Question about 1994 Nissan Pickup

1 Answer

I have a 94 Nissan pickup, I don't know if it has daytime running lights (DRL) or not however the issue is that the driver side head lamp turns on when start the engine. The passenger side does not. The single light is actually a high beam and not a low-intensity DRL. I think the last owner replaced the light with one that fit but was made for another model. Any thoughts?

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I have a 94 nissan pickup, the right side light beam works low and high but the left side dosnt work.... my friend thinks its aground problem how ever there appears to be ablack box looking like a day time night time module located at the left fender inside ...behind the battery fastened by two screws holding it to the body....

Posted on Jan 25, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2000 chevy e3500 drl location


DRL location ? Module ? Lights ?
The operation of the daytime running lamps is controlled by the daytime running lamps control module. The module is powered by CKT 39 (PNK) from the GAUGES fuse, and it is grounded through CKT 150 (BLK). The module turns on the daytime running lamps under the following conditions:
Daytime Running Lamp (DRL) Control Module
Under the left side of the IP, taped on the IP harness

Jul 03, 2017 | Chevrolet Cars & Trucks

2 Answers

Can anyone tell me where the drl module is located on a 2000 Chevy Blazer


Behind the lower kick panel on the passenger's side good luck colin

Jun 24, 2017 | Cars & Trucks

1 Answer

2003 Chev Malibu. Radio inop with key in on position, auto systems not working, I.e. daytime running lamps, auto lock and drivers unlock, fuel and temp gauges not working.


Have you had vehicle check for DTC'S diagnostic trouble codes . Check fuse's an relays , find wiring diagrams to see what controls these systems ?
Radio/Battery fuse , fuse G 10 amp located in the right instrument panel fuse box . Do you know where this ?
Fuse Block - Right IP - On the right side of the instrument panel
An there is one on the other end of the instrument panel ,driver side .
Fuse Block - Left IP- On the left side of the instrument panel The fuel an temp . gauges not working is probably the step motors inside instrument cluster . GM had problem with this 03 to 06 .
How to repair GM Instrument Cluster Speedometer Gauge Stepper

Daytime Running Lamps (DRL)
The ambient light sensor is a light sensitive transistor that varies its voltage signal to the body control module (BCM) in response to changes to the outside (ambient) light level. When the BCM receives this signal it will either turn on the daytime running lights (DRL) or the headlights. Any function or condition that turns on the headlights will cancel the daytime running lamps operation. With the headlight switch in the OFF position, the headlights will either be turned ON or OFF, after an approximate 30 second delay depending on whether daylight or low light conditions are sensed. The HTR A/C IGN fuse in the underhood junction block supplies ignition positive voltage to the daytime running lamp (DRL) relay coil circuit. The DRL relay switch contacts are connected to the low beam circuit. When the headlamp switch is placed in the OFF position, the BCM will either turn on or off the daytime running lamps, depending on whether daylight or low light conditions are sensed. The BCM energizes the DRL relay, closing the switch contacts and grounding the low beam circuit. Ground is provided at G101. The DRL illuminate the low beam headlights at a reduced intensity. The DRL will operate when the ignition switch is in the ON position, the gear selector is not in the PARK position and the parking brake is released. When these conditions have been met and the ambient light sensor indicates daytime conditions, the DRL will illuminate.
DRL operation in Manual Transmission equipped vehicles will occur when the ignition switch is in the ON position, and the parking brake is released. - check fuse's an relay first.
Door Lock System Components
The power door lock system consists of the following components:
?€¢
Driver door lock switch


?€¢
Front Passenger door lock switch


?€¢
Body Control Module (BCM)


?€¢
Relays: Driver Door Unlock--if equipped, Door Unlock, and Door Lock


?€¢
Door Lock fuse 15A


May 25, 2016 | Cars & Trucks

2 Answers

How to turn off the daytime running lights on my 2005 chevy equinox


you have to change daytime running lights module.For now remove cable from battery +

Mar 19, 2016 | Cars & Trucks

1 Answer

I need clarification on 2003 Chev Malibu DRL problems:


That piece you think is a ceramic DRL module is a resistor , When in DRL mode voltage to the low beam headlamps circuit goes through that resistor dimming the headlamps from low beam to daytime running lamps . It sounds to me like you need a new resistor ,but without doing some electrical testing it could be a lot of things . The DRL relay in the under hood fuse box could have a problem , could be the BCM - body control module , the ambient light sensor etc... Here is how daytime running lamps work .
Daytime Running Lamps (DRL)
The ambient light sensor is a light sensitive transistor that varies its voltage signal to the body control module (BCM) in response to changes to the outside (ambient) light level. When the BCM receives this signal it will either turn on the daytime running lights (DRL) or the headlights. Any function or condition that turns on the headlights will cancel the daytime running lamps operation. With the headlight switch in the OFF position, the headlights will either be turned ON or OFF, after an approximate 30 second delay depending on whether daylight or low light conditions are sensed. The HTR A/C IGN fuse in the underhood junction block supplies ignition positive voltage to the daytime running lamp (DRL) relay coil circuit. The DRL relay switch contacts are connected to the low beam circuit. When the headlamp switch is placed in the OFF position, the BCM will either turn on or off the daytime running lamps, depending on whether daylight or low light conditions are sensed. The BCM energizes the DRL relay, closing the switch contacts and grounding the low beam circuit. Ground is provided at G101. The DRL illuminate the low beam headlights at a reduced intensity. The DRL will operate when the ignition switch is in the ON position, the gear selector is not in the PARK position and the parking brake is released. When these conditions have been met and the ambient light sensor indicates daytime conditions, the DRL will illuminate.

Feb 25, 2016 | Cars & Trucks

1 Answer

Where is the fuse located for the daytime running lights on a 2005 Chev Siveraado?


It is located in the underhood fuse/relay box , marked DRL 10 amp fuse ! Also if that is good check the DRL relay in the same fuse/relay box .Your light sensor could also be bad .
The daytime running lamps (DRL) will operate when the ignition switch is in the RUN position, for automatic transmissions (A/T), the gear selector is not in the PARK position, the headlamp switch is in the AUTO position, and for manual transmissions (M/T), the park brake is released. When these conditions have been met and the ambient light sensor indicates daytime conditions, the DRL will illuminate. The ambient light sensor is a light sensitive transistor that varies its voltage signal to the body control module (BCM) in response to changes to the outside (ambient) light level. When the BCM receives this signal it will either turn on the DRL or the headlamps for auto headlamp operation. Any function or condition that turns on the headlights will cancel the daytime running lamps operation. The DRL can be manually turned OFF by depressing the AHL/DRL switch in the headlamp switch
Do you know that on inside of fuse box lid it shows what fuse is what .

Feb 01, 2016 | 2005 Chevrolet Silverado

2 Answers

Daytime running light module location 2001 impala


The daytime running lamps in your 2001 Chevrolet Impala are controlled by the Body Control Module (BCM) Here is a description of how the system works:

The ambient light sensor is a light-sensitive transistor that varies its voltage signal to the Body Control Module (BCM) in response to changes in the outside (ambient) light level. When the BCM receives this signal, the BCM turns ON either the DRL or the headlamp relay for auto headlamp operation. Any function or condition that turns ON the headlamps will cancel the DRL operation.
Thirty seconds after you start the ignition with the headlamp switch set in the OFF position, the DRL will perform one of two actions:

Illuminate the high beam headlights at a reduced intensity in daylight conditions
Illuminate the low beam headlights in low light conditions
The DRL/EXT lamps fuse in the top of the engine fuse block supplies battery positive voltage to both the DRL switch contacts and to the DRL relay coil. When the BCM energizes the DRL relay coil, current flows through the right high beam lamp, to the left hand high beam lamp, to the energized DRL relay switch contacts, to ground G101.
The high beam headlamps are now in series, and split the voltage so that the headlamps illuminate at halt intensity. The DRL operates when the ignition switch is in the RUN position, and the parking brake is not set or the transmission is not in park. When these conditions have been met and the ambient light sensor indicates daytime conditions, the DRL will illuminate.

Oct 10, 2011 | 2001 Chevrolet Impala

2 Answers

Daytime running lights won't shut off on 2001 grand am


check the drl 9daytime running lights0 relay under the hood. I could be stuck in the on position.

May 29, 2011 | Pontiac Grand Am Cars & Trucks

1 Answer

I have low beam but no high beam. relay on new harness is good but it connects to the old harness. i put the new harnes on so i could have high beam on drivers side it worked for a while but stopped. most...


What relay's ?
The instrument cluster controls the headlamp systems that include daytime running lamps (DRL). The system allows the headlamps to operate at a reduced intensity when all of the following conditions apply:
• The engine is running.
• The transaxle is not in the PARK position.
• The normal headlamps are not on.
The instrument cluster turns the DRL system on by grounding CKT 592, thereby energizing the DRL relay. This action allows a reduced voltage of 6 volts to flow across the headlamps. If the vehicle has the optional fog lamps, the fog lamp relay will also be energized. The park lamps will turn on and the fog lamps will operate normally. When the headlamp switch is turned to the ON position, the instrument cluster allows normal headlamp operation.
The instrument cluster also has an input from the park brake. If the park brake is in the ON position, the DRL will remain disabled until the park brake is placed in the OFF position. On vehicles with an automatic transaxle, the instrument cluster will disable the DRL until the transaxle has been taken out of the PARK position.

Headlamps Inoperative - High Beams
Step
Action
Value(s)
Yes
No
1
Did you perform the Daytime Running Lamps (DRL) System Check?
--
YES - Go to Step 2
NO - Go to Daytime Running Lights (DRL) System Check
2
Disconnect the turn/hazard headlamp switch connector C1.
Connect the fused jumper between terminal B of the turn/hazard headlamp switch assembly harness connector C1 and ground.
Do the high beam headlamps operate?
--
YES - Go to Step 3
NO - Go to Step 4
3
Replace the turn/hazard headlamp switch assembly.
YES - Did you complete the repair?
--
NO - Go to Daytime Running Lights (DRL) System Check
--
4
Repair the open in CKT 1200 between the turn/hazard headlamp switch assembly. Refer to Wiring Repairs in Wiring Systems.
Did you complete the repair?
--
Go to Daytime Running Lights (DRL) System Check
--

Jul 01, 2017 | 1998 Chevrolet Cavalier

Not finding what you are looking for?
1994 Nissan Pickup Logo

364 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

76673 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...