Question about 1995 Chevrolet Monte Carlo

1 Answer

Can the idle be changed on a 1995 monte carlo ls 3.1? i need to either lower it or raise it..its harmonics happening when in gear and foot on the brake...shakes a little...rattles steering wheel

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Master
  • 361 Answers

Change or clean the idle air control valve

Posted on Nov 13, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1995 Monte Carlo. Has a very loud rattling/whining noise when I give it gas,sometimes even while idleing


A damaged or defective HARMONIC BALANCER is a likely culprit, especially if you have recently had engine work done.

May 07, 2015 | 1995 Chevrolet Monte Carlo

1 Answer

How do u reset the timing on a 1995 chevy monte carlo 3100 engine.


Advice of Haynes manual is worth it . But to answer your Intake ?? if it is intake manifold gasket there are 3 of them . The upper planium is the Aluminum part the Air intake hose attaches TOO - a common GM loss of pressure gasket causing rough idle / drivebility issues . Then # 2 gasket is lower intake mounting to antifreeze carrying Intake manifold same air pressure loss. ## 3 is Intake base mounting to cylinder heads and has coolant carried in it to keep air / fuel mix charge cold . Now U see you did not remove cylinder heads so the Timing belts or heads not have been disturbed = no need to set timing . Timing is set by computer via sensors and Belt Load / Tension under Rpm . If you have loose / worn out Timing belt then engine will rattle when applying power in gear with foot on brake - it may stall under test I described and not want to restart - That would be reason to Look at resetting Timing issues . Good luck .

Jun 03, 2012 | 1995 Chevrolet Monte Carlo

1 Answer

95 Monte Carlo Idle Fast and Have low oil pressure


95 monte carlo is idling high we just replaced the intake manifold gasket. How do I fix this and could I have caused it.

Jun 13, 2009 | 1995 Chevrolet Monte Carlo

2 Answers

Wont keep idle, car stalls out


I had this same problem on my 2005 monte carlo, took mechanic a while to figure out it was the idle air control valve. They also replace the idle air control motor.

Jun 01, 2009 | 2005 Chevrolet Monte Carlo

2 Answers

2002 ls monte carlo "shudders" between 2,000-2400 rpm.....


My monte carlo would hit 2nd gear and bog down and not shift properly until it got to the last gear. I had the catalytic converter replaced and that fixed that problem. (It also created another, but not near as bad)

May 20, 2009 | 2002 Chevrolet Monte Carlo

1 Answer

How do I connect tranny to radiator coolant lines monte carlo


The lower line off the transmission will connect to the lower radiator fitting and the upper transmission to the upper radiator.
Good luck.
Regards,

May 17, 2009 | 1995 Chevrolet Monte Carlo

1 Answer

I CANT LOCATE CRANK POSITION SENSOR


7X Crankshaft Position (CKP) Sensor
Lower rear of engine
4
25
--
24X Crankshaft Position (CKP) Sensor
Right hand side of engine, at end of crankshaft, behind harmonic balancer
7X Crankshaft Position (CKP) Sensor
Lower rear of engine
4
25
--
24X Crankshaft Position (CKP) Sensor
Right hand side of engine, at end of crankshaft, behind harmonic balancer
Right hand side of engine, at end of crankshaft, behind harmonic balancer

Apr 12, 2009 | 1995 Chevrolet Monte Carlo

1 Answer

1995 Chevy Monte Carlo


you need to take the upper and lower steering column covers off, should be 3 screws in bottom, take tilt steering lever out if neccessary, it is a 2 peice cover, take apart, change switch and put back together

Nov 03, 2008 | 1995 Chevrolet Monte Carlo

Not finding what you are looking for?
1995 Chevrolet Monte Carlo Logo

140 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7710 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...