Question about 2008 Scion Xd
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
I just did this procedure 5 mins ago on my 2007 RAV....some procedures state to do it from the ODO position but that will not work....use the procedure below.
Set odometer to Trip A
Turn the key off
press and hold the ODO button.
Turn key to ON
Continue holding button while the light goes through the series of the ----countdown and then flashes 0000. Release the button and turn key to OFF.
Posted on Jul 14, 2008
SOURCE: maintenance light
1. With your car OFF, place your key in the ignition and turn to "On". Do not start the car.
2. Find the odometer button and press until it reads the total odometer setting, (not the Trip A or Trip B setting).
3. Turn the key to OFF.
4. Place your finger back on the odometer button, press and hold. At the same time, turn the key back to "On".
5. Hold the odometer button in until the MAINT REQD light goes out...should take about 8-10 seconds.
Posted on Jan 05, 2009
Actually - I just tried the solution provided and IT WORKED just fine - set to odom, then key off, then press button, then turn on ign to on (but not starting the car) - all done. Perfect. Thnaks
Posted on Jun 09, 2009
Oil Change Reminder Lamp: Service and Repair
Engine Oil Replacement Reminder Light
This light acts as a reminder to replace the engine oil.
This light will come on when the ignition key is turned to "ON" and will go off after about a few seconds.
When you drive for about 7200 km (4500 miles) after the engine oil replacement, this light illuminates for about 3 seconds and then flashes for about
12 seconds with the ignition key turned to the "ON" position. If you continue driving without replacing the engine oil, and if the distance driven
exceeds 8000 km(5000 miles), the light will come on. The light will remain on thereafter.
If the light is flashing, we recommend that you replace the engine oil at an early opportunity depending on the driving and road conditions. If the light
comes on, replace it as soon as possible.
Resetting the system
The system must be reset after the engine oil replacement. Reset the system by the following procedure:
1. Turn the ignition key to the "OFF" position with the odometer reading shown.
2. Turn the ignition key to the "ON" position while holding down the "TRIP METER" reset button.
Hold down the knob for atleast 5 seconds. The odometer indicates "000000" and the light goes off.
If the system fails to reset, the light will continue flashing.
Posted on Sep 30, 2009
Tips for a great answer:
Mar 09, 2015 | 2003 Honda Pilot
May 13, 2011 | 2008 Scion Xd
Sep 09, 2010 | 2007 Chevrolet TrailBlazer SS
Mar 08, 2010 | 2008 Scion Xd
Jul 22, 2009 | 2004 Mercury Mountaineer
Jun 02, 2009 | 2006 Toyota Camry
Aug 02, 2008 | 2008 Scion Xd
Jun 30, 2008 | 2007 Toyota Yaris
98 people viewed this question
Usually answered in minutes!