Question about 1997 Jeep Grand Cherokee

1 Answer

How do you replace blower motor resistors in a 1997 jeep grand cherokee

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,206 Answers

Very easy first you go buy one then look under the glove box near the blower motor you will find it usually two or three screws holding it, and a large plug connects to it. very simple to do.because you have it in hand it makes it easier to compare to what you see under there.good luck

Posted on Nov 14, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Replace blower motor resistor block on 1997 jeep grand cherokee


how to?
who can
is this a DIY question?
how hard.
how many steps
how long does it take?
this is covered in the FSM (factory service manual)
and at alldata.com (under Hvac)
or here
see ZJ here, RTM read the manual
its all there.
see the facts here.
http://www.loctiteproducts.com/tds/T_LKR_RED_tds.pdf

Jan 28, 2014 | 1997 Jeep Grand Cherokee

1 Answer

The fan will not come on to blow the heat or anything on my 1997 jeep grand cherokee. PLEASE HELP


Go under the dash on the passengers side.The blower motor and blower motor resistor are located under there.With the switch on just tap the blower slightly and if it goes on then replace the blower motor.If not then follow the wires that go to the resistor and check the resistor.They like to heat up and melt the connectors.So you might have to replace the resistor and the connectors which you can get from the dealership parts department.Make sure you have checked the fuses first.let me know if you have any questions.Good luck.

Dec 08, 2010 | 1997 Jeep Grand Cherokee

1 Answer

My 2005 Jeep Grand Cherokee heater only blows air on the high setting, I ohm tested the HVAC fuse under the hood and only get response on 1 leg.


when the blower motor resistor fails the blower switch defaults to the high position. autozone.com has a great tutorial on how to replace the blower motor resistor.

realfixesrealfast.com has a segment on blower motor resistors.

Nov 13, 2010 | 2005 Jeep Grand Cherokee

1 Answer

My blower motor now only runs in the "high" postion. I suspect this is just the switch since the blower does run. 2001 Jeep Grand Cherokee (198,000)


no that is your blower motor resistor. find it in or near the heater box by your blower motor should have 3 wires going to it remove the connector remove the resistor and replace it, that should solve your problem

Aug 05, 2010 | 2001 Jeep Grand Cherokee

1 Answer

Power to blower motor but no grond at the motor


replace the blower motor resistor, this will solve your problem, the resistor is located on heater box, its screwed into box near blower motor, wires from blower go to this resistor, unplug the connector, remove screws and slide out of box, hope this is helpful.

Dec 26, 2009 | 1997 Jeep Grand Cherokee

1 Answer

Blower motor resistor replacement


how do the wires go on a 2002 jeep grand cherokee blower motor resister.

Oct 18, 2009 | 2002 Jeep Grand Cherokee

1 Answer

Where is the blower motor resistor located in the 1997 jeep grand cherokee larado?


IT IS UNDER THE GLOVE BOX NEXT TO THE BLOWER MOTOR.IT WILL HAVE 2 DIFFERENT ELECTRICAL CONNECTOR

May 07, 2009 | 1997 Jeep Grand Cherokee

1 Answer

Ac blower won't work. Resistor has been replaced 3 times. I think it is the problem now. Is it easy to replace? Where is it?


Blower motor resistors are found on the pasenger side ducts near the blower motor. It should have three wires going to it.

Apr 22, 2009 | 2000 Jeep Grand Cherokee

2 Answers

Heat


we had same problem .ran new wire to blower . old wire broke down ck wires with ohm meter.

Dec 19, 2008 | 1997 Jeep Grand Cherokee

Not finding what you are looking for?
1997 Jeep Grand Cherokee Logo

232 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...