Question about 1994 Ford Ranger Supercab

Open Question

How do I remove radiator suppor from 94 ford ranger

Posted by on

  • global1207 Nov 11, 2010

    UPPER RADIATOR SUPPORT, LOWER RADIATOR SUPPORT, or RADIATOR SUPPORT ASSEMBLY?
    This isn't a job for novices. The car has to be pulled first, in frame alignment shop and you must know the coordinates of the front clip before installing the new one.
    THE ANSWER IS DRILL OUT ALL WELD SPOTTING POINTS.

×

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
chrischronic
  • 235 Answers

SOURCE: Replace thermostat in 2000 ford ranger

the open pipe that you took the hose off of is the thermostat housing, you will need to remove this to reveal the thermostat, make sure you use a new gasket with sealant when reinstalling thermostat housing to prevent leaks and dont over tighten the bolts,run both bolts down as far as you can before final tightning

Posted on Dec 26, 2008

Ad
  • 1 Answer

SOURCE: ford ranger truck overheating

I have had this happen with my ranger. Changed everything I could to try to fix the over heating. It turned out that I had a small leak in my head gasket and it was allowing exsaust gas to go into the cooling system witch was over pressurizing it. Also the air from the exsaust will heat up much faster than liquid making your thermostat to read hot and will not be able to blow hot air in the cab because there is no liquid going to the heater core. This happened to me when my blet came off and I tryed to make it home. If you had it over heat for a long peirod of time it may have ripped the head gasket.

Posted on Feb 21, 2009

daves944
  • 1050 Answers

SOURCE: firing order on a 94 ford ranger 3.0

Sorry, that supposed to be under solutions.a79bdf6.jpg

Posted on Mar 26, 2009

mcgyver468
  • 710 Answers

SOURCE: How to remove fan clutch on 94 Ranger 4.0?

THERE IS A SPECIAL TOOL THAT CAN BE RENTED OR PURCHASED AT YOUR LOCAL AUTO PARTS STORE. IT CONSISTS OF A LARGE OPEN END WRENCH AND A LONG FORK-LIKE TOOL THAT GRABS THE NUTS ON THE FAN SO THAT THE WRENCH CAN LOOSEN THE LARGE NUT THAT HOLDS THE FAN CLUTCH TO THE FAN. I HOPE THIS HELPS. THANKS FOR USING FIX-YA AND FOR AN HONEST RATING. P.S. BE SURE TO LOOK AT THE NEW CLUTCH TO FIND OUT WHICH DIRECTION THE THREADS GO. SOME OF THESE ARE LEFTY TIGHTY, SOME ARE LEFTY LOOSEY. GOOD LUCK

Posted on Aug 22, 2009

Testimonial: "Very Helpful "

  • 63 Answers

SOURCE: to remove a front axle shaft 94 ford ranger remove

you shouldn't have to remove anything else, unless it is in your way, one end of the shaft should just come out of the spindle, after you beat it with a hammer...lol, but seriously, and then the other side you need a special tool it is a 2 prong fork, to pry between the tranny and the shaft, and that should get it out.

Posted on Aug 08, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Location of the park gear in a 94 Ford Ranger


Get that from ATSG.Com or local
trans parts supplier, that the shops buy from

Jun 21, 2012 | 1994 Ford Ranger Supercab

1 Answer

How to replace the water pump on a 1984 ford ranger 2.8 litr


I just did one on a 94 "almost identicle engine"

This is the way I did it:

drain coolant-remove upper radiator hose-loosen fan bolts '4 bolts attaching it to the water pump'-remove serpentine belt-finish uninstalling the fan- remove 2 bolts securing the fan shroud to the radiator and it should slide out with the fan-remove pump 'be sure to clean the mating surface of the block before sealing with silicone and gasket to ensure it doesn't leak'

reverse the process for installation.


NOTE: if I were you, id replace the timing belt while your in there since the timing cover is nearly impossible to get off without doing this same procedure.

Good luck.

Feb 09, 2011 | 1984 Ford Ranger

1 Answer

Ford ranger 2001 2.3 Ihave to replace the thermostat, What is involved/


2001 Ford Truck Ranger 2WD 2.3L MFI DOHC 4cyl
  1. Drain the cooling system.
  2. Disconnect the radiator hose and the electrical connector.
  3. Disconnect the radiator lower hose.
  4. Remove the bolts and the thermostat housing.
  5. To install, reverse the removal procedure. Tighten the housing bolts to 89 inch lbs. (10 Nm).

Hope helps (remember to rate and comment this).

Oct 01, 2010 | 2001 Ford Ranger Regular Cab

1 Answer

How to install Pwr Steering in 94 Mazda B2300 (same as Ford Rngr)


You'll also need to change the steering box. The stock axle should be okay to use. Be careful hooking up the new box and make sure it is centered, the same number of turns to the stop when you turn it left or right. Also make sure the pitman arm is the same length, on the Ranger, so the front end isn't out of whack, and check the clearance at the radiator and fan. Hope this helps.

Aug 09, 2009 | 1990 Ford Ranger SuperCab

1 Answer

How to change blinker light bulb


94 ranger is all I have. Maybe similar

Parking, Turn and Front Side Marker Lamps, Ranger Removal and Installation
  1. Remove one nut that attaches the parking lamp to the opening panel in radiator grille .
  1. Pull parking lamp away from vehicle to disengage the two barbed retainers.
  1. Twist the lamp socket and remove from lamp. For installation, follow removal procedures in reverse order.

Mar 09, 2009 | 1991 Ford Ranger Supercab

2 Answers

94 ford ranger temp rises and falls constantly


Does it ever get above 210 degrees F? If not, don't worry about it.

Nov 22, 2008 | 1994 Ford Ranger Supercab

Not finding what you are looking for?
1994 Ford Ranger Supercab Logo

Related Topics:

112 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

77186 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

fordexpert

Level 3 Expert

5575 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...