Question about 2004 Land Rover FreeLander

1 Answer

Fitting new radiou but dont seem to have any power

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Land Rover Master
  • 22,219 Answers

Is it a factory radio or a aftermarket radio

Posted on Nov 12, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

I just bought an 02 GMC Savana 3500 with 350 and I was told about 120k. Bought it cheap as heck as a known project but Im kinda stumped with electrical issues.


one point I am thinking is , the mileage for the car is too low so maybe a new dash was fitted and all the plugs at the back were not correctly fitted or ground wires were not connected
an 2002 is 15 years old
average distance covered is 20 k per year so the speedo should have over 250-300 k on it

Mar 12, 2017 | GMC Cars & Trucks

1 Answer

Just purchased an 87 Ford Honey C.... aux battery shows a good charge, but when parked the outlet nor tv work?


Fit a solar panel on the roof ,dont think the dual circuit charging is working for whatever reason

Nov 22, 2014 | Ford Cars & Trucks

1 Answer

My dash board lights dont work when i turn my headlights on and ive turned the brightness up and still not working, any solutions? and also, my aftermarket radio doesnt work anymore do these problems...


gday mate,geoff here, seems like you may be right, if the radio has been fitted to another fuse, ie the dash light fuse which may well also run the tail lights, alternitavely the new radio may take more power than the original, usnig higher power for more volume, features. check fuse amperage and corrct, look to see ( if you can ) to see the original wiring hasnt been tampered with, if so correct and try again, best i can do without being there,hope this helps, geoff.

Feb 10, 2012 | 1998 Honda Accord

1 Answer

Over heating


have you tried replacing the thermostat?

Jul 28, 2009 | 2005 Hyundai Elantra

1 Answer

Speedometer & odometer not working after dead battery replacment


Remove the - (Negative) battery lead and wait for a few seconds. the refit BUT DONT LET the terminal arc keep it firmly pressed on while tightening. It seem as if this may have happened when you fitted the new battery as any rapid on off power to the management system will scramble it. You also dont say if you have driven it far as some times after a battery change depending on management system fitted around 20 miles before system workks out settings lost when power removed (happens after a sensor change aswell) hope this helps.

Jul 08, 2009 | 1997 Ford Escort

1 Answer

Clutch cable adjustment


the clutch cables dont really adjust if its still to long after fitting a new clutch then i suggest that a new cable fitt4ed aswel as it seems to have stretched

May 29, 2009 | 1996 Ford Escort 4 Door

1 Answer

No heat in heater of sprinter van


your termastat is gon get a new one

Jan 26, 2009 | 2004 Dodge Sprinter

1 Answer

Dont know how to put the new fanbelt on


If you open the bonnet and look to the left hand side you will see the jockey wheel that keep the belt tight tight. It has a square 3/8 inch fitting in it, put in a rachet of that size and take the tension off. Your belt will now lift off all the pulleys easy. If I was you I would make a simple drawing before you actually take off the drive belt as it runs over a number of pulleys and if you do the drawing easy to fit the new one on.

Once you have old one off fit new one and take the tension off with the rachet as you did prior to removing use your drawing to fit it correctly. I would also make sure your jockey wheel is fine prior to fitting the new belt listen for any rough bearing noise from it when you spin it.

Make sure you get the right belt from a ford dealership asthe length is critical of the new one even one a little shorter wont fit, dont be talked into buying one that seems nearly the right length, it must be the Ford one and the right length.

Sep 27, 2008 | 1998 Ford Explorer

1 Answer

Color for radio wiring? or diagram need the color of wires of radio harness


I have AURORA 2001 I need to put the sub wofer in my car I dont know whot is behaid radiou in my car

Sep 11, 2008 | 2004 Oldsmobile Alero

Not finding what you are looking for?
2004 Land Rover FreeLander Logo

Related Topics:

58 people viewed this question

Ask a Question

Usually answered in minutes!

Top Land Rover Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

yadayada
yadayada

Level 3 Expert

76649 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8518 Answers

Are you a Land Rover Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...