Question about Chevrolet Blazer

1 Answer

I have a 2000 chevy blazer LS......when i take it on the highway for more than 10 - 15 minutes...then stop first time....first gear jerks...only when i get it on the highway and then get odd and back into stop and go traffic does this happen. Really could use some advice. Thank you!

Posted by on

  • jamesmelton1 Nov 14, 2010

    It has 156000....the transmission was rebuilt almost two years ago....i have checked the fluid and it looked fine....although i didnt smell but will. It hasnt had a flush and filter since the rebuild.



1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Master
  • 4,472 Answers

How many miles are on the vehicle? When was the last time it had a transmission flush and filter? That would be the first thing to look at. Smell the tranny fluid see the color and if it smells burnt at all.

Posted on Nov 13, 2010

  • Lee A.
    Lee A. Nov 14, 2010

    How many miles since the rebuild? it honestly sounds like something transmission related.
    thank you,



1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Somewhere down the line my 2000 Chevy blazer LS

Try locking and unlocking the driver side door with the key. Door lock should be connected to the factory "security" system.

Oct 12, 2014 | Cars & Trucks

1 Answer

Engine only stalls when in any gear also when floored engine cuts out at 3000+ rpms

it sounds like a crank sensor if the vehicle stalls in any gear or when cold its most likely a crank sensor. located near the bottom of the engine. there almost always behind the balancer pully for the crank shaft

Jan 11, 2014 | Cars & Trucks

1 Answer

Chevy blazer 4 wheel shifts

check your oil level may be low.

Dec 20, 2013 | Cars & Trucks

2 Answers

2002 chevy blazer jerking on the highway

take it and have the fault codes read first
it is unlikely that they will read the codes as they would rather guess at the problem and charge you when they get it wrong
indications are fuel pressure problem ( EVAP not venting the tank) or blocked cat converter
when you take it in just tell them the symptoms as completely as you can, keeping the fault codes to yourself and hear what their guesses are before sharing any information
If you say first , they will focus on that
unlikely to be a transmission problem from what you describe

Dec 27, 2017 | Cars & Trucks

1 Answer

Want to replace transmission filters on 2007 chevy uplander

My 07 uplander jerk hard into gear when I take off from a dead stop is it because my transmission is over filled

Jul 23, 2012 | 2007 Chevrolet Uplander LS Minivan

1 Answer

2000 chevy blazer passenger front wheel noise

driving in 4wd on hard surfaces produces what is known as torque wind up as the wheels cannot slip so the variations of distance going around corners , dips in the road etc place considerable strain on the transmission , transfer case , drive lines and diffs
that is why it is difficult to get out of 4wd unless you drive with 2 wheels on a grass verge to relieve that torque wind up
as for the noise check wheel bearings and the cv ("U") joint at that wheel as there appears a proble where the dog teeth in the hub are not engaging properly or are jumping out of engagement

Mar 26, 2017 | 2000 Chevrolet Blazer

2 Answers

My 2000 chevy impala shakes while driving.i let

It sounds like you might need to replace your motor mounts, or get a tier allignement done. The allignment you cannot do yourself but the motor mounts you can this requires you to place a jack under you engine and undoing the motor mounts then replace them and take away jack.

Jan 30, 2010 | 2000 Chevrolet Impala

1 Answer

Where do I find the gear ratio for the rear diffI I have a 2000 blazer ls 4 door 4x4

Lower down this page is a chart with RPO codes, which can potentially be found inside the glove box...
The codes pertain to the transfer case, the front differential, and the rear differential, so it may take a bit of snooping.

However, if you were merely looking for the driving-gear-ratios, here's a page containing that kind of information for a 2000 4wd ls blazer:

Nov 29, 2009 | 2000 Chevrolet Blazer

1 Answer

Dash Problems with my 2000 Chevy Blazer

Try checking the temperature sensor. I had alot of problems with my 2000 blazer, and found that a spark plug wire was arcing out the temp. sensor.

Oct 27, 2008 | 1999 Chevrolet Blazer

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

19 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

79077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides