hummer Master
  • 75,797 Answers

What year?, H2? please give exact model and year information. Do you mean rotors?

Posted on Nov 14, 2010

  • yadayada
    yadayada Nov 17, 2010

    The rotors are rusted on to the axle face, you need to soak around the lug bolt studs with rust penetrate (like WD40) and tap around the edge of the brake rotor with a brass faced hammer (to avoid damage to rotor) until the rust bond between the rotor and the axle face breaks free..

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2006 hummer h2 axle seal


Did you jack up the rear end, remove the rear tires and brakes, turn the half shaft and through the hole remove the bolts? there are 4 to 5 bolts holding the halfshaft in the housing

Dec 10, 2013 | Hummer Cars & Trucks

1 Answer

How to remove passanger side door panel 2012 auston martin db9


Its just fitted with few screws and hidden lock clips.The clips are very delicate and can break easily.But no worry,the clips are easily available.
on some vehicle models these screws are hidden.Once the panel is loose, don't just pull it out,there are few wire connectors connected,first disconnect the connector plug,then lift the panel out and keep in safe place for re-installing.
For your help,there are few very helpful similar help links with diagrams and solutions to make your task easy.Click the link below:----How to Remove Door Panels on Acura Integra
http://repairhelpcenter.blogspot.com/2011/11/how-to-remove-door-panels-on-acura.html

-------How to Access car door panel?
http://howtobyme.blogspot.com/2011/11/how-to-access-car-door-panel.html

---------

Vehicle door panel components?
http://howtobyme.blogspot.com/2011/11/vehicle-door-panel-components.html
----------How to remove the door panel to install a new window regulator on Cadillac Deville?
http://howtobyme.blogspot.com/2011/08/how-to-remove-door-panel-to-install-new.html
---------------
Hummer H2 Door Panel Removal? http://technoanswers.blogspot.in/2012/07/hummer-h2-door-panel-removal.html
------- Hummer H2: How to remove Front Door panel? http://www.howtobyme.blogspot.com/2012/07/hummer-h2-how-to-remove-front-door.html
-------------- 2009 Hummer H2 Door Panel Removal http://schematicsdiagram.blogspot.in/2012/07/2009-hummer-h2-door-panel-removal.html
-----------how to remove window motor on driver side door panel on 1994 Oldsmobile Cutlass Ciera
http://technoanswers.blogspot.com/2011/08/how-to-remove-window-motor-on-driver.html
------------How to remove door panel, door window motor and regulator on 1991 cavalier?
http://technoanswers.blogspot.com/2011/05/how-to-remove-door-panel-door-window.html
-------------
how to remove rear window inner panel on Hyundai Elantra?
http://technoanswers.blogspot.com/2011/05/how-to-remove-rear-window-inner-panel.html
------------
ford explorer window motor, regulator and door panel removal?
http://technoanswers.blogspot.com/2011/02/ford-explorer-window-motor-regulator.html
------------
These details will help.
Thanks,.

Nov 23, 2012 | Cars & Trucks

1 Answer

How do I remove the driver door panel on a 2002 cadillac deville


DOOR PANEL REMOVAL



Its just fitted with few screws and hidden lock clips. The clips are very delicate and can break easily. But no worry, the clips are easily available.

On some vehicle models these screws are hidden. Once the panel is loose, don't just pull it out, there are few wire connectors connected, first disconnect the connector plug, then lift the panel out and keep in safe place for re-installing.


For your help, there are few very helpful similar help links with diagrams and solutions to make your task easy. Click the link below:----


How to Remove Door Panels on Acura Integra
http://repairhelpcenter.blogspot.com/2011/11/how-to-remove-door-panels-on-acura.html

-------

How to Access car door panel?
http://howtobyme.blogspot.com/2011/11/how-to-access-car-door-panel.html

---------

Vehicle door panel components?

http://howtobyme.blogspot.com/2011/11/vehicle-door-panel-components.html

----------
How to remove the door panel to install a new window regulator on Cadillac Deville?
http://howtobyme.blogspot.com/2011/08/how-to-remove-door-panel-to-install-new.html ---------------
Hummer H2 Door Panel Removal? http://technoanswers.blogspot.in/2012/07/hummer-h2-door-panel-removal.html

