Question about 1996 Chevrolet Suburban

1 Answer

Where do wires attach on starter 96 chevy suburban 1500 5.7 engine

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 11,896 Answers

Ignition wire to solenoid. Battery to solenoid. Then one wire from solenoid to starter.

Posted on Nov 10, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2005 chevy suburban 5.3 engine hesitation


http://engine-codes.com/p1125_chevrolet.html
According to that website above, its your Accelerator Position Pedal Sensor. If you have already replaced it check your wiring harness.
Here is a website that for your wiring diagram for your 2005 Chevy Suburban.

Nov 26, 2013 | 2005 Chevrolet Suburban 1500

1 Answer

I have a 96 chevy suburban 1500 that only started if i sprayed starter fluid in it but now it stop working ,whats wrong


you need to install a fuel pressure gauge on the system and see what the fuel pressure is doing

Jul 09, 2012 | Cars & Trucks

1 Answer

I have a 1996 Chevy Suburban 1500. No crank or any noise or sound when trying to start. Battery is good, even tried jumping to make sure. Could this be the starter? If so, where is it located?


The starter is next to the side of the lower engine block where the engine and trans meet(I believe on the passenger side on GM V8s)You should get 12 volts on the small(purple?) wire of the solenoid when the key is turned to "start".If you don't get 12 volts when the key is turned,it could be the switch on the shifter(usually referred to as the PRNDL switch)IF you get 12 volts at the solenoid when you turn the key,replace the starter(my Chevy work truck has gone through 6 starters(ONE A YEAR)since I've had it!)

Jan 07, 2012 | 1996 Chevrolet Suburban

1 Answer

86 Chevy Suburban not starting.


Is the starter actually turning the engine over (engaging), or is it just whirring rapidly? If it is not engaging, then the vehicle certainly will not start. If it is not engaging, there is most likely a shimming issue to be addressed to get the starter to engage. If it is engaging, check carefully the large nut in the starter solenoid. There are usually more than one wire attached to this nut. Ensure that you have not missed replacing any of the wires that came off the starter studs. Some feed back to the fuse paqnel and can be critical for operation.

Dec 30, 2011 | Ford Ranger Cars & Trucks

2 Answers

Does the 1995 Chevy Suburban have a solenoid and where is it located. thankyou


Yes it does, it is the small round canister bolted to the top of the starter. The starter is bolted to the bottom rear of the engine on the passenger side.

Dec 03, 2010 | 1995 Chevrolet Suburban

1 Answer

Where is the starter located on a 2002 Chevy Suburban? How do I replace it?


    Removing the Starter
  1. Step 1 Open the hood to access the engine compartment. Disconnect the battery by unscrewing the positive and negative terminals. This will prevent the risk of electrical shock.
  2. Step 2 Crawl under the passenger side of the truck and locate the starter. The starter is positioned between the transmission and the engine.
  3. Step 3 Unbolt the negative and positive wires from the starter with a socket wrench. Take the nut off the stud and pull the wires off the stud. Repeat the same for the positive wire.
  4. Step 4 Unscrew the two bolts holding the starter to the frame. Wiggle the starter to work it free from the flywheel.
    Installing the Starter
  5. Step 1 Position the new starter onto the frame. Tighten the bolts to secure the starter in place.
  6. Step 2 Unscrew the nut on the positive stud and push the positive wire down on the stud. Tighten the nut on the stud to secure the positive wires.
  7. Step 3 Unscrew the nut on the negative stud. Push the negative wire on the stud and tighten the nut to the stud to secure the wire.
  8. Step 4 Connect the battery cables to the terminals. Ensure the positive wire connects to the positive terminal. Ensure the negative wire connects to the negative terminal.
  9. Step 5 Start the truck to ensure the starter is functioning correctly. The starter should catch as soon as you turn the key and start the truck.

May 23, 2010 | 2003 Chevrolet Suburban 1500

1 Answer

96 chevy 1500 suburban wont start


check the catalytic converter i had the same problem with my suburban and mine was a clogged converter.

Jan 19, 2009 | 1996 GMC Suburban

2 Answers

Electronic problem in 1996 Chevy Suburban 1500


srgy,
Have 96 burb and had similar issue. Mine was finicky about starting sometimes and thought it was the neutral safety switch. Turns out, it was the starter solenoid. Not positive yours is same issue, but it is worth checking. 

Jul 19, 2008 | 1996 Chevrolet Suburban

Not finding what you are looking for?
1996 Chevrolet Suburban Logo

182 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...