Question about Ford Focus

1 Answer

I have a 2001 ford focus it's been in the shop numerous tmes,engine light on code says,problem with tps sensor and fuel rail sensor.engine runs ok most of the time but sometime after start up loss of power and bad hesitation occurs .kind of like engine flooding with gas. fuel rail sensor .tps jas been changed alon with sparkpluge and wires.and vacum lines

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Ford Master
  • 14,585 Answers

Some thing you should do also is change the fuel filter and check the air filter(if dirty,replace it) You can clean the throttle body also, you have to open up the plates and clean behind it as much as possible(use a tooth brush). I have done this to cars and it's better than the tune up they just got.

Posted on Nov 11, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

P0193


Recommend replace fuel rail pressure sensor, make sure connector and wiring are good, clear codes and recheck.

Jan 11, 2014 | 2005 Ford Focus ZX3

2 Answers

P0193


http://m.youtube.com/?#
Go to you tube and look for how to install fuel pressure regulator.

Jan 11, 2014 | 2005 Ford Focus ZX3

1 Answer

2001 ford focus was shut off and would not start so I replaced the timing belt using the bar and pin checked spark ok, fuel to the rail have compression but still not start ??? help


If you replaced a timing belt on a ZETEC engine, and got it right,you have mechanical ability.
My shop manual shows four pages of instructions on replacing that belt.
Assuming you have it timed properly, then it should start.
Did you make sure the fuel pump inertia switch didn't trip on it? Can you hear the fuel pump whirring momentarily when you turn it to ON'?
Keep us posted and I hope you find the problem .don-ohio

Dec 14, 2012 | 2001 Ford Focus

1 Answer

Where is the fuel rail sensor on 2005 ford focus


My engine light came off I got those codes because my car was stalling because of the fuel lines not getting fuel and plus put in good gas like the middle one will help regulate the bad gas...i have ford focus 2005 zx3 and got the fuel sensor regulator out of junkyard and now it's fine no engine light...you must disconnect battery so while changing it will reset...then go to the top of your engine look for the fuel sensor regulator right in the middle unplug remove two screws pull up but put something underneath so the fuel won't go underneath replace then connect battery and done..

jefferson sotto on Dec 31, 2014

Jul 10, 2012 | 2005 Ford Focus 1.8

1 Answer

Check engine light keeps saying check emissions sensor. the auto parts tester gave the p0193 fuel rail pressure sensor to check.


Check it

Codes Said what it is--sensor on
fuel rail, on engine

Don't understand or know how to test it,
you need a repair shop.

Feb 13, 2011 | Ford Escape Cars & Trucks

1 Answer

My 2001 Ford Focus check engine light with diagnostic trouble code PO460, Fuel Level Sensor? What does that mean and what can be done about it?


change the fuel sensor.is near the gas pump on the gas tank.cold joints on the sensor.isnt repairable you must change the sensor.

May 11, 2010 | 2001 Ford Focus

2 Answers

Ford focus 1.6 zitec petrol, engine warning light flashing, engine chugging, very high fuel consumption, fumes smell when stationary, exhaust seems ok, recently change speed sensor and coil pack?


try the air filter first and the intake.the spark plugs then and after all go to a garage for checking compression timing and the head gasket.

Apr 22, 2010 | 2004 Ford Focus

2 Answers

Acceleration problem


check your plug wires that may help.

Jul 04, 2009 | 2001 Ford Focus

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

150 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76682 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

fordexpert

Level 3 Expert

5537 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...