Question about 2004 Infiniti G35 Sport Coupe

2 Answers

Automatic windows When I use the auto up feature, it hits the top then drops 5 inches. I can raise it slowly and it stays up.

Posted by on

  • William Cerniuk Dec 01, 2008

    same issue, on passenger side. will roll to top and then roll back down 1/2 way  when using the automatic up feature. windows have been problematic since I bought my G35 in 2003



2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 9 Answers

Take of the door panel. There will be a metal skin underneath. Look for a black sticker that is covering a hole. There may be more than one. The one you want is covering a little rubber nipple/switch thing. Roll the window all the way up! NOT WITH THE AUTO UP! MANUALLY! Now, push on the rubber switch in the door and HOLD it. Roll the window all the way down with the MANUAL switch. DO NOT PUSH IT ALL THE WAY TO AUTO DOWN or it will not work. Let go of the rubber switch. Roll the window up with the MANUAL switch position. Now you can Auto Down/Up. If it does not work...Try rolling the window all the way down, holding the rubber switch, rolling the window up with manual, let go of switch and roll down manually. Then try to auto up. If it doesn't set you need a new Window Motor.

Posted on Sep 07, 2008

  • Level 1:

    An expert who has achieved level 1.


    An expert that has over 10 points.


    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 13 Answers

Need to seset the window motor

Posted on Jun 22, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

2008 pontiac g6 drivers window, when handle is lifted the window does not drop the inch or so that it should.

The window indexing feature is used to lower the driver and passenger power windows approximately 4 mm when the door is opened. This is necessary to allow the top edge of the window to clear the window weather-strip. This feature will also raise the window to the fully seated position once the door is closed.
Is just the driver door not working ?
Observe the operation of the driver window and front passenger window while opening and closing their respective doors. The windows should index DOWN and UP when the doors are opened and closed.
? If either window does not index UP or DOWN, refer to Window Index Feature Malfunction.

Window Index Feature Malfunction
Ignition ON, observe the scan tool Driver Door Ajar Sw and Door Ajar Switch parameters while opening and closing the driver and passenger doors, the parameter should change from Door Closed to Door Ajar.
? If the parameter does not change when opening and closing the doors, refer to Door Ajar Indicator Malfunction .
Ignition OFF, disconnect the harness connector at the appropriate window motor.
Ignition ON, with the door closed, test for greater than 10 volts between the signal circuit terminal 5 and ground.
? If less than the specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the BCM.
With the door open, test for less than 1 volt between the signal circuit terminal 5 and ground.
? If greater than the specified range, test the signal circuit for a short to voltage. If the circuit tests normal, replace the BCM.
If all circuits test normal, replace the window motor.

Your best bet mite be to take your vehicle to a qualified repair shop (GM dealer )

Nov 13, 2017 | Pontiac Cars & Trucks

2 Answers

My battery completly died. Now my anti theft system lockdd my power windows sunroof power locks and my seat adjusters. What can i do?

Take to dealer and have your memory reset,. some times this happens when a battery goes totally dead. They have the software to reset

Jan 12, 2015 | 2002 Nissan Pathfinder

1 Answer

How can I re-initialize and get the auto up/down working again on my Expedition driver window?

You don't say what method you used so try this -lower the window and contnue to hold the button down for another 5 seconds then raise the window a continue to hold the button down for a further 5 seconds hope this helps

Aug 22, 2014 | 2009 Ford Expedition

1 Answer

Liftgate does not stay up,why?

needs new stays end of story

May 11, 2012 | 2009 Chrysler Aspen

1 Answer

I have 2006 750 LI the passenger rear power shade will only go up 1-2 inches and reset?> I have checked for obstructions/ poped top panel back and tried to manually raise/ and put back ib factory clips...

Hi Butler296,

I would recommend double checking the door panel at the top where the shade travels and make sure that the leather material is not coming loose. If it appears to be ok, try reinitializing the rear window by raising it all the way up, and once up holding for approximately 7seconds. Also, there is a built in safety feature that will not allow the sunscreen to automatically raise if the window glass is down.

Jul 18, 2011 | 2006 BMW 750Li

1 Answer

Soft top not working

It is never a good idea to unplug your modules with the key on you definitely can damage them. Hope fully your windows are not synchronized. See if the express mode up works. Try holding the button in the first detent and raise window and hold for 5 seconds. next see if the windows work with the 1 touch operation. It is possible that the module you unplugged stores the synch for that feature. The soft top module must know the window position in order to operate. Also there is a sliding cover that must be retracted in your trunk in order to operate top. The switch in the cover has to be depressed to let module know that there is nothing in they way of the top operation. Hopefully I have been helpful.

May 31, 2009 | 1995 Mercedes-Benz E-Class

5 Answers

2004 Saab 9-3 Window reset

I had the problem of the drivers window rolling back down. This was fixed by removing the electrical connector located behind the door hinge. It looks like an oblong block. You have to prise the top ribbed part right up then pull the block out. Leave out for about 1 minute. Replace it

Dec 30, 2008 | 2004 Saab 9-3

3 Answers

Driver side window bumps down when closed.

Turn the key on

Press the window switch, lower the window, continue to hold the window switch down for 15 seconds after the window is completely lowered Don't use the auto feature

Pull the window switch up, raise the window, hold the button up for 15 seconds after the window is fully up. don't use the auto feature

Try the auto down feature again, see if it now works.

Oct 31, 2008 | 2004 Toyota Highlander

Not finding what you are looking for?
Cars & Trucks Logo

524 people viewed this question

Ask a Question

Usually answered in minutes!

Top Infiniti Experts


Level 3 Expert

77194 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14384 Answers

Are you an Infiniti Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides