Question about 2005 Mitsubishi Endeavor
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: location of the cabin filter
Not sure about that car in specific but most cars have their cabin air filters where the front passengers feet would be. There maybe a plastic cover you need to remove and maybe a screw and the filter should drop down.
Posted on Aug 29, 2008
SRS is not DIY. I strongly suggest you go to a reputable repairer an have it scanned and unless you are very competent Auto Tech leave it to them to repair.The SRS lamp is warning you that the Supplimentry Restraint System has a fault and will NOT funtion if you have an accident. Therfore you don't have this as a backup with your seatbelts .There is a good chance that it is the pressure pad in the passengers seat as has been suggested along with loom and module failures.
Posted on Jun 12, 2009
Did you change the seat belt holder. When airbags are deployed the seat belts automaticly open they still work ok but need changed
Posted on Aug 08, 2009
The water is clear condensate water from the air conditioner evaporator
drain. You'll notice that the water doesn't contain any antifreeze or
odor. Keep in mind that running with the ventilation control selector
in the defrost position also runs the air conditioner. The foam seal
around the drain tube and the fire wall has deteriorated allowing water
that is blown back against the fire wall around the drain tube to enter
the passenger area of the vehicle. You can see the hard plastic drain
tube protruding low on the engine side of the fire wall. It's about an
inch or so long and a little better than a half inch in diameter. The
fix is easy and permanent. Cut a 2.5' patch from some rubber gasket
material, it can be round or square doesn't matter. Cut a round hole in
the center of the patch that is slightly smaller than the tube. Slather
one side of the patch with marine sealant and slide itover the tube
with the sealant side tward the fire wall pressing the patch against
the firewall. Now use a wet dry vac to extract as much of the water
from the passenger foot well as possible an wait about a week or so for
the carpet and padding to dry.
Posted on Feb 25, 2010
Tips for a great answer:
Jan 25, 2017 | 2004 Mitsubishi Endeavor
Aug 23, 2012 | Mitsubishi Cars & Trucks
Jun 19, 2012 | 2005 Mercedes-Benz Mercedes Benz E320 Cdi
Aug 09, 2011 | 2001 Mitsubishi Galant
Oct 18, 2010 | 2005 Mitsubishi Endeavor
Jun 26, 2010 | 2005 Mitsubishi Lancer
405 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: