Question about 1996 Ford Explorer

1 Answer

1995 Ford econoline conversion van. (It's an Anaheim Van. They were in Houston, but went out of business.) The rear fan system doesn't blow out the top any more - only out at the floor. I've taken apart the ducting enough to see that it isn't blocked. What should I do?

Posted by on

  • 848scott Nov 14, 2010

    No way anyone has replaced the blower motor or changed the wiring to the motor.
    And I don't think that the wires could have been reversed. Maybe it's some kind of fuse that's blown? The weird thing is that the rear ac still gets cool, but neither it nor the vent setting (on dashboard slider switch) gets any air to come out the top vents - in both cases warm air (maybe it's the warm air that comes off of the AC - if it's making cold air, it has to dump heat somewhere) comes out of the one floor vent. The floor setting also blows air out the floor vent, so it's not like the floor vs. upper vent circuits were switched.

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,168 Answers

Hello Scott.

I can't help but wonder if someone has replaced the blower motor or changed the wiring to the motor.
Perhaps the wires have been reversed? In a DC wired motor this can happen.
Hope your repair goes well.
Thank you for using FixYa.

KL

Posted on Nov 14, 2010

  • FUBAR Nov 14, 2010

    I have gone through the All-data service manual and it doesn't show me the rear heater case or the operation of it.
    I did find however a vacuum diagram.
    It shows a vacuum line that is hooked up to the front heater control and it may be the source of the problem. If this vacuum hose is broken or pinched it may not allow the proper movement of the doors in the rear heater/AC case.
    Did you come across any vacuum lines in your search?

  • FUBAR Nov 14, 2010

    O yes, the diagram indicated the line is blue.

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1989 ford e150 conversion van cranks but will not start


do you have spark and fuel pressure ? will it start on starting fluid sprayed into the intake ?

Jan 29, 2014 | 1995 Ford Econoline

1 Answer

1998 Ford Econoline Van E-150 Front A/C blows cold rear A/C blows warm?


Generally you would need to check the level of freon in the system, and probably the expansion valve in the rear unit. You should have one hot and one cold ac line going to each evaporator.

Aug 22, 2012 | Ford Cars & Trucks

1 Answer

Where is the fuse box on this van. It is a conversion van.


What type of conversion? if the front of the van remains Ford the fuse box is located under a dash trim panel to the left of the steering wheel, in front of your knee, there are two plastic quick releases under the panel, twist them counter clockwise to remove and pull down

Nov 17, 2010 | 1993 Ford Econoline

1 Answer

Ford econoline van leaking unknown fluid HELP!!!!!!


check your enging fluids could be brake fluid or power steering fluid. the wheelechair lift is most likley electric and does not require fluid of any kind

Feb 05, 2010 | 2000 Dodge Caravan

1 Answer

1993 ford e-150 conversion van heat and a/c


Selection lever does not move to AC vent or floor vent only to the defrost. AC compressor does not kick in when AC is selected.
Vacuum level is at 18 instead of 23.
Any suggestions.

Oct 19, 2009 | 1993 Ford Econoline

1 Answer

Where is the speed sensor on a 1995 Ford econoline van


the sensor is located on the driver side of the transmission case

Jun 19, 2009 | 1995 Ford Econoline

1 Answer

1995 ford econoline van speedo/trans


It is either the speed sensor, the wireing in between ot the speedometer module it self. The sensor sends pulse train signal to the speedometer module and there it drives the speedometer and is divided in frequency by about 7 and feed to the computer and the cruise control. When the signal drops the Engine management computer thinks the speed is real slow and raises the transmission pressure.

In the one I had it was a cold solder jooint on the bacjk of the speedometer module itself but this was the divided output and the speedometer itself still worked. The easyest part would be the sensor that mounts on the rear axile I believe and should cost less than 30.00 dollars. If not that thebn it's the wiring or the speedometer module electronics..


Mar 04, 2009 | 1995 Ford Econoline

Not finding what you are looking for?
1996 Ford Explorer Logo

Related Topics:

95 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

fordexpert

Level 3 Expert

5495 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...