Question about 1992 Dodge Ram 250

1 Answer

Wiring i put a radio in my 92 d250 and i had the interior light on for a litlle bit and after about 5 minutes itwent off and made the radio mirriors and interior light not work i checked the fuses and wires their power going through them but i cant figure ouit whatr it is

Posted by on

  • 92_cummins Jun 26, 2008

    no im pretty sure i installed it did the same thing to the stock one but it would fix itself



1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Master
  • 1,010 Answers

You installed it wrong... use the manuals.

Posted on Jun 19, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How to put in a wire harness into a 1990 Dodge D250 for my radio

Do you have any radio yet?
If yes, there should be a harness.

Mar 20, 2013 | Cars & Trucks

1 Answer

Engine stops after 5 minutes of running

It sounds like the engine might be shorting itself out. make sure you take it in for a routine check-up with an auto mechanic every 6-8 months or even more frequently. It could be a problem with the degradation of wiring in the car's interior. your best bet is to take it into a shop.

Aug 12, 2012 | Cars & Trucks

1 Answer

Interior light and radio not working

It's not a fuse, It is the internal wiring, the wiring from your dome light to your wiring harness is bad.. have you recently put in an aftermarket CD player?

Feb 21, 2010 | 2000 Chevrolet Cavalier

1 Answer

Wiring drigraim for 92 BMW touring lights

you will need to e mail me at for the specific diagram their are about 20 for the lights Brake Headlight signal interior lighting module etc

Feb 04, 2010 | 1992 BMW 5 Series

2 Answers

Change puddle light , need to know how to take the lens off to change the light bulb in the mirrior of a 2003 ford expedition .

Per the '03 Owners manual...

Approach lamp bulb removal (if equipped)
To change the bulbs:
1. Make sure that all the doors are
closed and the interior lights have
automatically turned off or the
opposite mirror approach lamp has
turned off.
2. With a small flat tipped
screwdriver, insert the tip into the
approach light module slot located
on the outboard corner of the lens
to release the clip.
3. While holding the clip in the release position, pull the approach light
module down.
4. Remove the two wires from the module and replace the module with a
new one.
5. Reverse the order to reassemble the approach light module.

Jul 04, 2009 | 2003 Ford Expedition

1 Answer

Need to replace drivers side mirrior

This can be easy if you know how to pull the door panel. After it is off the mirror connects with 2 or three bolts and one power wire.

May 25, 2009 | 1997 Cadillac DeVille

1 Answer

Removing the radio disconnected the interior lights.

It sounds like the power wire fed the lights as well. Most of the time its just a piggyback and when you break the connection it disrupts anything powered by it. Although I must admit that this would be a wired wiring but stranger things have happened.

the very first thing I would check is the fuse under the dash. If you it any of the wires taking the radio out you may bhave blown the fuse that protects it and it is very common for a fuse to control and protect more than one item such as a radio , interior lights and cig lighter all at once. If the fuse is blown then problem solved. If not your going to need a tester to find out what wires are poer, negative and what goes where.


May 19, 2009 | 1992 Nissan Maxima

1 Answer

No power to radio or interior lights.

i would say because the interior does not work as well that it is a blown fuse. you will have two supplies to the radio. one permanent fuse that holds the memory and an igition fuse which is live with ignition turned on. check the permanet supply fuses because the interior light will also work off one of them, same as radio. the fuse may look good you need to test across both sides of the fuse with a 12volt tester, it should work across both sides of the fuse.

Apr 22, 2009 | 1999 Dodge Avenger

2 Answers

My interior light ,Radio is not working the fuses are good

IOD fuse replace it it worked for me i had no radio interior lights or power mirrors

Mar 07, 2009 | 1998 Dodge Ram 1500 4WD

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

91 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts


Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides