Question about Kia Sportage

1 Answer

Need location of coil and ignition module - Sportage Kia Cars & Trucks

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Master
  • 1,672 Answers

Modern car nowadays have their coil inside the DISTRIBUTOR assembly! Everything about the ignition is in there. Module is under the distributor rotor! Taaah!

Posted on Nov 11, 2010

Testimonial: "thank you I thought I had it right but thanks for conferring"

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: ignition module wires to coil pack

found a good repair manual and followed the wiring diagram ~~~ Thank You / Jeff

Posted on Aug 31, 2008

wyatt1582
  • 453 Answers

SOURCE: ive changed coil pack,crankshaft sensor, couold it be ignition control module

TFI module located : bolted to the bottom of the distributor when the TFI module gets hot it will cause the car to shut off and it won't start until the part cools off or until the part does not work anymore. Part cost about $25 - $40.

Posted on May 06, 2009

  • 1 Answer

SOURCE: locate ignition module on 1999 rodeo,3.2L V6 with coils on plug

changed timing belt on my 2000 rodeo.since then cylinders 2,3 and 5 on right side of engine will not fire.I HAVE CHECKED THE COILS AND AM GETTING SPARK.ALSO DID A COMPRESSION TEST AND AM GETTING ABOUT 150PSI FROM EACH CYLINDER.RECHECKED TIMING MARKS SEVERAL TIMES.A MECHANIC I KNOW TOLD ME THAT IT MIGHT BE THE IGNITION MODULE IS BAD.DO NOT WANT TO BUY ANEW MODULE AND FIND OUT THAT'S NOT THE PROBLEM.APPRECIATE ANY INPUT.

Posted on Dec 30, 2009

  • 58 Answers

SOURCE: location of ignition coil

the coils and module are located together in upper rear of engine. Follow the plug wires

Posted on Jan 08, 2010

csmock132
  • 4669 Answers

SOURCE: how to install ignition module on1995 buick

The ignition module is under the coils. It is what the coils plug on to. To replace it removal all the coils and unplug it.

Posted on Jul 31, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Location of ignition control module 2001 cadilac deville


Ignition Coils/Modules
The electronic ignition system uses an individual ignition coil for each cylinder. There are two separate ignition module assemblies located in the camshaft cover of each cylinder bank. Each ignition module assembly contains an ignition control module and four ignition coils. Each ignition coil connects directly to a spark plug using a boot. This arrangement eliminates the need for secondary ignition wires. The ignition module assemblies receive power from a fused ignition feed. Both ignition module assemblies connect to chassis ground. A Reference Low and four ignition control (IC) circuits connect each ignition module assembly to the PCM. The PCM uses the individual IC circuits to control coil sequencing and spark timing for each ignition coil. The IC circuits transmit timing pulses from the PCM to the ignition control module to trigger the ignition coil and fire the spark plug. The PCM controls ignition system sequencing and timing events

Dec 05, 2015 | 2001 Cadillac DeVille

1 Answer

Where is the icm high voltage module located on a 1999 chevy express 2500?


What engine does yours have ? 4.3 - 5.0 - 5.7 L An just to get this straight , The ICM high voltage module is ? If you would like help you need to get your terminology correct !
ignition control driver (ICD) module. ,no high voltage module !
The enhanced ignition system used on all OBD II engines somewhat resembles the current distributor ignition (DI) system described in the ignition systems. However, the system has been greatly enhanced in order to make it compatible with the new OBD II regulations. The enhanced ignition system provides a spark at precisely the correct time in order to ignite the air and fuel mixture for optimum performance and fuel economy. The system consists of the following components:
?€¢
Vehicle control module (VCM)


?€¢
Distributor


?€¢
Ignition coil driver module


?€¢
Ignition coil


?€¢
Crankshaft position (CKP) sensor


Ignition Control Module
Top RH side of engine
Engine Controls Component Views
Engine Controls Connector End Views
Ignition Coil
Top RH of engine.

Sep 25, 2015 | Cars & Trucks

1 Answer

Where is the ignition modulator located in a 1984 toyota truck


Ignition "modulator"??? I assume you mean "ignition module" or "Ignition control module". If this is what you mean, it is mounted on the ignition coil assembly. Toyota refers to this part as "transistorized ignitor".

