Question about 1995 Jeep Wrangler

1 Answer

Replaced water pump, thermostat and radiator on my 1995 Wrangler 4cylinder 5 speed, the gauge is in the red just after a few minutes of idling, i haven't put the fan shroud back on yet could that be it.

Posted by on

  • Efstathios Govas Nov 11, 2010

    did you have this problem before all of these repairs??

×

Ad

1 Answer

I would check the converter for blockage.

Posted on Nov 12, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Can a year-old water pump that doesn't leak or make noise just stop pumping ?


The impeller could break loose from the shaft. You would have to remove the pump to find out for sure.
Could be a blockage in one of the passages too.

Apr 13, 2015 | Cars & Trucks

1 Answer

1996 jeep cherokee temp gauge reads hot 10 mins. after start-up


If you have a viscous fan hub then have it replaced as it is not drawing air through the radiator at idle or slow speed (crawling traffic). Check that are no air locks in the system as they will cause heating problems.

Jan 09, 2014 | Cars & Trucks

1 Answer

Help ford ikon 1600 overheating after i replaced thermostat housing cleaned radiator replaced water pump replaced thermostat with another new one but still gauge moves to hot and fan comes on


check that you put the thermostat in the right way. The body of the unit has to be in the head / block water. Simple check is to start from cold and within 5-10 minutes idling you should start to feel hot water coming through the top radiator hose.. If in ok the bleed the air out of the cooling system by loosing off the highest hose and let the air out until you get solid water flow . Run the engine while doing this so that the water is circulated by the pump. Make sure that the heater core is open to allow the air in it to be removed

Jan 04, 2014 | Cars & Trucks

1 Answer

2001 Oldsmobile Silhouette...Overheating, changed the thermostat, no signs of leaking, and the oil looks fine. At idle it takes 20 minutes to max the temperature gauge (red) and while driving it take


Usually the problem with no heat and overheating is low coolant, thermostat, or a faulty water pump impeller.
The radiator may not be full of liquid coolant, or the pump may not be moving the coolant thru the block.

Feb 19, 2013 | 2001 Oldsmobile Silhouette

1 Answer

How do i replace the water thmostat 99 6 cylider


WELL YOU NEED TO DRAIN COOLANT LEVEL BELOW THERMOSTAT LEVEL.YOU HAVE TO DISCONNECT MAF SENSOR LOOSEN AIRDUCT 2 LARGE CLAMPS LOOSEN REMOVE 4 SCREWS TO AIR FILTER COVER LIFT UP REMOVE COVER. THEN REMOVE AIR FILTER AND HOUSING, FIRST DISCONNECT MAF SENSOR.YOU HAVE TO DISCONNECT THROTTLE CABLE AND SHIFT CABLE.YOU HAVE TO DISCONNECT REMOVE THROTTLE BODY COOLANT HOSES DISCONNECT IDLE SPEED CONTROL VALVE CONNECTOR AND DISCONNECT TPS SENSOR CONNECTOR. THEN REMOVE THROTTLE BODY ASSEMBLY. YOU NEED TO BUY NEW THROTTLE BODY COOLANT HOSES AND NEW THROTTLE BODY GASKET FOLLOW TOP COOLANT HOSE TO ENGINE BLOCK.NOW YOU SEE CAN AND REMOVE THE THERMOSTAT HOUSING REPLACE THE THERMOSTAT.BESURE TO HAVE EXTRA COOLANT ON HAND.BLEED COOLANT SYSTEM WHEN DONE.TO BLEED COOLANT SYSTEM REMOVE RADIATOR CAP ON OVERFLOW JUG.THEN OPEN BLEED SCREW ON THE WATER PUMP BYPASS HOSE PIPE JUST A LITTLE.POUR COOLANT IN THE OVERFLOW JUG UNTIL LEVEL STOP DROPPING.STOP AT COLD MARK ON JUG.CLOSE BLEEDER SCREW ON WATER PUMP BYPASS HOSE PIPE.CRANK VECHICLE CHECK FOR LEAKS. START UP ENGINE LET IDLE FEW MINUTES THEN CHECK COOLANT LEVEL ADD MORE UNTIL UNTIL LEVEL STOP DROPPING.PUT RADIATOR CAP BACK ON OVERFLOW RESERVOIR. LET ENGINE IDLE WATCH COOLANT TEMPERATURE GAUGE.WHEN GAUGE START CLIMBING. TURN OFF ENGINE WAIT FEW MINUTES TAKE A LARGE RAG OPEN RADIATOR JUST A LITTLE YOU HEAR HISS NOISE.WHEN PRESSURE STABILIZE DONT GET SCALDED BECAREFUL.OPEN CAP LITTLE MORE.IF COOLANT PRESSURE STILL BOILS OUT WAIT 20 MINUTES ADD MORE COOLANT TO RADIATOR OVER FLOW WHEN COOLANT LEVEL STOP DROPPING.PUT RADIATOR CAP BACK ON START VECHICLE UP LET IDLE UNTIL THERMOSTAT OPEN. THEN FEEL TOP RADIATOR HOSE FEELS HOT THERMOSTAT OPEN WATCH TEMPERATURE GAUGE.IF GAUGE TEMP START CLIMBING TURN OFF ENGINE WAIT A WHILE.CHECK AND ADD MORE COOLANT.WHEN THE ENGINE CAN IDLE TEMP GAUGE STOP CLIMBING YOU HAVE BLEED COOLANT SYSTEM.KEEP CHECK ON COOLANT LEVEL.

Dec 29, 2010 | 1999 Oldsmobile Alero

1 Answer

Gauge reads Hot but truck doesn't appear to be overheating - help


is antifreeze dirty looking and if was changed was it chemically flushed?

Jul 06, 2009 | 2002 Nissan Frontier Crew Cab

2 Answers

1993 Acura Legend Overheating.


This could happen if your fan is indeed weak.  To test disconnect the thermostat of the radiator by removing the terminals near the radiator hose towards the engine.  You should see the fan run at its highest speed, then you can check if your fan has weakened.

Jun 07, 2009 | 1993 Acura Legend

2 Answers

Car overheats at idle, ok when at speed


You will need to Change your Thermostat. A bad Thermostat will cause the Overheat Problem as Stated above. Also, Check you Coolant Level, and see if the Water Pump is Pumping Water through the Radiator. Please Rate my Response, I need all the Help that I can Get! Thanks!

Jan 26, 2009 | 1993 Saturn SL2

1 Answer

Running Hot


Sounds like the water pump.Check if you see coolant or coolant residue behind the water pump pulley.

Dec 06, 2008 | 1995 Subaru Legacy

1 Answer

Oil pump replacement


That is just condensation. Usually if you have a cracked water jacket you will get white smoke out of the exhaust rather than raw water\\

Sep 07, 2008 | 1995 Jeep Wrangler

Not finding what you are looking for?
1995 Jeep Wrangler Logo

Related Topics:

71 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...