How do you bleed the brakes for a 1997 mercury tracer?

dot 3 brake fluid

Replacement of oxygen sensors on a 1997 Mercury Tracer LS. Sell the Tracer and buy a Ford Focus, or 2010 Chevy Cobalt, or a new Chevy Cruze, or a Ford Fiesta. This solution is best if your Tracer has over 130,000 miles on it.

Make sure resevoir is full then start from the farthest from the master cylinder n work toward master and pump 3 times while someone opens the bleeder do not compress all the way to the floor tho continue around vehicle til there's no air in lines

Without being hurtful in any way

If you have to ask a general question
about brakes,that implies you have never
done brake work,I would suggest you don't

Use the repair shop and watch as they perform the job

take a pair of channel locks and turn the caliper piston clockwise while pushing it in a little bit at a time until it is in all the way. Some pins on the back of them so they sit in the caliper right. make sure to line those pins up. They do make a tool to turn the piston but I have done it this way before. Hope this helps leave comment.

It's under the hood, driver side, rear engine area, passenger side of brake booster, mounted on firewall, about half way down.

About $250.00 installed

replace the brake / shifter release switch under the column

you need to turn the adjuster
there is a little hole on the bottom of your backen plate to ajust the brakes up

I have the exact same problem with a Ford Escort. Anybody have an answer?