Question about 2004 Mazda 6

Open Question

My mazda 6 won't start it backfires, what type of fuel should i put in it?

Posted by on

Ad

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 9 Answers

SOURCE: mazda 6 diesel wont start

Have you run the car without fuel? There must not be any air in the fuel line... Blead the fuel line of air and try to start it. There should be bleader screws under the hood....

Posted on Jun 13, 2009

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why do my Mazda mx 6 cuts right off after starting like it's not getting any gas just put new fuel pump


sounds like you might have a vapor lock issue. Too much typing to explain how to troubleshoot but you will find lots of info Googling the issue. also make sure you're fuel filter isn't clogged.

May 06, 2015 | Mazda Cars & Trucks

1 Answer

My Mazda lantis does not start .I put some gasoline in the brake booster line and it will start and rev as normal but when I leave it for about 2 hours it will not start someone please tell me why?


if you are putting fuel in the brake booster vacuum line then the problem is that there is no fuel being supplied to the injectors or the injectors are not being activated by the ECM
Get the fault codes read before sometjing like a backfire blows the booster off the car

Apr 08, 2015 | Mazda Cars & Trucks

1 Answer

My 2003 mazda 6 2.3 is hard to start and backfires and when it does start it want idle u have to keep patting the gas then all at once it will smooth out and Rev the engine up then it dies someone s


you stated that you just had an intake manifold gasket place more than likely it was not placed correctly it may be home bad word but not sealed properly

Jan 13, 2015 | Mazda Cars & Trucks

2 Answers

2002 Ford Explorer ran out of gas put gas in and won't restart. replaced fuel pump and fuel filter still won't start. Cranks but won't start


Most Fords have a fuel reset button. When you ran out of gas you tripped the circuit. Most of the time the button will be on the passenger side by the kick panel. The exact location should be in your owners manual or your local library or auto parts store will have a copy of one for your specific vehicle.

May 08, 2012 | 2000 Cadillac Seville

1 Answer

Had a question bout my mazda rx8 I was driving it one night it was running fine the next day went out and it won't turn over it takes awhile bit it finally starts and idles real rough and you give it...


Too many possibilities

Won't turn over is one problem -battery,cables,grounds,
starter,solenoid,etc

Idles rough-- vacuum leaks,spark plugs never replaced,
egr valve etc

Worn O2 Sensors
Dirty MAF Sensor
Old Fuel Filter

You have to go into a lot of technical detail & history
on your vehicle, for us to even guess.

May 23, 2011 | 2005 Mazda RX-8

1 Answer

Mazda protege backfires when try to start it


SOUNDS like you have put 1 of the plug wires on the wrong way around OR you have got a valve sticking or burnt out so go back and check the firing order
on a 4 cylinder its 1342 and on a 6 clinder its 153652
RECHECK AND LET ME KNOW HOW YOU GET ON.
Ron

Oct 11, 2009 | 1992 Mazda Protege

1 Answer

First is there a charge for this service advise?


It sounds like an ignition problem. I would probably replace the plugs and plug wires first (I suppose they need replacment anyway). If that does not help, check your coil packs (the black boxes that the plug wires go into on the back of the engine - I think the 1990 had direct ignition system [DIS]), if not, replace the distributor cap and rotor button. Also, check the ignition timing.

Aug 07, 2009 | 1999 Mazda MX-5 Miata

1 Answer

Running rough


most likelly when your fuel pump gets hot it looses the pressure going to engine replace fuel filter and if this dont help then have the fuel pressure test done when problem is present
and if not good replace fuel pump

Jun 01, 2008 | 1993 Mazda MX-6

Not finding what you are looking for?
2004 Mazda 6 Logo

Related Topics:

64 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

76682 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...