Jun 13, 2012 | 1984 Toyota Pickup Deluxe

2 Answers

Where is the ignition module located on 2004 honda civic lx


I searched under 'ignition module' on autozone.com and 'no parts for ignition module' turned up.
I looked under DIS or Distributorless Ignition System and found the coils are inserted in the top of the engine and this tells me that it's likely that the ECM or PCM controls the spark on these cars.

Civic
1.7L Engine

  1. Disconnect the negative battery cable.
  2. Remove the ignition coil cover (A), disconnect the ignition coil connectors (B), then remove the ignition coils (C).
  3. Installation of the ignition coils is the reverse of the removal procedure.

    0996b43f8020624a.jpg enlarge_icon.gifenlarge_tooltip.gif

    Fig. Remove the ignition coil cover (A), disconnect the ignition coil connectors (B), then remove the ignition coils (C)

Jan 24, 2011 | Honda Civic Cars & Trucks

3 Answers

I cannot find my ignition module


Your ignition control module is under the coil packs on the motor.

Jan 05, 2011 | 1991 Chevrolet Lumina

2 Answers

Were is the ignition module located at do you have a pic or diagram


Ignition control module is located under the ignition coil packs, follow the spark plug wire''s from engine to coil packs.
If you have a 3.1L engine, the module will have three connector, two one one end and one in the other end.
If you have a 3.8L engine, the module will have one wide connector on one end only.
To remove module, remove all three coil pack's, will have two small screw's to each one,disconnect elec. connector from module and unbolt module.

Aug 11, 2010 | 2000 Pontiac Grand Prix

2 Answers

How to install ignition module on1995 buick


The ignition module is under the coils. It is what the coils plug on to. To replace it removal all the coils and unplug it.

Jul 31, 2010 | 1995 Buick LeSabre

1 Answer

1979 chevy van not getting spark.was running fine day before.turns over fine,getting fuel.could it be the module


First thing is what condition are the distributor cap, ignition rotor, and spark plug wires in?

There is the possibility that the ignition coil located in the top of the distributor cap is faulty and first check to see if full battery voltage is even getting to the "Bat" or "Pos" (+) positive side of the ignition coil when the key is in the "Run" position. Then check the secondary resistance to the ignition coil.

The ignition module and the pick-up coil/stator located inside of the distributor is what generates the signal that the ECM (Engine Control Module) uses to time and fire the fuel injectors, as well as the signal to run the fuel pump and the dwell signal timing to fire the ignition coil. A faulty ignition module can cause any one of these systems to malfunction.

That does sound like a malfunction with the ignition module inside of the distributor, and you can remove the ignition module and have it tested for free at most auto part stores. If the ignition module does test out alright then the problem could still be in the pick-up coil/stator, (it can be tested using an ohm meter by dis-connecting the wire connector from the pick-up coil/stator and the ohm reading between the two wires from the pick-up coil/stator should be between 500 and 1500 ohm's, and both of the wires from the pick-up coil/stator should show an open loop or an infinite reading between each wire and ground) and if the pick-up coil/stator is found to be faulty then replace the entire distributor, or the distributor will have to be dis-assembled to install a new pick-up coil/stator.

If you do purchase a new ignition module be sure that it does come with a silicone grease or a die-electric compound because it is a heat sink and the ignition module will burn up without it.

To install the new ignition module first clean out the mounting surface inside of the distributor. Then completely coat the metal contact surface under the ignition module with a thick coat the silicone grease or die-electric compound and do not leave any of the metal contact surface of the ignition module un-coated with the silicone grease or die-electric compound, and be very careful not to over-tighten the ignition module or it will be damaged.

Let me know if you require any further assistance.


b0c4aa0.jpg

Jul 29, 2010 | 1979 Chevrolet C/K 3500

1 Answer

Ignition turns but wont start it gets fuel but does not fire


The ignition module is generally located on top of the ECU for distributor cars. For distributorless ignition cars, the ignition module is usually inside the coil pack.

Dec 01, 2009 | 2001 Dodge Stratus

3 Answers

Where is the ignition module control located on 1996 ranger 2.3 e


It does not have an ignition control module. The PCM (powertrain control module) fires the coil pack based on signal it recieves from the crankshaft position sensor and the camshaft position sensor.

Apr 08, 2009 | 1996 Ford Ranger SuperCab

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

72 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kia Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

yadayada
yadayada

Level 3 Expert

75797 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8152 Answers

Are you a Kia Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...