Question about 1991 Plymouth Laser

1 Answer

No spark out of plugs distrubtor is brand new

Posted by on

  • soccerboys Nov 01, 2008

    i have no spark on any of my spark plugs the fuel pump works then the key is turned so i know it isnt that my car sat for about two or three months it was in running condition before and when i came back to it this is the problem i have can anyone help me


1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

Check your Number ine plug that could be it. if there is a problem with that it could be the coil the number one plug can prevent the car from getting any spark same with the coil. i have a 91 laser as well if you know where i can get some parts e-mail me @

Posted on Jan 12, 2009

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Mazda e2000 loses power and cuts out when warm? now it shakes when idleing.

did u change plug wires--bad ones leak sparkdi--ignition module may hav issues too--or something is gettn hot in the electronix-comes from age--disappears wen cool

Dec 23, 2014 | Mazda Cars & Trucks

1 Answer

Why is my 1991 toyota camry sputters

Bad fuel, fuel filter, low fuel pressure(fuel pump).

Sep 01, 2014 | 1991 Toyota Camry

1 Answer

I replaced the rotor an distrubtor cap changed an the guy took the hole distrubtor out and now it want start

If the plugs are getting spark, you just need to reset the timing. Line up the marks on the crank pulley and put the rotor at the number one plug wire. It will either be correct or 180 degrees off.
Once the engine is running you will need to use a timing light to set the timing to spec.

Apr 22, 2013 | Cars & Trucks

1 Answer

Pu t in new coil and distrubtor cap and rotor put in new electronic module not firing wont start

No spark at the spark plug? It may be the pick-up coil inside the distributor. This is the sensor that tells the computer the engine's crank position.
If the ignition switch is good, you should have power at the coil's + terminal when key is on. You might check for that.

May 08, 2012 | 1989 Chevrolet Camaro

1 Answer

Won't run, got fuel, got spark from coil to distributer but will not fire. Tried new plugs, fuel filter and dust. cap. No go.

You may want to change your rotor bug in distrubtor,If this don't work you may have bent or wornout shaft goig down from distrubutor inside motor. But if your getting fire to the coil but not the distrubtor i think the rotor bug will fix it. Good luck to you.

Apr 16, 2011 | 1992 Honda Accord

1 Answer

Spark plug removal and installation

This isn't fun. First make sure the engine is cool [ could strip the threads in the head if hot ], then you will need to remove the 7 milimeter headed screw that holds the coil-s in, remove the electrial connector, then carefuly twist the coil to loosen the boot from the spark plug and lift up, if you have air availble , [ it would be good to blow the holes out - other wise dirt and junk may drop into the cylinder], use a long flex joint plug scocket to remove the spark plug. At this point I recommend you replace the boots on the coils, they degrade like igntion wires on a distrubtor type system. Gap the new plugs, install to the proper torque = 13 foot pounds. This is very important as if they are over tightened they could strip, or too loose, they could begain moving and blow out of the head, This is real commom with these motors, [ aftermarket companies make a self tapping spark plug for this ]. reinstall the coils.

Apr 14, 2011 | 2005 Ford F-150

1 Answer

I get spark to the distributor but just a little spARK TO plugs.

Use a little sand paper and clean the brass tongs inside the distrubtor, Might check your pick-up coil while you have distrubtor cap off. If cap is very bad just replace, Good luck this should fix your problem.

Apr 04, 2011 | Chevrolet 3500 Cars & Trucks

1 Answer

My saturn sc1 is sputtering and back firing and misses, what is the problem

Sounds like the electronic module....this is a modern type distrubtor...I had the same problem once....part new is about $300.00.....installment is not hard...sits on top and has the spark plug wires plugged into it...cant miss it

Nov 22, 2009 | 1998 Saturn SC

1 Answer

I took my van in for a basic turnup and oil change that was $264.

If you remove the engine cover from inside the vehicle you will gain access to the spark plug wires and spark plugs. The spark plug wires come out of the distrubtor cap thats at the rear of the motor, the spark plug wires run to the left side of the motor and to the right side an end up attached to the spark plugs. Reolace spark plug wires one at a time so you dont mix them up, this is fairly easy the only difficult part is getting your hands in the small space in the engine compartment. Hope this was helpful.

Nov 26, 2008 | 2001 Chevrolet Astro

Not finding what you are looking for?
1991 Plymouth Laser Logo

Related Topics:

61 people viewed this question

Ask a Question

Usually answered in minutes!

Top Plymouth Experts


Level 3 Expert

74269 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22082 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7234 Answers

Are you a Plymouth Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides