Question about Mercedes-Benz C-Class

Open Question

C270 cdi , loss of power and no kickdown - C-Class Mercedes-Benz Cars & Trucks

Posted by on

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

alicantecoli
  • 22156 Answers

SOURCE: Mercedes Benz C270 cdi 2001.

in the fuse panel top right side is a paper folded up this is the fuse layout diagram

Posted on Jan 22, 2010

  • 1 Answer

SOURCE: c270 cdi service manual required

what is the cost of a b-service

Posted on Sep 19, 2010

merctechniqu
  • 229 Answers

SOURCE: HI GEAR BOX WILL NOT KICK DOWN C270 CDI 02 THANKS

first check is the kick down switch working or not, as a first step, get in to the driver seat, don't switch on or start, press accelerator paddle slowly til end then depress and listen is it make a click sound or not, if not kick down switch could be faulty, this information for you to understand how the kick down switch working, when you drive the car did you depress and check the kick down working or not same as you did now? once again drive car and fully depress accelerator and check if not working you must get it in to the Mercedes workshop for right diagnose possibly faulty kick down switch in accelerator paddle, is this information helped you?

Posted on Oct 20, 2010

ajarema
  • 404 Answers

SOURCE: where is the fuse for

It is located under the rear seat.

Posted on Jan 31, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My Mercedes c270 cdi -02 loses power shortly (as if the turbo closes than wake up again) between the gears mostly between the 1 an 2 gear


U may need an ignitiontuneup..new distcap or coil..plugs or wires. Fuelpump or regulator cud b worn. Dirty aircleaner or throttlbody. Get it scanned or service turbo or trans

Jun 15, 2015 | Cars & Trucks

1 Answer

Mercedes benz c270 cdi registered 2003 i have no


OFTEN IF THE CAR HAS A WEAK OR DEAD BATTERY THE RADIO REQUIRES THE SECURITY CODE TO BE REENTERED

Oct 16, 2013 | 1994 Mercedes-Benz C-Class

1 Answer

I have a c270 cdi 2003 automaticI It starts immediately and have all the power but after a few kilometer it goes in limb mode if i switch it off the problem stops but then the whole cycle starts again.It...


I had the same problem on a 2002 c270 cdi. Turned out to be a leakink vacuum hose. The brakes also makes use of the same vacuum pump as well as the turbo boost actuator.
After refitting and Tightning with Cabell tie my problem was solved.
Full boost full power.

Feb 14, 2013 | Cars & Trucks

1 Answer

Telephone keypad


you neeed bluetooth on both radio and phone

Sep 27, 2012 | 2004 Mercedes-Benz C270 CDI

1 Answer

C270 cdi service manual required


what is the cost of a b-service

Jun 26, 2010 | 2002 Mercedes-Benz C-Class

2 Answers

Mercedes Benz C270 cdi 2001. What is the fuse number for the driver's seat recliner please.


in the fuse panel top right side is a paper folded up this is the fuse layout diagram

Jan 22, 2010 | 2001 Mercedes-Benz C-Class

4 Answers

2003 mercedes C270 CDi auto gearbox fault


mercedes c220 cdi 2004 140k done gets stuck in gear then have to turn of ignition to get it working again. had recently had the gearbox serviced

May 08, 2009 | 2001 Mercedes-Benz C-Class

2 Answers

Loss of power


I have the same problem on a s320 cdi, gearbox goes into limp mode and wont rev above or kickdown, at the 1st chance i get to stop i put into park or neutral gear turn off the engine and re-start and then everthing is fine, I read that if you put a new battery on it may solve the problem, it's something to do with the voltage dropping below 10.4 volts. Then it sends a message to e.c.u. that puts your gearbox into limp mode. Hope this will work for you. MERKY

Apr 25, 2009 | 2005 Mercedes-Benz Mercedes Benz E320 Cdi

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

265 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercedes-Benz Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

yadayada
yadayada

Level 3 Expert

75822 Answers

Michael Contreras
Michael Contreras

Level 2 Expert

166 Answers

Are you a Mercedes-Benz Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...