Question about 1988 Toyota Land Cruiser

Open Question

How to replace water pump 1988 land cruiser - 1988 Toyota Land Cruiser

Posted by on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


SOURCE: 1997 Toyota Land Cruiser rain water leak

i had the same problem. Flushed the sunroof drains, replaced the windsheild, and weather stripping on passenger and driver side doors. Car is still leaking. No one can figure it out.

Posted on Jul 31, 2008

  • 119 Answers

SOURCE: 1988 toyota hj75 land cruiser

Repelce fuel filter, check is there any fuel leak,
also check heater plugs,
if all that ok check injectors and injection fuel.
check how is engine compresion.

Posted on Oct 07, 2008

  • 87 Answers

SOURCE: replace heater core 96 land cruiser

remove the dash board then the heater control box

Posted on Feb 27, 2010

  • 50 Answers

SOURCE: 1986 Land Cruiser: i have a 1988 land cruiser and my problem is that ...

check fuel pressure.

Posted on May 19, 2010

SOURCE: Hello, i need to replace a high pressure power steering hos

The high pressure hose is simple to replace if its not to confined of an area for you. Just un-thread from both sides, fill with power steering fluid, work steering wheel from side to side to work the air out. In between this check fluid levels. If air is still in it will make a whining sound, and bubbles will be visible in the power steering fluid reservoir. Hope I helped you good luck!!

Posted on Jul 11, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

1988 Toyota land cruiser won't go into four wheel drive

are you and hard ice free pavement.?
if yes, why?
its part time 4wd.
repeat test on dirt, work now>?
or ice or snow,....

you never said what makes you THINK its not in 4wd.
the most important fact
and where are you driving, what are tires touching?
we dont know.

Dec 10, 2013 | 1988 Toyota Land Cruiser

1 Answer

1989 Toyota Land Cruiser (BJ70)

Fit a new water pump ,the seal is leaking and stops when it warms up.

Nov 21, 2013 | 1989 Toyota Land Cruiser

1 Answer

Water pump on toyota land cruiser leaking

It is any special color? rust or so? Some of the water pumps notify in this manner that is time to replace it before the problem became worse!

Nov 21, 2013 | 1989 Toyota Land Cruiser

1 Answer


could very well be but it could also be any one of a number of things ,as its a 1988 its 23 yrs old so is it worth rebuilding the engine compared to buying another vehicle which may be a cheaper alternative

Feb 12, 2011 | 1988 Toyota Land Cruiser

1 Answer

How to replace a radiator on a1994 toyota land cruiser


  1. Disconnect battery ground cable.
  2. Drain engine coolant.
  3. Remove battery and tray,
  4. Remove radiator grille
  5. Disconnect No. 3 water bypass hose.
  6. Disconnect radiator inlet hose.
  7. Disconnect coolant reservoir hose.
  8. Loosen water pump pulley mounting bolts.
  9. Loosen lock, pivot and adjusting bolts of alternator and remove drive belts.
  10. Disconnect oil cooler hose from clamp on fan shroud, then remove shroud.
  11. Remove water pump pulley mounting nuts.
  12. Remove fan with fluid coupling, water pump pulley and fan shroud.
  13. Disconnect transmission oil cooler hoses.
  14. Disconnect radiator outlet hose.
  15. Remove radiator brackets, then the radiator.
  16. Reverse procedure to install.

Dec 11, 2010 | 1994 Toyota Land Cruiser

1 Answer

No heat inside the car

sounds like your heater matrix is dun.check the thermostat first though

May 04, 2010 | 1988 Toyota Land Cruiser

1 Answer

On my Land Cruiser HJ60 ,1988 model, I seem to have a slight positive camber on the Front left. What do I do to correct this?What are the alignment specs?

Your best bet is to just take the car to a wheel alignment shop, doesn't cost much, just had my jeep done last week, 4 wheel balance and alinement only cost $40 and it was all done electronically

Feb 05, 2010 | 1988 Toyota Land Cruiser

1 Answer


yes .if you can find one in a junkyard should cost 3 to 5 hundred new would be around 1700.00 good lusk

May 28, 2009 | 1988 Toyota Land Cruiser

1 Answer

1988 Land cruiser front end vibration from wheels

change the swivel bearing each side you got 2bearing do prober adjustment.

good luck

Dec 31, 2008 | 1988 Toyota Land Cruiser

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

160 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts


Level 3 Expert

79024 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8836 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides