Question about 2000 Jaguar S-Type

1 Answer

Don't know where to put transmission fluid, what are indicators transmission is faulty?

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Hi there until recently i had an XJ jag and the transmission oil on that goes in via the dipstick tube fiddly but thats how it was done...hope this helps

Posted on Nov 15, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Transmission fluid

30k on trans fluid may set the sensor off. The wiring to the sensor could be a problem too. A faulty sensor will give the indication too.

Jan 12, 2014 | 2001 Mercury Sable

1 Answer

Transmision wont go into gear no drive indicator

Did you replace the lost transmission fluid and rechecked the oil level after starting. Secondly if the torque converter moved forward without you knowing it, the converter may not be properly connected to the front pump and it won't be working Lastly ensure that all electrical wiring connectors are properly connected and not loose.

Apr 01, 2013 | 1997 Toyota Camry

1 Answer

Check transmission fluid

some car do not have deep stick.I do not know about this one.

Mar 13, 2013 | 1999 Mercury Villager

1 Answer

I accidently put automatic trans fluid in my power steering reserviour

Transmission fluid and power steering fluid are the one in the same. They are both hydraulic fluid. Only the red dye. Your vehicle will operate fine on transmission fluid in the power steering pump. Just don;t put power steering fluid in your transmission

Apr 02, 2012 | Cars & Trucks

2 Answers

Won't accelerate on highway. Is it a transmission

Won't accelerate on highway? At what speed (estimate) are you traveling before you "punch it". Is the engine a 3.4 or a 3.8? Is the check engine light on? Is it flashing?

These are a few questions I need to know to try to isolate the problem, but to put you in a ballpark of possible causes, causes could be (but not limited to):
poor grade of fuel
faulty secondary ignition components (spark plug wires, plugs)
clogged fuel filter
insufficient fuel pressure
a partially blocked catalytic converter (will aslo cause the floor to be a little warm)
a faulty map sensor
a faulty egr valve
a faulty transmission shift soleniod
a faulty vehicle speed sensor
low transmission fluid level
partially or blocked transmission fluid filter
transmission fluid has weaken due to age (needs flush)

Sep 02, 2011 | 2001 Chevrolet Monte Carlo

2 Answers

The gears do not change and from the owners manual a possible problem is indicated as a leaking transmission. The vehicle is a 1998 model. I have never had to put in automatic transmission fluid since I...

Yes, low transmission fluid from a leak will cause loss of gear-changing ability. Also, eventually,
if you were to try to drive the car on a dry transmission (for a distance as short as 4 blocks), you
can permanently ruin the transmission.
Most mechanics would advise you to top up the transmission fluid and drive to your nearest
transmission repair shop, where they will probably not determine the source of the problem and
fix it - most transmission shops don't repair transmissions, they simply replace them, and send
the faulty transmission to a real transmission repair shop, from which they order their rebuilt
replacement transmissions.

May 17, 2011 | Mercedes-Benz B-Class Cars & Trucks

2 Answers

It wont move i put it in reverce it wont move i put it in drive it wont move

check transmission fluid level could be low.if transmission fluid level okay and fluid and filter been changed every 21000 miles.code scan for transmission fault codes like faulty transmission range sensor.faulty transmission fluid pressure solenoid, look for faulty torque converter code or faulty tcm. if you see no fault codes.either transmission manual shift linkage loose or broken or you have internal transmission damaged.

Apr 16, 2011 | 1999 Ford Escort

2 Answers

I have code PO744

likely causes-
Faulty torque converter clutch solenoid valve
- Torque converter clutch solenoid valve harness or connectors
- Torque converter clutch solenoid valve circuit is open or shorted
- Low transmission fluid level
- Dirty transmission fluid
Tech notes When the a transmission solenoid is working intermittent, in most cases the problem is not the electrical part of the solenoid; the problem is foreign material obstructing the mechanical function of the solenoid or the flow of the fluid through the transmission valve body. If the transmission fluid is very dirty, it is recommend changing the transmission fluid and if possible removing the transmission pan for further diagnosis. Excessive debris or metal particles on the transmission pan could be an indication that there is a transmission mechanical failure and that the transmission will need to be rebuilt or replaced.

Jan 11, 2011 | 2000 Kia Sephia

1 Answer


you do not have a dip stick.

Item Part Number Description 1 — Fluid fill plug (bench) 2 — Fluid level 3 — Fluid drain plug (large) 4 — Fluid level and fill plug (small) 5 — Fluid level tube

  1. NOTE: It will be necessary to hold the drain plug (larger plug) with a wrench when removing the fluid level indicator plug.
    With the transmission in the PARK position and the engine running, use a 3/16 inch Allen key to remove the fluid level indicator plug.
  2. Allow the fluid to drain. Wait approximately one minute. When the fluid comes out as a thin stream or a drip, it is at the correct level.
  3. If no fluid comes out of the hole, fluid will need to be added. Continue with this procedure.
  4. Install the special tool into the pan.

Apr 13, 2009 | 2001 Jaguar S-Type

Not finding what you are looking for?
2000 Jaguar S-Type Logo

Related Topics:

122 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jaguar Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers


Level 3 Expert

76682 Answers


Level 2 Expert

489 Answers

Are you a Jaguar Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides