Question about 2007 Chevrolet Avalanche LTZ

Open Question

How do i remove the rear bumper cover on my 2007 avalanche at the point where the spare tire lowering crank passes through the rear bumper there is a metal collar retainer with at least a dozen retainer fingers on it that appear to me to be impossible to disengage without destroying the retainer

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 32 Answers

SOURCE: spare tire removal

If the tire does not lower with the jack parts from the access door then you will have to put the jack up under the presseurerelease in the middle of the tire till it releases.

Posted on Dec 22, 2008

  • 107 Answers

SOURCE: Can't fit retainer through the hole in the rim.

you can't take the cable off the retainer.
after the tire is down you need to lift one side of the tire and put the retainer through the hole at an angle

Posted on Jul 11, 2009

  • 58 Answers

SOURCE: The cable for the spare tire on my 2006 1500 works

  1. Rotate the hoist shaft counterclockwise until approximately 15 cm (6 in) of cable (1) is exposed.
  2. While holding the latch pin (3), fully depress the latch button (2) and release the secondary latch from the hoist assembly. Some side-to-side and/or up-and-down movement may be necessary to disengage the latch mechanism.
  3. Continue rotating the hoist shaft counterclockwise in order to lower the hoist the rest of the way.
  4. If this does not release the secondary latch, the spare tire hoist will need to be replaced. See the following procedure.
Important: If the spare tire hoist has been fully raised without a spare tire in place, the secondary latch mechanism may have become engaged. If this has occurred the hoist will not lower and the following steps will need to be followed:

Posted on Nov 02, 2009

  • 1 Answer

SOURCE: chevy avalanche/spare tire remove

We had to cut the spare loose by with a torch.

Posted on Nov 09, 2009

  • 10993 Answers

SOURCE: I do not have a key to remove my spare tire. There

if its an aftermarket lock drill out lock and remove if it came as a dealer option check glove box or jack area for spare key

Posted on Nov 15, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

How to take a spare tire off gmc envoy 2004


Since the spare is mounted under the rear of the car, Its not easy...you have to assemble the long crank rod out of its two pieces, then feed the rod through the hole in the top of the rear bumper and lock it into the mechanism that holds the tire in place. Once the crank rod is locked in, lower the tire towards the ground. Once the tire is low enough, you can crawl under the car and release the tire from its mount. The hardest part is locking the crank rod into the spare tire mechanism through the hole in the bumper.

Jun 17, 2014 | 2004 GMC Envoy

2 Answers

Where is the spare on a 95 ford windstar


it should be right behind your rear bumper up under your van. The way it is removed is to take your tire iron extension bars that should have come with your vehicle and assemble them. then you should see a hole near your license plate tag or somewhere on your bumper to stick the rod in ( sometimes the hole has a lock that your ignition key should unlock) then you turn the crank handle and lower down your tire.

Jan 29, 2013 | 1995 Ford Windstar

2 Answers

Where do i find the location of the spare tire jack for my 2001 Suburban?


in my burb, the jack and all the components are in a compartment located between the 3rd row seat cupholder and the mesh/container compartment. it's kind of deep and it has a small indednt for a handle, lift that and it should pop right out, then you can undo the nut to release the jack and wheel chokes. then follow konkomados's steps to lower your spare at the back

Jan 11, 2011 | 2001 Chevrolet Suburban

2 Answers

Where is the spare on the 1997 Blazer


Welcome to FIxYa.com


rear of truck under neath frame


Regards, Lee Davidian


Thank you for using FixYa,com.

Oct 23, 2010 | 1997 Chevrolet Blazer

1 Answer

How do I remove the spare tire on my 2001 chevy surburban?


Typically all Suburban spare tires are mounted on an under-car carrier. This carrier is usually accessed through a covered key way at the rear bumper near the license plate step. The jack that comes with the Suburban also has a crank rod that is used to raise and lower the jack. The other end of the rod is designed to access the key way to crank the spare tire lift up or down. Cranking the lift in a counterclockwise rotation will lower the spare tire.

I hope this helps:)

Sep 30, 2010 | 2001 Chevrolet Suburban

1 Answer

How to remove the spare tire on my 2007 dodge ram hemi pickup truck?


on your rear bumper or just above it there should be an access hole that you can stick the jack handles through ,then you should be able to lower the tire, its like a winch unwinding

Sep 26, 2010 | 2007 Dodge Ram Truck

3 Answers

How do i get the spare tire to come down


If the spare tire does not lower to the ground,the secondary latch is engaged
causing the tire not to lower Your vehicle has an underbody-mounted tire hoist
assembly equipped with a secondary latch system.It is designed to stop the spare
tire from suddenly falling off your vehicle if the cable holding the spare tire
is damaged.For the secondary latch to work,the tire must be stored with the
valve stem pointing up.
1.Check under the vehicle to see if the cable is visible.If it is not visible
proceed to Step 6.
2.If visible,first try to tighten the cable by turning the wheel wrench clockwise
until you hear two clicks or feel it skip twice.You cannot overtighten the cable.
3.Loosen the cable by turning the wheel wrench counterclockwise three or four turns.
4.Repeat this procedure at least two times.If the spare tire lowers to the ground
continue with Step 2 of removing the Spare.
5.Turn the wrench counterclockwise until approximately 6 inches (15 cm) of cable is
exposed.
6.Attach the jack handle,extension and the wheel wrench to the jack and place it under
the vehicle towards the front of the rear bumper.Position the center lift point of the
jack under the center of the spare tire.
7.Turn the wrench clockwise to raise the jack until it lifts the end fitting.
8.Continue raising the jack until the spare tire stops moving upward and is held firmly
in place.
9.Lower the jack by turning the wheel wrench counterclockwise.Keep lowering the jack
until the spare tire slides off the jack or is hanging by the cable.
10.Disconnect the jack handle from the jack and carefully remove the jack.Use one hand
to push against the spare while firmly pulling the jack out from under the spare tire
with the other hand.

Oct 31, 2009 | 2004 GMC Envoy

2 Answers

2007 buick lucerne has water leaking into the spare tire wheel well. please advise


Remove trunk trim and covers , close trunk and wet car now look for leak source.

Jun 16, 2009 | 2007 Buick Lucerne CXS Sedan

1 Answer

I need to remove the spare tire from underneath my 2004 Escalde?


The spare is held in place by a cable hoist, the the tool kit for changing tires has the crank to lower the spare. the access hole is through the bumper in most cases, look under the rear bumper u will see the crankin down access easily that way.

Nov 10, 2008 | 2004 Cadillac Escalade

2 Answers

Lowering/raising the spare tire


there should be a crank handle under the hood and an access hole just above rear bumper

Jun 28, 2008 | 1999 Mercury Mountaineer

Not finding what you are looking for?
2007 Chevrolet Avalanche LTZ Logo

Related Topics:

347 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7697 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...