Question about 1999 Mercury Villager

1 Answer

Need to know where is the Blower Motor Resistor on my 1999 Mercury Grand Marquis

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 7,353 Answers

Under the hood in the evaporator housing.

Posted on Nov 10, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2002 MERCURY GRAN MARQUIS NO LOW AC BLOWER


More often than not, the Blower Motor Resistor would be at fault. It controls the speed of the Blower Motor by varying its speed revolutions. The Blower Motor Resistor is located under the hood under the heater hoses. You can purchase one from E-bay, Amazon, or check your local Auto Parts store(try to get the best price). To get an idea of where the Blower Motor Resistor is situated and what it would take to replace it, go to www.youtube.com. Type ......how to replace blower motor resistor ford crown vic.... and the video will pop up. There should be another video under it with the caption.....2003 ford crown
Victoria blower motor resistor swap... Watch both videos as they contain two different approaches in replacing the unit.

Jun 08, 2014 | 2002 Mercury Grand Marquis

1 Answer

Replace blower motor 1999 mercury grand marquiss


The blower motor is on the passenger side under the dash board. You will need to remove the glove box, the kick panel under the dash and the blower motor should be just above it with 3 - 5 screws holding it in place.

Apr 05, 2012 | 1999 Mercury Grand Marquis

1 Answer

Blower stopped working on my 2001 Mercury Grand marquis


Check the fuse first. If the fuse is good then either the blower motor or the blower motor resistor pack is defective. Check the blower motor by applying 12 volts directly to the motor. If it runs it is good and most likely the resistor pack is bad and needs replacing. it can also be the blower motor speed control but rarely do they go bad.

Jan 02, 2011 | 2000 Mercury Grand Marquis

1 Answer

1999 grand marquis were the blower motor resistor is located


this is for manual heater system. If you have electronic (digital display) you don't have one. Instead you have a blower motor speed controller.

here is info

Control System Outputs—Manual A/C
Blower Motor Switch Resistor
The heater blower motor switch resistor has the following features:
  • The assembly is located in the engine compartment on the evaporator housing toward the center of the vehicle.
  • Three resistor elements are mounted on the resistor board to provide four blower motor speeds.
  • Depending on the heater blower motor switch position, series resistance is added or bypassed in the A/C blower motor circuit to decrease or increase A/C blower motor speed.
  • An overheating protective device (thermal limiter) will open the resistor coil when the temperature reaches 121°C (250°F) interrupting the blower motor operation in all speeds except HI.
  • The thermal limiter cannot be reset and is not serviceable.

Dec 12, 2009 | 1999 Mercury Villager

1 Answer

2000 grand marquis blower fan stops on lower speeds


there is a resistor for the fan motor which works the lower speeds, you need to replace that, it is normally located near the blower motor, got 3-6 wires plugged in it

Jun 28, 2009 | 1993 Mercury Grand Marquis

1 Answer

Blower for heater on a 2000 mercury marquis works some days and doesn't some days,,,why and where do you locate a resistor?


The resistor has two screws holding it onto the plastic case. The same case that houses the blower motor. The blower cools the resistor while its running.

May 12, 2009 | 2000 Mercury Grand Marquis

3 Answers

Location of blower motor switch resistor on 2004 Grand Marquis


The blower speed controller is located under the hood on the right or passenger side on the heater housing just to the side of the heater hoses near the very back of the right cylinder head.
Yes that would cause the concern you are having.

Feb 05, 2009 | 2000 Mercury Grand Marquis

Not finding what you are looking for?
1999 Mercury Villager Logo

65 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

fordexpert

Level 3 Expert

5537 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...