The rear blinkers and tailights aren't working I think it is just a fuse but we don't have a owners manual, what is the diagram for the fuse box, all it has is number references and says refere to owners manual.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
The tail lights are also called parking lights. There is a 10amp fuse for each rear parking lamp. The fuses are in the rear fuse box. Your owner's manual will tell you where that fuse box is located. The fuses get power from a park lamp relay.
no, sorry . but i do have a suggestion that might help. do the taillights work? if so check the brake light switch on the brake pedal. also , does the high mount light work and not the rear ones? if so you may want to check the turn signal switch to make sure there is voltage on that circuit.
if there is no fuse diagram on the fuse box cover you are gonna have to take them out 1 by 1 and check them, make sure the small pieceof wire in the fuse is not broken or burnt, a pair of cosmetic tweezers works great for pullin these little boogers out, probably a 20 amp fuse, good luck!!
No Turn Signal Operation (blinker)The turn signal lights in your car are a basic electrical system that controls the front and rear blinker lights to alert the intended direction of the vehicle. We have listed some of the most common problems and repair troubleshooting tips below: Troubleshooting Procedure To start troubleshooting this problem:
Turn the key to the on position (do not start engine)
Inspect the system fuse located in the fuse panel and replace if needed. If you cannot find the location of the blinker fuse consult your owner's manual or an online repair manual
When a blinker flasher fails it can cause blinker lights to say on, not blink, or not go on at all. To test the blinker system flasher, remove the flasher unit and insert a jumper wire between the two terminals. If blinker stays on in both directions without blinking, replace the flasher. If you cannot find the location of the blinker flasher consult your owners manual or an online repair manual.