Question about 1997 Honda Accord

1 Answer

My stop lights wont go off. Stay on all the tima.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 381 Answers

There is a button above your brake pedel that probably isn't being pushed in all the way by the brake pedel to shut them off. Try pulling up on the brake pedel and have someone watch to see if they go off when you do that. If so the button for the brake pedel needs to be adjusted so it shut them off when the pedel is not pushed.

Posted on Nov 13, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Kia hazard lights stay lashing even when the vehicle is not running and wont stop flashing


Has the HAZARD switch been activated? If the switch is off then there may be a problem with the switch or the flasher module.

Feb 20, 2015 | 2014 Kia Sorento

1 Answer

Turn signal and Hazzards issue


Turn signal flasher. Replace with a heavy duty one.

Mar 20, 2014 | 2001 Jeep Cherokee

1 Answer

1996 jeep wont stay started and oil pressure gauge goes up and down


hot or cold engine , or both.?
the oil pressure will be in direct ratio to engine rpm. slow low, fast high
due to the oil pump connection to engine crankshaft.

stalls.: can be caused by 50 things, or just 4 in physics.
the EGR valve (if you have one, no engine stated)
can stick open and stall any engine, and in fact LOVES to. clean it.
1: list 12vdc to EFI. (spark and fuel brain) dash lights dim?
2: lost compression hot, ? compression tests.
3: lost spark, do spark tests. and timing, checks.
4: bad fueling, too much if floods, and misfires and stalls.
too little fuel, it starves and dies.

the 1 free test, is can you save the stall with a fast right foot.

we do the tests. avoiding those 50 guesses....
each tests are simple and the tools dirt cheap .

Jan 30, 2014 | Jeep Cars & Trucks

1 Answer

Come to stop truck wont idle it shutts off


That's a very high rpm for an idle! It should be between 700 to 9oo rpm. This truck needs a tune up, at least!

Jan 21, 2013 | 1997 Dodge Ram 1500 Club Cab

1 Answer

Stop lights wont stay on when i step on brake pedal on 2001 expedition


I had this same problem (brake lights won't come on when pushing on brake) I found that the brake light sending unit had come out of adjustment.Look under the dash by the brake pedal.There is a plastic threaded unit that needs to be pushed back towards the brake pedal lever.Careful not to push it to far or the brake lights will stay on. Hope this helps

Nov 12, 2012 | 2001 Ford Expedition

1 Answer

My car wont stay running when Im not on the accelartor when I get to low rpms it just cust off even if coasting to a stop at a light or turning a corner PLEASE HELP!!


SOUND LIKE FAULTY IDLE AIR CONTROL VALVE.VECHICLE IDLING TOO LOW WHICH WILL CAUSE STALL OUT AT STOP LIGHTS AND STOP SIGNS TURNING CORNERS.HAVE VECHICLE CODE SCANNED FOR FAULTY IDLE AIR CONTROL VALVE.

Dec 04, 2010 | 2001 Lincoln Continental

1 Answer

Day time running light and low beams stopped


I would say your light switch is either dirty or bad.
www.rockauto.com

Feb 04, 2010 | 2000 Chevrolet Impala

1 Answer

1983 Mercury Marquis wont stay started


this problem is caused by carbon holding the EGR (exhaust gas recirculation) valve open, it is a very comon complaint, fixed 100's for the issue at my dealer. You can buy a EGR valve carbon trap from the dealer to stop the problem.

Dec 14, 2009 | 1983 Mercury Marquis

1 Answer

Brakes lights stay on and air suspension stopped working?


those lights are on to let you know that there is a problem with the system.
if they are on their main options will be off, just like if your airbags light is on the airbags wont work if there is a crash, so take ur car to your mechanic and have it ckecked, there are lots of testing to be done on your car to determine what needs to be done

Jun 19, 2009 | 1995 Land Rover Range Rover

1 Answer

Why mybreak lights wont turn off when car stops 1994 honda accord


Your brake light switch is most likely bad. Under the dash there is a switch that when you push the brake pedal, a pin extends to complete the circuit. There should be a bracket with a rubber tab on it attached to the pedal lever itself. If the rubber tab is missing, it will also allow your brake lights to stay on.

Dec 25, 2008 | 1994 Honda Accord

Not finding what you are looking for?
1997 Honda Accord Logo

Related Topics:

114 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

76673 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...