Question about 1991 Rolls Royce Rolls Royce Silver Spur

1 Answer

Starts fine when warms up idles rouph - 1991 Rolls Royce Rolls Royce Silver Spur

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 3,489 Answers

When it is cold, the idle is set higher and may cover a misfire. The first thing to check are the spark plugs. Recomended brands are either Bosch or Champion. Platinum plugs are not recomended!! Look for white tracking on the boots and wires indicating an electrical leak resulting in a misfire condition. Great cars and engines. Lots of power and very smooth. Email me if you need further help.

Posted on Nov 14, 2010

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Engine runs rough idle

run fault codes to find what is happening for the rough idle.

Jan 13, 2014 | Cars & Trucks

1 Answer

1995 chevy tahoe 4wd. 5.7 liter when cooled down, starting is normal . Right after, engine almost stalls but Idle air control kicks in and keeps it running. eventually it is idling but rouph. On...

If your vehicle has one, and I think it does, check your EGR system. If the egr valve is full of carbon, it can be partially open, creating a vacuum leak. If the egr valve solenoid is bad, it could be opening the valve at the wrong time, also creating a vacuum leak. Unplug the egr vacuum hose, plug the open end of the hose and start it and see what it does. A picture of the egr is below.

Mar 11, 2017 | 1995 Chevrolet Tahoe

1 Answer

It is starting skip alittle and idle rouph i have replaced the plugs and wires

Which engine, how many miles, and are you sure you got the wires back on in the proper order??

Apr 11, 2010 | 2004 Dodge Grand Caravan

1 Answer

Check engine light on. idle very rouph.likeno fuel. code po301

A code PO301 indicates a cylinder misfire. You may want to start with a tune-up, including new plugs and wires, especially if they are original from the factory. If there is a cap and rotor, replace them as well. To double-check the problem though, I would recommend bringing your vehicle into a local technician so he can put it on an engine diagnostics computer.

I hope this gives you a start as to where to look! Please let me know if you need any further assistance in this matter. :)

Nov 18, 2009 | 1999 Toyota 4Runner

1 Answer

Car got flooded

if it has a distributor, take the cap off and see if its wet up in cap

Jul 02, 2009 | 1990 Buick Regal

1 Answer

Car starts fine but doesn't idle when warmed up.

sound like idle speed control problems.its idling too low.

May 17, 2009 | 2001 Mazda Tribute

3 Answers

Fuel problems

a rouph idle or running rouph could be a couple of things

1. you may need to clean you carberator or fuel injectors.
2. you may need to change your spark plugs
3. if you can drive and be fine and when you try to get into the gas and it tryies to bog and idle rouph than you may have an hair line fracture in the distributor cap..
but it sounds like a fuel problem... also if you have run it low on gas latley you may sucked up all the dirt at thebottom of your fuel tank clogging you fuel filter... so check that as well. the fuel filter is usually the cheapest to change... if this doesn't help the only thing i can think of othe than that is check your catalitic converter it my be trying to clog and if it does your truck will not run right or run at can check this by taking the exust loose from the manifold and running your engine... if this doesn't help e-mail me and i will help you through this problem....

May 15, 2008 | 1992 Ford F150 SuperCab

Not finding what you are looking for?
Cars & Trucks Logo

185 people viewed this question

Ask a Question

Usually answered in minutes!

Top Rolls Royce Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers


Level 3 Expert

75807 Answers


Level 3 Expert

881 Answers

Are you a Rolls Royce Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides