Question about 2000 Acura TL
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Have you checkd your fuses & also there is a small plastic/rubber piece somewhere on the driverside door, either on the actual door or on the car frame itself that once u close the door, that peice tells the alarm that its ok to lock and arm. (i dunno if u noticed but u can manually lock ur car w/ ur keys in the ignition, running, only if driver door is closed, from any other door usung the lock button, but not if the driver door is open) If that peice n ur door is worn, eventually it will break causing u to have to use ur key to unlock ur car. BUT, doing that will not disarm the alarm only unlock ur car & it will sound every time & not stop until u pull the fuse to the horn & lights. i had to bring mine to a dealership to get it fixd bc I couldnt figure it out. Paid $300 for a $25 piece of plastic I could have changed myself. Hope this helps..... good luck.
Posted on Aug 25, 2009
Testimonial: "Thanks for info, don't know what the problem was but it went away..."
dont you have the alarm key fob? if so that will reset it. just press unlock. If you dont an dits not a OEM Acura alarm you will need to find who makes it and get a new key fob, or have a shop that does alarms to disconnect it.
Posted on Oct 06, 2009
Testimonial: "thank you so much. Like most solutions, it was simple and obvious once you pointed it out. I really do appreciate the help!"
try unplugging your hood latch switch ...if you open you bonnet of your car you will see the latch .locate the wire comeing from your latch and follow it until you get to the connector. un plug the connector. if the alarm dosent sound any more that is your problem.
Posted on Mar 23, 2010
Below are the proper steps to removing your vehicle's fuel tank..
Disconnect the negative battery cable.
Relieve the fuel pressure
Remove the rear seat cushion.
Remove the plastic grommet from the floor pan.
Detach the fuel pump electrical harness.
Disconnect the fuel lines from the fuel pump by compressing the tabs on both sides of each nylon push connect fitting and easing the fuel line off of the fuel pump.
Raise and safely support the vehicle securely on jackstands.
Remove the muffler mount.
Remove the heat shields.
Remove the fuel tank cover.
Remove the drain plug and drain the gasoline into a approved container.
Disconnect the fuel lines and remove the fuel filter and base.
Loosen the fuel tank filler pipe clamp at the fuel tank.
Support the fuel tank using a hydraulic jack and a block of wood or other suitable device.
Remove the two fuel tank support strap bolts and position the straps out of the way.
Partially lower the fuel tank to access the fuel tank filler pipe vent tube and disconnect the vent tube and filler pipe from the tank.
Disconnect the fuel vapor tube from the tank.
Lower the tank from the vehicle.
Installation is the reverse of the removal procedure.
Posted on Apr 23, 2010
Tips for a great answer:
Sep 06, 2016 | 2006 Acura TL
Aug 01, 2015 | Cars & Trucks
May 22, 2015 | 2005 Acura TL
Apr 25, 2012 | 2006 Acura TL
Dec 24, 2011 | Acura Legend Cars & Trucks
Apr 14, 2011 | 2004 Acura TL
Sep 26, 2010 | 2000 Volvo S80
Sep 15, 2010 | Mercury Sable Cars & Trucks
May 25, 2009 | 1996 Acura TL Series
150 people viewed this question
Usually answered in minutes!