Question about 1994 Dodge Viper

2 Answers

Security? 1994 Viper battery went dead, which in turn makes the security system not allow it to start now with new battery. Is there a way to unhook alarm(security) or what is the trick. Worthless car as is..............

Posted by on

  • mjoy3108 Feb 04, 2009

    battery went dead on my 1994 dodge viper i charged it the alarm wont let me disarm it any ideas

  • Anonymous Mar 12, 2014

    The car won't start because the alarm was tampered with and not the security light will not go off and will not allow to be start the car with either keys



2 Answers

  • Level 1:

    An expert who has achieved level 1.


    An expert whose answer got voted for 20 times.


    An expert that has over 10 points.


    An expert whose answer got voted for 2 times.

  • Contributor
  • 7 Answers

Call the dealer for codes??? Oh please.

Disconnect the battery and reconnect it. Press the key fob and this should reset the security system.

Note: This is for a Gen I - Gen II and later is different.

Posted on Jul 19, 2008

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert that has over 500 points.

  • Expert
  • 284 Answers

You are going to have to call the car dealer for codes. its mostly all intergrated.

Posted on Jun 18, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

2008 toyota tundra 5.7L Truck's electrical system drained drastically. I replaced the battery, and after one start, it went dead again with in 10 minutes. show very little light. on dash board. Voltage of...

is the alternator charging ok is the first thing to check when you've got the engine running if thats ok i'd disconnect the Viper remote as from your description it could be draining the battery/not working properly put back to original factory spec and run like that for a while then you'll know if its the Viper or not keep me updated

May 04, 2014 | Cars & Trucks

1 Answer

I own a 01 Pt cruiser it has new motor new battery and new fuil pump its a keyless remote and keyless remote start with a viper alarm its been running and starting just fine I get home turn it off 20 min...

I recently had a same situation with a customer of mine and it turn oit to be a problem with the security system wiring. I would look there for a problem.

Sep 03, 2017 | Cars & Trucks

2 Answers

1994 Dodge viper security system

probley need to be reprogramed from the dealer lost key code in memory

Nov 08, 2013 | Dodge Viper Cars & Trucks

1 Answer

Won't turn over

is the purple wire at the starter getting a 12 volt signal with the key held in the crank position? is the engine ground cable cklean and tight? are the starter cables ok?

Aug 09, 2009 | 1994 Chevrolet C1500

1 Answer

1994 Dodge Viper will not start after storage and battery drain.

With the battery charger connected or a jumper battery simply click the alarm key fob on and then off. This will reset the alarm and the car should start...had mine towed to find this out

Apr 07, 2009 | 1994 Dodge Viper

1 Answer

97 Jaguar XJ6 No Start (good battery- no click)

when you battery goes dead, the security system locks the car. When you charge the bathery, use the key to lock the door and hold until the alarm activates. open your door and you can now start your

Mar 16, 2009 | 1997 Jaguar XJ6

1 Answer

Flashing running lights

it sounds like you have a security system that has had the sound disconnected. now if this is the case you need to find out if it is a factory or aftermarket. usually if it is a aftermarket system the box for it should be on the driver side under the dash. now don't go just cutting wires these systems tap into some of the major wire harness. get info off the box and contact the manufacturer for a wire schematic. this will allow you to cut and splice the correct wires. good luck

Feb 05, 2009 | 1995 Mitsubishi Mirage

2 Answers

Security System

I have a 5.2L V8 Jeep Grand Cherokee and i know to reset my security system i actually have to go around to the passenger side door and lock and then unlock it again. Seems fairly odd but that's how i was told it was reset. Give it a go and lemme know!

Oct 21, 2008 | 1994 Jeep Grand Cherokee

Not finding what you are looking for?
1994 Dodge Viper Logo

732 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts


Level 3 Expert

77169 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides