Question about 2001 Chevrolet Monte Carlo

1 Answer

Put window back on track passenger side front

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 6 Answers

Take it to a window car place to get it fixed

Posted on Nov 12, 2010

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 15 Answers

SOURCE: 2001 vw beetle window and door lock will not work

Hi Rachel . It sounds like the plug on the drivers window motor (Which is also the ecu for that door) has come off or is loose . This will stop the cdl working as well . Regards VW Audi tech

Posted on Jan 20, 2009

chuck943
  • 783 Answers

SOURCE: My power window came off track

There are 2 screws just above the door handle you need to remove. Remove the plastic trim around door handle. Then starting at bottom of door panel pull out to disengage the push pin clips and work your way up both sides of panel. Then lift up on door panel to disengage the weatherstip on top of panel.

Posted on Feb 10, 2009

  • 3 Answers

SOURCE: 2003 Buick Century - window problem

I've had a similar problem with my 2003 Buick Century. In my case, the driver's side front window one day went up and would not come down. I knew that the switch was malfunctioning by sticking in the up position since the window continued up despite the fact that Iet off the switch when the window was half way up and it continued going up. I had to pull over and pull the master switch assembly from the door panel and unplug it to prevent the window motor from being damaged by the constant power feeding it after the window was up. Basically, it would have burned the motor out. I cleaned the switch and it now works fine most of the time. I still need to replace the assembly. Not sure this is the reason in your case. I would check the back window and see if it goes down with the switch on the back door panel. If it does, then you are having problem with the master switch assembly on your front door panel. Moisture from rain from the window being down during rain or dirt may have corroded the switches' contacts.

Posted on Apr 09, 2009

  • 1 Answer

SOURCE: cable on the power window motor is off track

You need to replace the regulator. When cable comes off track it usually binds up in the motor. motor, and cable all come preassembled as one unit, known as the regulator.

Posted on May 21, 2009

  • 60 Answers

SOURCE: rear passenger window off track

You have to carefully remove the panel. They are all "snapped" into place. If you have not done this before, it's hard to describe. You may have to remove a lever, I have never done the back panels, just the front ones, but it was not too bad. Use a medium sized screw drive and take your time.

Odds are there is a green / yellow plastic part that has failed. This usually happens on the front ones, but I guess it could on the back ones. This plastic part fails that holds the window in the runners.

Once the panel is off this is easy to fix. You will have to get the part at a dealer and the put back on. There is a metal retaining pin you will have to deal with.

When testing, please be very careful putting the window all the way up. It is amazing how easy it is to break a window if it is not lined up correctly. My friend broke two trying to fix one of his cars (not a Saab).

I have had to fix a front in my wife's 2001 replacing the plastic part.

This is a known issue

Posted on May 24, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

The front passenger window in my 2004 freelander has dropped how do I fix it.


pull out the door panel and put it back on the track just the window up and then slid it back on the track and tighten the bolts on the track : )

Jan 15, 2013 | 2004 Land Rover FreeLander

1 Answer

Putting window back on track gmc jimmy passenger front window


some of them run with a wire this my have corroded and snaped take of door panel and check this

Aug 24, 2012 | Cars & Trucks

1 Answer

Replace bashed in passenger side window


one screw at handle two on arm rest or under switch the rest is plastic retainers just putt and use trim tool or screw driver two bolts hold glass to regulator have to lower window till you see then remove remove bolt that holds front track and slide glass in top and put in track front an back set in regulator and bolt in raise then bolt front track

Aug 04, 2012 | 1995 Volvo 960

1 Answer

My 2004 acura rsx. the window track clips dont stick to the window when they go down. so the window works fine when it goes up. but doesnt come down with the track clips. is there a adhesive i can buy. or...


I had the same problem with our 2004 RSX. First the driver's side window now the passenger side. They tried to glue the window back twice (driver's side) and ended up having to replace the window and tabs. Now the passenger side did the same thing. My wife put up the window and it kept going, coming out of the track. I'm assuming the window will have to be replaced. Waiting for Acura's ruling. Must be a flaw in the tabs/glue...should have been a recall.

Jan 18, 2011 | Acura RSX Cars & Trucks

2 Answers

Need front passenger window regulator, tracking,


The only real difference that their should be is going to be Left/Right Front/Back

Just make sure you purchase the correct one that you are actually going to replace

Jul 03, 2009 | Hyundai Motor 2002 Sonata

1 Answer

Rear passenger window off track


You have to carefully remove the panel. They are all "snapped" into place. If you have not done this before, it's hard to describe. You may have to remove a lever, I have never done the back panels, just the front ones, but it was not too bad. Use a medium sized screw drive and take your time.

Odds are there is a green / yellow plastic part that has failed. This usually happens on the front ones, but I guess it could on the back ones. This plastic part fails that holds the window in the runners.

Once the panel is off this is easy to fix. You will have to get the part at a dealer and the put back on. There is a metal retaining pin you will have to deal with.

When testing, please be very careful putting the window all the way up. It is amazing how easy it is to break a window if it is not lined up correctly. My friend broke two trying to fix one of his cars (not a Saab).

I have had to fix a front in my wife's 2001 replacing the plastic part.

This is a known issue

May 21, 2009 | 1999 Saab 9-5

2 Answers

Passenger side front and back window not working.


Once those cables break, the window regulator is history.
Cheapest way is junkyard regulators.

Jun 05, 2008 | 1996 Isuzu Rodeo

Not finding what you are looking for?
2001 Chevrolet Monte Carlo Logo

92 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...