Question about 2004 Ford F150

1 Answer

I have a 2004 ford f-150 and I just bought a after market stereo forbit and I was just how to get the old stereo deck out of the dash? Thanks

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 984 Answers

The center trim panel is held on with spring clips.
Open the ash tray, and start at the lower corners, pulling hard. I use a plastic trim tool with a lip on it, so get a grip on the panel.

Once the lower corners are released, you can work your way up the panel to the top ( spring clip locations circled in black in the picture below ):
I have a 2004 ford - sscullys_23.jpg

Posted on Nov 14, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1997 GMC Sierra 2500 4x4 EXT after market deck has no sound


either the deck is a dud, or the wires are not properly hooked up

Mar 09, 2013 | Cars & Trucks

1 Answer

How do you put normal cd player in 2004 model ford fusion


You will need an adapter kit for the dash panel specific for the Fusion or a multi kit, both availible at an Auto Parts store. You should also buy the wiring harness for the Car as well, this will make life much easier on you! Connect the harness to the stereo, following the schematic/diagram. Pop the dash panel apart and remove the old stereo. Slide the adapter plate over the wires FIRST, then connect the wire harness, put the adapter plate in place and then slide the stereo in place, re-assemble the dash...

Jun 11, 2012 | 2006 Ford Fusion

1 Answer

I have a 1987 trans am gta tpi 5.7 350 i just bought the kid i got it from said the anti theft chip fried so he just took it out and spliced the wires said it had no problems running or staring then some...


If it is the antitheft, there will be a light on the dash that says SECURITY. If you see that light, then here is a link to help.

http://vatspasslockpasskeysecurityhelp.yolasite.com/

When someone steals a stereo, if they rip it out and damage wires, you could have a short behind the dash. Common practice on old cars was to run a wire from the ignition to the stereo deck so that when the car turned off, so did the deck. This might be the case

Jun 05, 2012 | 1987 Pontiac Firebird

1 Answer

On my 2006 F-150 everytime I go to restart the engine radio resets and tach acts like it is stuck. Any idea's?


Check the connections on your battery terminals. A bad or loose connection will make your radio reset each time you start your vehicle. Other places you might look are hot wires leading to your fuse box, if you have an after-marked radio installed. In some situations, the hot lead going to your fuse box may be shorting out. If your tach is stuck, you have crossed wires under your dash, also a case that will happen if you have an after-market stereo installed.

Nov 15, 2010 | 2006 Ford F-150

1 Answer

How to remove stereo unit on 2004 f 150


the ford units have two holes on either side of the stereo and require 2 special pullers that can be obtained from the dealer. insert and pull. cheers

Jan 21, 2010 | 2004 Ford F150

1 Answer

2002 celica gts stereo has power but there is no sound


does the amp have power

is the stereo original ?

after market stereos are notorious for blowing factory amp then the internal amp in the deck

Jan 05, 2010 | 2004 Toyota Celica

1 Answer

Wiring after market stereo to factory wiring equipt with factory amp


you have to get the cable that conects your factory deck harness to the aftermarket deck, and that will allow you to use your factory speakers and amp, the wire harness is availiable at canadian tire or any stereo shop

May 05, 2009 | 2001 Pontiac Grand Am SE

1 Answer

2004 Ford Explorer radio


According to my schematic of your BASE system...
There is a 20A fuse for constant power...

AND

a 5A fuse for ignition power

AND a delay relay.

CLICK HERE to see the schematic.

All the fuses are located in the same fuse panel.

If you need more help - let ma know.

Thanks for using FixYa - a FixYa rating is appreciated for answering your FREE question.

Apr 17, 2009 | 2004 Ford Explorer

2 Answers

Problem with aftermarket stereo wireing


seriously the answer is very easy the yellow wire from the deck is constant power weather the truck is on or off it should always be hot. The red is the ignition wire which simply turns the deck on when the ignition key is turned on and the black is ground besides the actual speaker wires these are the only wires that need to be connected. if they are properly connect there is a good chance that there is a short somewhere

Mar 16, 2009 | 2006 Ford F-150

Not finding what you are looking for?
2004 Ford F150 Logo

Related Topics:

69 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

fordexpert

Level 3 Expert

5495 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...