Question about 2005 Chevrolet Aveo

1 Answer

My 2005 chevy Aveo will not run below 1500 rpm. it runs fine above 1500 but dies when it gets to 1500. I have replaced the air idle sensor as well as the throttle possition sensor with no luck.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 3 Answers

Sometimes you can change your vaccum hoses

Posted on Nov 13, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2005 Dodge Ram 1500 4.7 Engine. Starts fine, Idles fine, but when engine shifts into high gear and RPM lowers engine runs really rough under load


Have you checked for a broken valve spring. Repaired a dodge engine with the same running issue as you have described and it was a broken intake valve spring.

Feb 22, 2015 | 2005 Dodge Ram 1500

1 Answer

2005 Aveo intermittently will crank ( turn over ) but not fire ( Run ). Jump-start no help, interior and exterior lights look good on "batt" power. Its a 5-speed. Been to dealer 2X, and...


Did they check to see if any reprogramming or up dated software for the PCM is avilable ? Sometime computer gliches will cause problems an the dealer can do a reflash to fix the problem . Did they look at TSB - technical service bulletin .You could go to the GM TDS web site an enter your vehicle ID # or VIN an it will tell you if any updated software is available . Also could have a lose or corroded connection ,body grounds etc.... How to Program and Reprogram OBD 2 Modules Example Code P0326 Knock Sensor

Mar 01, 2017 | 2004 Chevrolet Aveo

1 Answer

Hi, I have an 89 Chevy 1500 with a throttle body. The truck runs rich. The oil pressure gage reads 15 psi when the engine is warm and waiting at a light. It shoots back to 30-35 psi once I get going. Any...


Running rich can be from a bad sensor, such as O2, mass air, temperature, throttle position, etc., which would effect all cylinders and run smooth.
Or from a bad plug or wire, bad compression, etc., which would not effect all cylinders and run rough.

The most common with this age, would be PVC blowby foam coating the air mass sensor. Just take it off and clean it. Then splice long hoses into the PVC, and run it down to a metal container that get cold in the wind, to condense out the oil and water vapors before it gets into the intake.

Your oil pressure is perfectly fine.
On new vehicles, oil pressure can even drop below 10 at idle, and to above 40 when at high RPM.

Aug 11, 2010 | Chevrolet 1500 Cars & Trucks

1 Answer

97 chevy suburban 4x4 1500 only when it drops 40 6.5 tubro diesel


fuel might be thickening -try an anti-gel or other fuel additive-also get fuel pump pressure checked

Oct 14, 2009 | Chevrolet Suburban 1500 Cars & Trucks

2 Answers

94 chevy k1500 5.7L engine won't run properly.


It could and most likely is a faulty Fuel pump.

Sep 12, 2009 | 1994 Chevrolet K1500

1 Answer

98 Lincoln Navigator Check Eng light on


fuel pump is going out causing the truck to run lean and miss

Aug 22, 2009 | 1999 Lincoln Navigator

1 Answer

Won't start, engine wont rev above 2000rpm


Have the alternator tested. You are providing a low charge to the battery when you jump it and when taking it above 2K RPM requires more amperage resulting in the engine dying and the rough idle

Apr 23, 2009 | 1999 Chevrolet Silverado 1500

4 Answers

Mazda 626 engine cut off when excel over 3000 rmp


my 1988 mazda 626 starts okay then dies everytime it idles down to normal idle speed. i replaced the throttle control sensor and the mass air sensor. i replaced the rotor in the distributor but is still dies. if you throttle up to about 1500 rpm it keeps running. any ideas???

Aug 04, 2008 | 1994 Mazda 626

Not finding what you are looking for?
2005 Chevrolet Aveo Logo

Related Topics:

388 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7782 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...