Question about 1989 Chevrolet Corvette

1 Answer

How much time does it take to replace a fuel pump on a 1989 chevy corvette. How do you do it

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chevrolet Master
  • 14,585 Answers

About an hour, Open the lid where you put the fuel, there are four screws that you have to remove, remove the lid, pull the rubber boot out and there is the pump sending unit. remove the eight or ten bolts and pull the unit out. replace the pump and install in reverse order. These are the easiest ones I have done. You can do it.
Randy

Posted on Nov 11, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Have no spark on my 1989 corvette 5.7l replaced just about everything


Check whether the COIL WORKS, and also CHECK or replace the CAPACITOR next to the coil----it's cheap.

Sep 20, 2012 | 1989 Chevrolet Corvette

1 Answer

89 corvette hard to start after setting a day or two act like not getting fuel


Check your fuel pressure it should be 40-47 with the key and engine off and 30-44 with engine running.If its not within these specs then replace the fuel pump and filter.

Aug 08, 2011 | 1989 Chevrolet Corvette

1 Answer

I have a 1989 corvette with greenwood package that cranks for about 50 seconds before it will fire, runs at a ruff idle, and after it is hot and running for awhile it will shut off and be really hard to...


The only part that would come to mind after all of this would be the fuel pump relay. This is located on the fire wall on the drivers side of the car. When that goes bad it does not allow for adequate fuel to cycle through.The other thing would be timing. You need fuel air and spark for the vehicle to fire. After all the test and after replacing the fuel pump relay. I would do a compression and a leak down test. Are you sure that the timing did not jump a gear? You can also look and test the IAC (Idle Air Control) or the MAF (Mass Air Flow Sensor). Also do a test to check fuel pressure. The last Corvette that I worked on personally that had this issue it turned out to be the Fuel Pump Relay. Good luck let me know if you have any further questions.

Jun 16, 2011 | 1989 Chevrolet Corvette

1 Answer

I need to know how to replace a fuel pum in a 1989 corvette


is the pump inside of the fuel tank ... or outside.. if inside the tank usually has to be taken out if the pump is an external electric pump it is somewhere along the fuel line if it is mwchanicle it is on the engine block

Apr 08, 2011 | 1989 Chevrolet Corvette

1 Answer

1989 corvette runs rough surges between 600 and 700 rpm. drive it for 20 minutes it totally runs awful. had to have it towed the other day..waited two hour for flatbed started car and it ran again..code 44...


try replacing the fuel regulator,that would make it get too much fuel and the code for o2 sensor will come on saying too lean or too rich fuel mixture,and it would run rough

Feb 14, 2010 | 1989 Chevrolet Corvette

1 Answer

How to replace a fuel pump on a 1986 chevy corvette


fuel pump is in fuel tank remove tand and take pump out of top of tank were hoses and fuelguage sensor hooks up

Nov 11, 2009 | 1986 Chevrolet Corvette

1 Answer

Tom fuel pump on 1989 chevy 2500 truck sometimes


weak pump possible,wiring would ber all the time,relay could be relay its the cheapest part so id start there

Aug 23, 2009 | 1989 Chevrolet C1500

1 Answer

INSTRUCTIONS TO INSTALL FUEL PUMP ON 1989 CORVETTE


REMOVAL
  1. Relieve fuel system pressure.
  2. Disconnect battery ground cable.
  3. Remove fuel filler door.
  4. Remove fuel cap.
  5. Remove fuel tank filler neck housing and disconnect drain hose.
  6. Remove screws attaching fuel meter/fuel pump to tank.
  7. Disconnect fuel lines, fuel vapor line and electrical connector.
  8. Remove fuel meter/fuel pump and gasket.
  9. Replace fuel pump.
INSTALLATION
  1. Reverse procedure to install.

Jul 27, 2009 | 1989 Chevrolet Corvette

Not finding what you are looking for?
Cars & Trucks Logo

263 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

80407 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...