Question about Subaru Legacy
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
I had the brake light switch replaced by a local dealer. Cost was $140 and it fixed the problem. Have driven the car for two weeks since and no lights and all systems normal.
Posted on Oct 15, 2008
EGR Temperature Sensor or Circuit
ABS light is nothing to do with code 55 separate fault circuits.
Under dash there are two wires with mini spades at the end, connect one of them to the single black multiplug in position 2. Thats RHS plug inlet when you hold plug with tab lock on top.
ABS sensor should then flash up error coded. Ignore code 11 thats a initial flash to let you nknow the difference between a fast and slow flash.
Let me know what code flashes up and I will tell you the symptom,
Posted on Jan 08, 2009
You need to take the jeep to a dealer or a good mechanic who can retreive the codes out of the computer. You may have a module problem but I will not guess without knowing the codes.
Posted on Feb 11, 2009
Do you hear a 'click' when the key is turned to start? Have someone try the key while you listen under the hood. It should be the starter solenoid clicking. You need either a test light or voltmeter to test further. One large terminal on the solenoid has the large wire from the battery positive, and should always show voltage/light at all times. Test the other side of the solenoid (large terminal) that is connected to the terminal on the starter motor. It should show light/voltage when the key is turned. If it doesn't, the solenoid must be replaced. If it does show light/voltage, then the starter motor is defective (probably brushes). If you get no click when turning the key, test the small terminal on the solenoid, you should see a voltage/light change when the key is turned. If you see a change, but no click, the solenoid coil is open or the case of the solenoid is not grounding where it is mounted. Try loosening the mounting and re-tighten. If no help, replace the solenoid. If you see no change at the small terminal, remove the wire from it and using a spare piece of wire, touch the small terminal to, first, the large terminal that the battery is connected to, then to the the mounting bolt for the solenoid. If the solenoid is good, the starter should operate with one of these two tests. In that case, the starter position of key switch is open--replace the ignition switch.
Posted on Sep 15, 2009
You will need to get it diagnosed to see which wheel sensor is bad.
If both the abs and the brake light are on on the speedo dont work them the module is bad.
Also make sure the tire pressures are the same
Posted on Dec 10, 2009
Tips for a great answer:
Dec 17, 2015 | Cars & Trucks
Jul 09, 2014 | 2007 Jeep Liberty Sport
Jun 25, 2014 | 2006 Subaru B9 Tribeca
Jan 09, 2014 | 2004 Subaru Outback
Jul 16, 2012 | Cars & Trucks
Sep 07, 2011 | 2004 Ford Explorer
Sep 19, 2010 | 2008 Jeep Liberty
Feb 06, 2010 | 2004 Ford Explorer
Jul 10, 2009 | 1992 Subaru Legacy
58 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: