Question about 2000 Nissan Quest

1 Answer

Turn signal problems, flasher works bulbs are new i just dont get anything when i switch to either side

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Nissan Master
  • 4,369 Answers

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why are my blinkers working i changed the flasher and the switch on steering column i have a1987 nissan v-6 se 4x4 trvuck?


See troubleshooting basic turn signal and flasher problems

www.procarcare.com/includes/content/.../ch14/14TSTurnSignals.html
Most problems in the turn signal or flasher systems can be reduced to ... Occasionally, problems in the turn signals are traced to the switch in the steering column, which ... One turn signal light on one side doesn't work Check and/or replace bulb. ... Often the filaments have been reversed In systems combining stoplights with ...

where is the flasher(turn signal relay)located ... - CarGurus

www.cargurus.com > Questions > Chevrolet > Cavalier

CarGurusApr 17, 2007 - Emg. flashers work but L/h and R/h signals dont. ... How do I get that cover. off my steering wheel? ... How to change Flasher Fuse 4 answers.

Turn Signal Switch Replacement - YourMechanic


Dec 15, 2015 | Nissan Cars & Trucks

2 Answers

Brake light trouble right side brake light will not come on but both flashers work also turn signals work older ford truck what could the problem


I have to think the problem is inside the turn signal switch, a poor internal connection. You know the brake signal first goes through the turn switch before it goes to the bulbs. That is why the brake lights and rear turn signal lights share the same filament in the bulb, and the same wire going to those lights. The only difference is the turning side light is affected by the turn signal flasher, causing blinking, while the other side- the non turning side-does not go through the flasher relay, but straight to the bulb from the turn signal switch. Change your turn signal switch and I believe you will solve the problem. Let me know, okay?

Sep 16, 2015 | Ford Cars & Trucks

1 Answer

1995 Chevy Caprice Wagon, right side signals and brake lights dont work


change the bulb if still out then check and test socket/ground wiring/wire harness for damage

Apr 28, 2017 | Cars & Trucks

1 Answer

My saturn signal light work sometime than go off if it the flasher please tell me there it is in my car


IF TURN SIGNAL LIGHT DONT WORK SOME TIMES.CHECK FOR BLOWED OR LOOSE FUSE.CHECK TURN SIGNAL BULBS AND CHECK BULB SOCKETS FOR CORROSION.CHECK TURN SIGNAL FOR BAD GROUND.USE JUMPER WIRE BETWEEN GROUND SIDE OF THE TURN SIGNAL BULBS AND A GOOD CHASIS GROUND.IF ALL IS GOOD TURN SIGNAL SWITCH IS BAD OR FLASHERS GOING BAD.TURN SIGNAL FLASHER LOCATED ON CENTER CONSOLE SIDE PANEL GRASP THE FLASHER UNIT AND DETACH IT FROM THE FUSE BOX.IF YOU HAVE EARLY MODEL VECHICLE FLASHER UNIT LOCATED AT THE FRONT OF THE FUSE BLOCK.

Aug 23, 2011 | Saturn LS Cars & Trucks

1 Answer

Turn signals dont work most of the time. i cant find the flasher module


your Flasher/turn signal relay are malfunction,it suppose to have a regular clicking sound everytime you use the flasher/turn signal switch, you need to replace with a new one,but you need first to check your bulbs, the RELAY located on the left driver side under the dashboard, or turn your flasher so that you can here the clicking sound....

Feb 05, 2011 | 2002 Jeep Grand Cherokee

1 Answer

New bulbs, turning signals do not work...


Check the flasher located in the fuse/relay panel. Also check for a blown fuse as well. Remember this if the 4 way flashers are not working the turn signals will not either. To test the flasher before you remove it, turn the turn signal switch to either side and with your finger touch the top of flasher. If you feel a click from flasher then it's good and you will have another problem in the wiring. Hope this will help you.

May 15, 2010 | Cars & Trucks

2 Answers

Turn signals dont work bulbs/fuses are good.


check to see if the emergency flashers work if they do its its either a wiring problem, bulb, or socket the bulb fits in. if it does not work than the flasher is the problem. it is located underdash on driver side in the kick panel( to left of the brake pedal) it is a blue or grey sguare relay looking plug. if it is factory flasher it will say flasher with the part # on it. it should also say toyota on it. good luck

Jul 09, 2009 | 2000 Toyota Camry

1 Answer

Turn signals dont work headlights dont dim heater fan doesnt work


Did all these problems happen all at one time?? If so you may have a bad body ground. Try running a electrical wire from the (-) negative side of the battery to the body and see if this works. Be sure this wire is to a place with no paint as low voltage electricity will not flow through paint.
A). If not try replacing the turn signal flasher for the turn signal problem. This is usually the culprit and it's easiest and cheapest to replace. The turn signal flasher will be found under the driver side dash next to the hazard flasher. Turn the hazard flasher one to locate it. If you want try swapping the turn signal flasher with the hazard flasher to see if this fixes it. They are the same style flasher.
If this doesn't work you may a faulty turn signal switch or some wiring issues.
B). It could as simple as the head lights bulbs need to be replaced, it's rare but I have seen when both bulbs blew at or near the same time. If your able check the voltage at the head sockets.
C). Could be a bad blower motor or switch. I'm not sure if these models have a resistor block or not. The resister block controls the electrical current going to blower motor which controls the speed of the blower fan.

Jan 19, 2009 | 1992 Dodge Caravan

3 Answers

Turning signals dont blink


Problem is the Turn Signal "FLASHER" unit, 1.Turn on Emergency FLASHERS 2. Go under Dash while they are on Listen -for Clicking sound then feel for it 3. Should Be a Silver Round Unit About as Big IN ROUND as Half dollar coin 4. ok now Look Around for the SAME EXACT Thing Clipped onto Something Under dash At Driver side Usually Between Steering wheel and Center HUMP in Floor, 5. once you find it Take OUT the first One you Found Emergency FLASHER) and 6. Put it In Place of Turn Signal Flasher, 7. Turn off Emergency Flashers- Turn Key in "ON" Position but don't start then Try Turn Signals. Yaaaa !!!! they work ?? LoL hopefully this Does the trick, if they work Buy new one and Replace Always Use NEW For TURN Signals as they are used Much More than Emergency Flashers. Hope this is Good Instructions For you and Helps you Solve The Problem, Please DONT Forget to RATE ME Thank you Rejakwilson@aol.com

Jan 18, 2009 | 1986 Oldsmobile Cutlass Supreme

3 Answers

Flasher or turn signal switch


When you select left or right do any of the bulbs come on? If you select left check front and back left side if one of the bulbs did not come on the flasher will not work. Change the bulb that is out. Same with the right. If the fuse for the turn signal is good (check fuse or replace do not use visual, some appear to be good but are not).
The emergency flasher is different from the turn signal flasher. Look at manual for location of turn signal flasher. If you manually lift and lower turn signal control you may hear a clicking under the dash to locate the flasher.

Jan 02, 2009 | 1995 Chevrolet Caprice Classic

Not finding what you are looking for?
2000 Nissan Quest Logo

126 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...