Question about 1999 Mercury Grand Marquis

Open Question

HARD TO FILL FUEL TANK - 1999 Mercury Grand Marquis

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2011 Chevy Cruze I fill it with gas and it has a hard time starting after what does that mean


Some vehicles, if you top off the tank after the fill valve clicks off, have a tendency to have issues with the evap system properly venting the tank. This can cause starting issues. It is also possible that you may be having issues with the fuel pump, as the fuel coming from the underground tank will be in most cases colder than the fuel in the tank, although this is not as likely. See this Youtube video for more information.
Car hard to start after pumping gas Auto Information Series

Nov 20, 2015 | Cars & Trucks

1 Answer

Hard to fill fuel tank


Fill by pressing half way, and give chance for the air in the tank to escape out.

Oct 26, 2015 | Cars & Trucks

1 Answer

How To Drain Fuel Tank On 2005 Jeep Liberty Gas Tank


here is the Cherokee page.
read chapter, 14, page 19 on..
shows all way there, and is not easy.
why do this.
is pressure low
pump dead
is there 12vdc to pump cranking, (no? then dont do this)

http://www.jeep4x4center.com/knowledge-base/index.htm?utm_source=cj#service

i have the KJ pages here. (line # messed up)
Two different procedures may be used to drain fuel
tank: through the fuel fill fitting on tank, or using a
scan tool.
The quickest draining procedure involves removing
the rubber fuel fill hose (7) (Fig. 25) from fuel tank
fitting.
As an alternative procedure, the electric fuel pump
may be activated allowing tank to be drained at fuel
rail connection. Refer to DRB scan tool for fuel pump
activation procedures. Before disconnecting fuel line
at fuel rail, release fuel pressure. Refer to the Fuel
System Pressure Release Procedure for procedures.
Attach end of special test hose tool number 6541,
6539, 6631 or 6923 at fuel rail disconnection (tool
number will depend on model and/or engine application).
Position opposite end of this hose tool to an
approved gasoline draining station. Activate fuel
pump and drain tank until empty.
If electric fuel pump is not operating, fuel must be
drained through fuel fill fitting at tank. Refer to following
procedures.
(1) Release fuel system pressure.
(2) Raise vehicle.
(3) If equipped, remove fuel tank skid plate.
(4) Thoroughly clean area around fuel fill fitting
(6) (Fig. 26) and rubber fuel fill hose (1) at side of
fuel tank. After cleaning, loosen fuel fill hose clamp
(2) at tank.
(5) Before removing rubber hose (1) (Fig. 26) from
fitting, note hose orientation while referring to marks
(3) and (4).
6) Disconnect rubber fuel fill hose at fuel tank fitting
(2) (Fig. 27). Using an approved gas holding
tank, drain fuel tank through this fitting.
Tank Removal
(1) If equipped, remove fuel tank skid plate and
tow hooks. Certain equipment packages will also
require removal of the trailer hitch. Refer to Tow
Hooks, Trailer Hitch or Skid Plate in 23, Body for
removal/installation procedures.
(2) Disconnect and separate fresh air tube (6) (Fig.
28) quick-connect fitting.
(3) Disconnect air tubes at front of NVLD pump
(9) (Fig. 28).
(4) Disconnect NVLD pump (9) (Fig. 28) electrical
connector.
(5) Disconnect fuel pump module electrical connector
jumper. This is located near front of fuel tank.
(6) Support tank with a hydraulic jack.
(7) Remove 4 fuel tank strap bolts (10) (Fig. 28) (2
at front of tank; 2 at rear of tank), and remove both
tank support straps.
(8) Carefully lower tank a few inches.
(9) Continue lowering tank while guiding remaining
hoses and lines through plastic isolator sleeve (3)
(Fig. 29).
(10) If fuel tank is to be replaced, remove NVLD
pump and fuel pump module from tank. Refer to
Fuel Pump Module Removal/Installation procedures.
end , tank out.

why not login to alldata.com and read
or buy the FSM,, and get all pages of chapter 14, end to end.

Oct 19, 2015 | 2005 Jeep Liberty

1 Answer

How do I fix the problem of my 2004 SV6 commodore being hard to start every time I fill the tank with fuel. The problem disappears once it starts until the next time I fill the tank.


you need to replace the canister purge valve it is stuck open and is allowing fuel vapors to fill your intake manifold and causes a flooding issue which takes the engine longer crank time to clear out the vapors.

Jan 04, 2015 | Cars & Trucks

1 Answer

P0446 2007 gmc yukon


Always Google any codes you get & read up

PO446-Evap System Vent Control Circuit Malfunction

If the Evap Vent Valve or it's control circuit are bad, then
you can't fill the fuel tank

Mar 04, 2013 | 2000 GMC New Sierra 1500

1 Answer

Can't put fuel in tank


The fuel tank fill tube or fill tube vent pipe for the fuel tank is either clogged with something or the anti-siphon feature (what stops people from stealing your gas) is fouled up. The tank and fill tube have to be inspected.

Oct 03, 2012 | 1999 Lincoln Town Car

1 Answer

My legend is hard to start after i go places and try to start it back after half hour it dont want to start


AIR FILTER CLOGGED, CLEAN FUEL INJECTORS FILL UP GAS TANK 3/4 TO FULL TANK OF GAS POUR BOTTLE OR CAN OF SEAFOAM IN FUEL TANK SEE IF IT HELPS PROBLEM.

Aug 09, 2011 | 1991 Acura Legend

1 Answer

Fuel pump not working?


Have someonde turn the key to on position not start and listen for humming of fuel pump above gas tank in trunk or put ear to gas tank. May only run for a short time to build fuel pressure. No sound, check fuse. Fuse blown, filter screen in tank or fuel filter clogged making pump run hard. Prevelent from using dirty gas cans to fill tank. Please rate answer.

Jun 26, 2010 | 1999 Chevrolet Prizm

1 Answer

Can't fuel xg350 2002 at gas station difficult


there is a tube that runs along side the filler neck to the gas tank, this tube allows air to escape from the gas tank as you fill it, if it gets kinked or obstructed then you have a hard fill situation, pull the filler neck/vent assembly out and replace it.

Apr 09, 2009 | 2002 Hyundai XG350

2 Answers

Fuel in my van


Im having a similar issue except sometimes i can fuel up and sometimes i cant. Have you tried fueling up again with out issue

Jun 04, 2008 | 2005 Dodge Grand Caravan

Not finding what you are looking for?
1999 Mercury Grand Marquis Logo

Related Topics:

33 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

fordexpert

Level 3 Expert

5546 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...