Question about 1995 Nissan Maxima

1 Answer

I need serious help! Not a single mechanic has been able to solve my problem! After a night of resting, when I start my 95 Maxima up, it starts up fine. As I drive and as the engine warms up, the car will start to skip. As the driving continues, I experience all of the following issues: 1. There is very little acceleration and the harder I press the gas, the RPM needle goes down and the car will threaten to shut off or it will shut off if I continue to hold it down. 2. It shuts off when I come to a complete stop at the light. 3. When I press on the gas, the engine won't pass 2,000 RPM. 4. I hear a grungy jumping noise when I press on the gas. 5. Often, when I press on the gas, the car will go, stop, go, stop, and eventually go skipping along the way. What is wrong?

Posted by on

  • whittaker_ch Nov 11, 2010

    WOOOOOOOOOOOOOOOOOOOOWWWWWWWWWWWWWWW!!!!!!!!!!!!!!! YOU WERE RIGHT!!!!! I can not believe that after all of this time, energy, and money that it was something as simple as that! When I unplugged it, the situation didn't change. When I plugged it in though, it worked PERFECTLY! So I basically learned that either the wire has a shortage or it is not sitting on there securely. Either way, I'm going to replace that wire. Nevertheless your answer has led me to the solution! This has been a great help! I am about to talk about this website to EVERYONE! Thank you so much!!!

  • whittaker_ch Nov 11, 2010

    THE SOLUTION WAS VERY HELPFUL!!!! He provided the exact solution to the problem that I have been searching for for months! I have spent so much money, time, and effort into trying to fix the problem and he solved it in a few short minutes! Not a single mechanic that I took it to was able to solve the problem! Thank you so much! This was a great help! I am about to talk about this website to EVERYONE!!!

×

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 2,299 Answers

The mass air flow sensor is more than likely causing the problem. The mass air flow sensor is on the hose that runs from the air filter box to the fuel injection. Try to unplug the electrical connection to the mass air flow sensor and drive the car. The mass air flow sensor works like a choke. It controls the air to the engine. It sounds like your engine is not getting enough air once it is given throttle.

Posted on Nov 11, 2010

  • Rodney Clark
    Rodney Clark Nov 11, 2010

    That is great! I am glad I could help!

  • Josiah Bowen Dec 30, 2010

    do you think you can helpme i think i am having the same problem i press on the accelerator and it wil do a 123....then go bak to 123 over and over agiann...

×

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Is there an OBD1 readear for a 95 Nissan Maxima?


In rare cases your 1995 Maxima might use OBD2 but it is probably a OBD1. You could try an OBD1 reader but unfortunately OBD1 was not anywhere as useful for diagnostics as the OBD2.
SOLVED What scan tool do need 95 Nissan Maxima

Feb 22, 2015 | 1995 Nissan Maxima

1 Answer

My 95 maxima was just cuttn out on me and would go dead but usually move battery cables a little and it would crank, however we changed cable ends on battery, crank it and dtove doen the road, it went dead...


Battery went dead? If this is the case you probably have a dead short.Should pull starter possibly bad solinoid, My old Maxima had caused me similar issue, if you pull starter it usually can be tested at a local Auto parts store. In a vehicle that fails to start, the common problems are the starter solenoid and the starter motor. The starter assembly can be quickly pulled from a 1995 Nissan Maxima, and then can be further separated to replace one part of the starter assembly.The process does not require any special tools, and can be done by novice mechanics

Dec 28, 2011 | 1995 Nissan Maxima

1 Answer

My 95 Nissan Maxima suddenly won't start. It clicks multiple times when i first try to turn it over then seems to loose power. I can here the relay making noise and my headlights dont seem to dim when


does the car turn over or do you get nothing at all...cos your ignition switch could be bad....it takes me five minutes to start my 95 maxima up cos of this problem..

Oct 26, 2011 | 1995 Nissan Maxima

1 Answer

My car was make a winding sound and the air in it


could be alternator has packed up and its not charging which is why it jump starts then dies

Jun 14, 2010 | 1995 Nissan Maxima

1 Answer

The airbag lamp started flashing after


you will have to take it to a mechanic that can reset the light when charging you may have caused a fault code to come up with low voltage.

Nov 12, 2009 | 1998 Nissan Maxima

1 Answer

95 nissan maxima wont start


I had a 94 which i fixed this same type of problem by putting in a new distributor

Aug 26, 2009 | 1995 Nissan Maxima

1 Answer

95 maxima hard to start


Remove the high tension cable to the distributor from the ignition unit. Conduct a spark test. If there's no spark, try to replace the ignition coil or the igniter.

May 28, 2009 | 1995 Nissan Maxima

2 Answers

My 95 nissan maxima shifts hard from first to second then shifts good the rest of the gears


Look into issues with the throttle position sensor, i had the same problem with a 95 se. The sensor is directly responsible for shift intervals as it gives the ecm throttle position which doesnt go hand and hand with rpm. Sometimes the sensor needs adjustment, however this is not recommended if you dont have a scan tool to reset your ecm. check this page out

www.vqpower.com/v2/articles.php?article_id=95

Apr 01, 2009 | 1995 Nissan Maxima

1 Answer

2001 Nissan Maxima SE-rattling noise for 4 min after start


This only happens when the Car is Cold???? It is the Exhaust Manifold. You need to Replace the Exhaust Manifold Gasket and check the Rest for Tightness.

Jan 20, 2009 | 2001 Nissan Maxima

1 Answer

Wont Crnk


did ya get it goin???? havent heard from you???????

Oct 26, 2008 | 1995 Jeep Cherokee

Not finding what you are looking for?
1995 Nissan Maxima Logo

Related Topics:

402 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

76682 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...