Question about 2001 Dodge Caravan

1 Answer

Car starts but when put in drive will not engage

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 3,911 Answers

I think you need a transmission guy to take a look at it. Could be as simple as a broken connector on the linkage between the gear selector and the transmission or a major failure.

Posted on Nov 11, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

96 ford ranger starts popping in passenger front end when you put in 4wheel drive and let out on clutch.


the hub actuator for the drive at the hub is either no engaging correctly or is failing in the engagement allowing it to jump in and out of engagement
check for full engagement or replace worn or broken parts in the hub drive

Jan 23, 2016 | Ford Cars & Trucks

1 Answer

Car in park turn key starter engages engine starts and you can hear the Bendix still spinning in the ring gear put car into drive and then they stop spending


Does the starter engage again when you go back to park ?
Shifting from park to drive would cut the circuit from the key switch to the starter. The neutral safety switch prevents you from cranking the engine in drive or reverse.
I would say the key switch is not turning off power to the starter when you go from start to run.

Sep 14, 2015 | Cars & Trucks

1 Answer

Whats the procedure for engageing the 4 wheel drive on a 2004 chevy Silverado HD 2500 with automatic transmission


The best way is to take your time...,Set Emerg brake,start vehicle and put into neutral..Engage 4 wheel drive,look at your dash gauge area for 4 wheel drive light to come on..Put truck in reverse and release park brake..,Back up 10ft.slowly..Then put it in drive and pull up 10 ft.slowly then you should be in four wheel drive..

Feb 21, 2015 | 2004 Chevrolet Silverado 2500HD

2 Answers

My chevrolet transport is no longer engaging gears, when i put it on drive or reverse gear, it doesnt engage


check fluid level in transmission . run the fault codes and look for a faulty TCM or torque converter clutch solenoid / servo

Mar 20, 2014 | 1999 Chevrolet Venture

1 Answer

Put in drive or reverse it stalls sounds like torque converter locked


band or a servo piston is jammed, either way req an experienced auto mechanic.

Jan 17, 2013 | 2001 Toyota Celica

1 Answer

Gear shifting is having issues. Neutral is reverse, have to put in 3rd gear to drive, if u put in drive the car won't go. Now, car won't start and if u put it in any gear it thinks it is in revese just by...


This is a factory defect.My unit started to fail at about 80k.It finally got to the point that I had to pull the entire shifter vertically to engage the shifter.And then it happened.......it would not engage.It took me two hours of fiddling with it to get it in reverse.Then another twenty minutes in the street for drive.Finally got it to the dealer where it was replaced under extended warranty.You might as well get it over with.

Sep 17, 2010 | 2004 Lincoln Aviator

1 Answer

Transmission will not engage and slips when it does engage


auto trans operates on fluid pressure. if the trans has never been serviced, more than likely the filter is plugged, and or the fluid is bad. no doubht its burned and will smell and look like it. get it towed to a shop and have the fliud and filter changed first, then check the band adjustment.recommend a trans shop do it and not jiffylube.

Jul 20, 2009 | 1995 Dodge Avenger

1 Answer

Will not engage into park and will not start now


The vehicle should start if you put the transmission into neutral. I would try to let the car roll just a hair, apply the brake pedal and put the car into park.

May 30, 2009 | 2001 Mercury Mountaineer

1 Answer

Will not engage into 4wheel drive


Start Vehicle with engine running push on BRAKE and with feet firmly on brake put vehicle in NEUTRAL. Keeping foot on brake try to engage 4x4 should work. If I fixed-ya leave ma FIX-YA comment thanks

Dec 19, 2008 | 1995 Kia Sportage

Not finding what you are looking for?
2001 Dodge Caravan Logo

Related Topics:

55 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8172 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...