Question about 2000 Buick LeSabre
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: location of blower resistor
The 96 LeSabre Custom and LeSabre Limited use an electronic module in place of a blower resistor.
It is under the hood on the firewall on top of the heater plenum, but below the relay rack.
They tend to short and run on high until the module burns out and then it quits.
The same part is used on many high-end GM cars from 92 to 96. The electronic module has two connectors on it. (If yours has only one plug it is a real resistor pack and not electronic.)
Posted on Nov 05, 2008
SOURCE: 2000 Buick LeSabre Struts
Yes there are struts on the front and shocks on the back. 2 of each. They are around $50-100 for the fronts. $30-100 for the rears depending if the car has air ride or not.
Posted on Nov 08, 2008
first disconnect the battery then check how the serpentine belt is lined up so u can take it off and put back on. Then the pump should be on the side of the motor with 9or12 bolts there could be more! after taking out take razorblad and skrap the old gasket clean wipe of then put new gasket and pump back on dont over tighten the screws cuase the pump my be aluminum.
Posted on Mar 19, 2009
it should be on top of power steering pump - look over right front fender at the engine belt - on left back corner of the motor the power steering pump should be seen below the alternator - reach down and turn cap that is on top of pump - they should have put a remote tank on pumps
Posted on Sep 21, 2009
kind of tricky, took me an hour to get it figured out, but you got to opend the trunk and take out the 10 or so 10mm nuts sticking out of the backside of the lid, then the whole solid piece where the lights are on the back will slide off, then you can change the bulbs above the license plate and put it all back together
Posted on Mar 20, 2010
Tips for a great answer:
Jan 17, 2017 | 2000 Buick LeSabre
Jul 23, 2015 | 2000 Buick LeSabre Limited
Jun 28, 2015 | Buick Cars & Trucks
Jan 06, 2011 | 2000 Buick LeSabre
Apr 27, 2010 | 2000 Buick LeSabre
Mar 08, 2010 | 1998 Buick LeSabre
Jun 27, 2009 | 2000 Buick LeSabre
Nov 05, 2008 | 2000 Buick LeSabre
Sep 06, 2008 | 2000 Buick LeSabre
461 people viewed this question
Usually answered in minutes!