-------
Hummer H2: How to remove Front Door panel? http://www.howtobyme.blogspot.com/2012/07/hummer-h2-how-to-remove-front-door.html

--------------
2009 Hummer H2 Door Panel Removal

http://schematicsdiagram.blogspot.in/2012/07/2009-hummer-h2-door-panel-removal.html

-----------

how to remove window motor on driver side door panel on 1994 Oldsmobile Cutlass Ciera
http://technoanswers.blogspot.com/2011/08/how-to-remove-window-motor-on-driver.html

------------

How to remove door panel, door window motor and regulator on 1991 cavalier?
http://technoanswers.blogspot.com/2011/05/how-to-remove-door-panel-door-window.html

-------------
how to remove rear window inner panel on Hyundai Elantra?
http://technoanswers.blogspot.com/2011/05/how-to-remove-rear-window-inner-panel.html

------------
ford explorer window motor, regulator and door panel removal?
http://technoanswers.blogspot.com/2011/02/ford-explorer-window-motor-regulator.html

------------
These details will help.

Thanks,.

Nov 23, 2012 | 2002 Cadillac Deville

1 Answer

How to remove rear door panel on h2


Its not very hard,check the 3 help links provided below regarding this:----

http://technoanswers.blogspot.in/2012/07/hummer-h2-door-panel-removal.html


--------------
http://www.howtorepairguide.com/2012/07/hummer-h2-how-to-remove-front-door.html


------------

http://schematicsdiagram.blogspot.in/2012/07/2009-hummer-h2-door-panel-removal.html

----------
All the 3 help links will give you complete step by step procedure to remove door panels.

Thanks.

Jun 05, 2012 | 2004 Hummer H2

1 Answer

2006 hummer h3 replace burnt out left trun signal bulb


if it's the rear light, open the back door all the way and look where it hinges. There are two phillps screws in there that you remove and then go out side the door and gently pull streight back on the light assy to remove it

Nov 20, 2010 | 2006 Hummer H3

1 Answer

Rear passenger seat belt locked in place how do i unlock it when it is rolled all the way up with no slack to pull out?


eremove seatbelt cover, locate the safety lock lead or metal at the bottom of seatbelt assembly, remove the plastic roto that locks , push slightly teh belt and if u think lock is release, slowly pull the belt.

Jun 27, 2010 | 1994 Oldsmobile Cutlass Supreme

1 Answer

I need to remove the luggage racks from my 2007 Hummer h2 SUT


I have the same vehicle and was able to remove mine with the following steps: 1) remove light behind each rear of luggage rack rail using phillips screwdriver (one screw each side). 2) remove molding underneath each light using T20 torx driver (2 screws each side). 3) Loosen cross rails nobs. 4) Side cross rails off of roof.

Nov 27, 2009 | 2007 Hummer H2 SUT

1 Answer

How do i pull off the lens for rear break bulb to replace the blinker and the break bulb?


Open the rear gate. There are a couple screws you need to take out to remove the whole lamp assembly. Pull the bulbs out and replace then replace the lamp and put screws back in.

Nov 09, 2009 | 2008 Hummer H3

2 Answers

Rear output shaft seal on transfer case is leaking hummer h2


How to remove axle shaft seal on hummer H2

Feb 20, 2009 | 2005 Hummer H2

2 Answers

Replace rear turn signal bulb on 2007 H3 - driver side


1st::Unscrew the 2 screws that hold the light in.
2nd::Slide your hand behind the light and pull the light towards you. Make sure that you pull it straight, as if the h3 was driving away from you, so you dont break the two pins that are holding the light in...PULL ONE PIN AT A TIME!!!

Dont pull it to far away from the hummer as there are wires attached that need to stay attached.

3rd::turn the back of the bulb to unlock it from the lens...
4th:: slide the bulb out and remove thebulb by pulling it straight out.
5th::put the new bulb in, lock it back into the lens, then insert it back where you got it from,...

MAKE SURE you move the wires out of the way when you put the lens back in...they will get in the way and can be damaged.

Jan 10, 2009 | 2006 Hummer H3

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

59 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hummer Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8152 Answers

Are you a Hummer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...