Question about Nissan Altima

1 Answer

I need an exploded view diagram of a 2003 nissan altima's front drivers side door { window assembly}.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Nissan Master
  • 17,970 Answers

Altima
Window Motor, Regulator & Switch - Removal & Installation

Front

I need an exploded view - zjlimited_56.jpg

Fig. View of power window components (click for zoom)

zjlimited_57.jpg

Fig. Locating window regulator

  1. Before servicing the vehicle, refer to the Precautions Section.
  2. Remove the door speaker.
  3. Temporarily reconnect the power window switch to the door harness.
  4. Operate the power window switch to raise/lower the door glass until the door glass bolts can be seen.
  5. Remove the door glass bolts.
  6. Raise the door glass up into the door frame/channel and hold in place with a suitable tool.
  7. Remove the module assembly bolts and the module assembly.
  8. Disconnect the harness connector for the module assembly, and disconnect the harness clip from the back.
  9. To install, reverse removal procedure.

Hope helps.

Posted on Nov 11, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I put the driver side power window back on track and the door panel for my 2003 Nissan Altima 3.5SE?


R/R the inner door panel, slide the window back on track, reconnect the window transmission to the window, (or reinstall the trans) bolt everything back together (window motor, window trans to door etc.) Make sure the window is in the UP position. use the switch to raise the window & keep it up if all is back together before finally installing the door panel ( make sure the switch & other plugs are plugged in before the door panel is reinstalled.) Lights etc. Good luck

Sep 14, 2014 | 2003 Nissan Altima

1 Answer

While Driving My Nissan Altima there is a static noise coming from the front driver side


Check door and window weatherstripping for gaps and wear that will allow the wind noise.

Apr 20, 2014 | 2008 Nissan Altima Hybrid

1 Answer

1994 Nissan Altima: Passenger side front power window will not go up or down. Passenger switch tested good but has no effect on window when connected. Was able to "hot wire" power window motor direct...


It can be either switch or any of the wiring in between. You have to follow a wiring diagram to test the circuit and this one is a bit complicated.

Aug 29, 2013 | 1994 Nissan Altima

1 Answer

How do you jump the window motor to get it up on a 2003 nissan altima


There should be connection to the window motor inside the door panel. Disconnect it and run two leads from the battery.. One on negative one on positive. touch the leads from the motor with the leads from the battery. reversing the positive and negative leads, change the direction the motor turn.

Mar 18, 2012 | 2003 Nissan Altima

1 Answer

Replacing the gas fill tube on a 2003 Nissan Altima


I'm not quite sure as to what your question is but I went on and gave you some exploded view pictures of that area of your vehicle. I hope this what you were needing.


clifford224_854.gif


clifford224_855.gif

Jun 19, 2011 | 2003 Nissan Altima

1 Answer

The trunk latch fell off of my 99 nissan altima, and i'm not sure how to put it back on. need a assembly diagram for it.


Good luck with that. Trunk latches are usually only held on with 2 to 4 bolts. If you need a diagram, the best place to look would be a dealer parts department. There are no service manuals that will give this to you and the parts diagrams at the dealer will only show you an "exploded" view for ordering parts - it won't show you how to assemble it.

Mar 26, 2011 | Nissan Altima Cars & Trucks

1 Answer

Drivers side front window rolled down fine but now will not roll up. All other windows are operating fine.


It is likely the switch on the door panel that controls that window. It could also be the window motor, but that is much less likely.

Jul 27, 2009 | 2003 Nissan Altima

2 Answers

The driver side door will not lock - the other doors lock and unlock using the electronic key, but the driver side door will not ock either electronically or using the key.


the lock mechanism itself of the driver side door is the problem.

you may try lubricating the lock mechanism and you might un-tangle what is binding in there.

something could have stuck in the locking mechanism.

tnx 4 using fixya,

drcool

Oct 31, 2008 | 2003 Nissan Altima

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

928 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...