Question about Mitsubishi 3000GT

Open Question

Have dodge stealth twin turbo ran fine then parked it.now speedometer not working and car will not go past 25-2700 rpm .already replaced speedometer sensor and throttle position sensor.car still runs like ****.cant find wiring diagrams ,just had rebuilt engine installed i suspect that i have apinched wire or one that burnt between speedo sensor and speedo head.

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: 1997 dodge ram 1500 stalls when driving

check vacuum hose into throttle body, also clean throttle body orifices and iac. remove iac [engine off] and have someone turn key to on to see if plu8nger works. just a thought .

Posted on Dec 25, 2008

Ad
  • 9 Answers

SOURCE: 1997 dodge dakota v6 engine wont start replaced

turn the key to the on position a see if you can here a buzzing sound around the fuel tank,if you don't hear a sound then. (be very careful while doing this) with the key off take a fuel line coming from the tank loose,make sure its pointed away from you and turn the key to the on position,see if any gas comes out,if not then your fuel pump is probably bad.

Posted on Mar 05, 2009

  • 4 Answers

SOURCE: 944 turbo throttle dropout problem

i gave my 944 turbo which had a idle problem. checked all the vacuum
attatchments, made sure all were connected. Checked coolant level.
Then cleaned the fuel pressure (part). ie the fuel rail attatchment, with carburettor cleaner then sprayed dry lube into it. Its running like a dream again. This part i am talking about has 3 inlets and is at the front of the fuel rail, when you take it out fuel runs out of it for a little while.
Hope this fixes the problem.

Posted on Oct 02, 2009

  • 1 Answer

SOURCE: Where is the throttle position sensor on a

Lightning bolt on dash starts blinking and the freakin truck shuts off on the highway in the center lane. Real nice Dodge. Nice way to kill someone. Any body have aclue what happens to the fbw.

Posted on Oct 15, 2009

  • 1 Answer

SOURCE: speedometer, gas gauge, odometer, rpm gauge not working

My gas guage, speed odometer and tempiture does not work
The speed odometre is reading 9999999 what should i do

Posted on Oct 21, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Dodge stealth twin turbo problems


Hi have you checked al the intake hoses and hoses to and from the turbocharger? And it's also possible that the timing may be off has the timing belt been changed?

Nov 30, 2017 | 1993 Dodge Stealth

1 Answer

I have a 1991 dodge stealthr/t twin turbo it backfires through the intake and exhaust a mechanic at the dealer said it is running lean and doesn't have a good reading on the down steam o2 sensor I


Here is what you need to try. When a car gets a lean signal from an O2 sensor it means there is more air than it should have. The general perception is that there is too little gas.

This means you have a leak in the intake gasket or one of the vacuum lines or vacuum solenoids. You can try spraying a water mist from a handheld spray bottle on the running egine. If the engine stalls or Rpm drops, you have found the leak.

Now I see that this is a Dual Turbo. Sometimes there is valving or "Gates" inside the turbo that regulate airflow. If the gate sticks, or carbons up, it will not shut down the Turbo and you will get too much airflow past the O2 sensor.

Having a backfire through the intake and exhaust indicates something is sticking and an engine valve is carbonned up and failing to close. You need to systematically test the items I have mentioned. The more difficult test would be a compression test to see if the valves are sealing.

Sep 26, 2012 | 1991 Dodge Stealth

2 Answers

1993 Dodge Stealth Twin Turbo and it has faulted a brand new ignition module


need new switch. if key has a chip switch needs to be relaerd to the pcm dy dealer or someone with the software

May 17, 2011 | 1993 Dodge Stealth

2 Answers

MASS AIR FLOW SENSOR? 1991 Dodge Stealth RT


Yeah sound like the Mass Airflow sensor (MAF). This is one of those items you really shouldn't get at a junk yard.

Apr 21, 2010 | 1991 Dodge Stealth

1 Answer

Timing belt alighnment marks for a 1992 stealth rt twin turbo


There are two, whichever is on the head is what determines the mark on the pulley. I think one is a box, and you have 2 lines to line up with and the other is a triangle? and you have one mark to line up with. Hope this helps.

Mar 16, 2010 | 1992 Dodge Stealth

1 Answer

Need new engine


the only more powerful engine is the twin turbo but you could rebuild yours with high performance internals and add a turbo

Aug 24, 2009 | 1992 Dodge Stealth

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

51 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

Marvin
Marvin

Level 3 Expert

83481 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22393 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...